Search

Measuring the time variation of the wavenumber spectrum of turbulence is important for understanding the characteristics of high-temperature plasmas, and the application of a Doppler reflectometer with simultaneous multi-frequency sources is expected. To implement this diagnostic in future fusion devices, the use of a phased array antenna (PAA) that can scan microwave beams without moving antennas is recommended. Since the frequency-scanning waveguide leaky-wave antenna-type PAA has a complex structure, we have investigated its characteristics by modeling it with 3D metal powder additive manufacturing (AM). First, a single waveguide is fabricated to understand the characteristics of 3D AM techniques, and it is clear that there are differences in performance depending on the direction of manufacture and surface treatment. Then, a PAA is made, and it is confirmed that the beam can be emitted in any direction by frequency scanning. The plasma flow velocity can be measured by applying the 3D manufacturing PAA to plasma measurement.

A heavy ion beam probe (HIBP) has been designed for the QUEST spherical tokamak to measure plasma turbulence and the profiles of electric potential profiles. Using a cesium ion beam with an energy of several 10 keV, the observable region covers most of the upper half of the plasma. Although the probe beam is deflected by the poloidal magnetic field produced by plasma current and poloidal coil currents, it can be detected under plasma current up to 150 kA by modifying the trajectories with two electrostatic sweepers. According to the numerical estimation of the intensity of the detected beam, sufficient signal intensity for measuring plasma turbulence can be obtained over almost the measurable area when the electron density is up to 1 × 1019 m−3, which is larger than the cut-off density of electron cyclotron heating in QUEST. The performance of the designed HIBP is sufficient to explore the mechanisms of heat and particle transport in magnetically confined plasmas, including the influence of plasma wall interactions, which is a goal of the QUEST project.

Electron cyclotron emission (ECE) imaging diagnostics incorporating a lensless approach have been developed for measurements involving active spatial selectivity and direction-of-arrival estimation. The Capon method for adaptive-array analysis was proposed to improve the spatial resolution of the two-dimensional ECE imaging technique. Broadband noise source emissions were used to simulate the ECE to verify the practical effectiveness of the Capon method in the ECE imaging. Multiple noise source emission positions were properly estimated with a high spatial resolution using the Capon method.

The experimentally optimized magnetic field configuration of the Large Helical Device [A. Iiyoshi et al., Nucl. Fusion 39, 1245 (1999)], where the magnetic axis is shifted inward by 15 cm from the early theoretical prediction, reveals 50% better global energy confinement than the prediction of the scaling law. This configuration has been investigated further from the viewpoints of high energy particle confinement and magnetohydrodynamic (MHD) stability. The confinement of high energy ions is improved as expected. The minority heating of ion cyclotron range of frequency was successful and the heating efficiency was improved by the inward shift. The confinement of passing particles by neutral beam injection was also improved under low magnetic field strength, and there could be obtained an almost steady high beta discharge up to 3% in volume average. This was a surprising result because the observed pressure gradient exceeded the Mercier unstable limit. The observed MHD activities became as high as beta but they did not grow enough to deteriorate the confinement of high energy ions or the performance of the bulk plasma, which was still 50% better than the scaling. According to these favorable results, better performance would be expected by increasing the heating power because the neoclassical transport can also be improved there.