Search

This study investigates the effectiveness of microwave treatment (MW) on the antifungal properties of Norway spruce wood and the leaching of preservatives. Given the environmental and health concerns about conventional wood preservatives, this study evaluates microwave treatment as a sustainable pretreatment to limit the leaching of preservatives from wood. In the experiment, wood samples were treated with microwaves at five different energy levels before being impregnated with copper–ethanolamine- and boron-based preservatives. We assessed preservative retention by leaching tests and assessed the resistance of the wood to fungal attack. The results show that MW treatment improves the uptake and fixation of preservatives, reduces leachability, and significantly improves the durability of an otherwise perishable wood against fungal attack. This study emphasises the potential of microwave treatment for wood preservation. It offers an environmentally friendly approach to extending the life of wood products while maintaining their protective properties against decay. [ABSTRACT FROM AUTHOR]

The demand for construction timber is continuously increasing, due to its favourable characteristics. However, the adequate protection of wood is key to its successful use, as it is flammable and susceptible to biodegradation. Given that thermal modification enhances the durability of wood, and mineralisation with CaCO3 considerably improves its fire properties, it is worth considering the combined effects of the two methods. European beech (Fagus sylvatica) was selected to determine the effects of a) thermal modification, b) mineralisation through the in-situ formation of CaCO3, and c) a combination of the two procedures, on resistance to decay fungi, reaction to fire and the mechanical properties of the wood. Microscopic analysis and comparisons of the samples before and after exposure to fungi were also conducted. Mineralised wood generally had a slightly alkaline pH value and higher equilibrium moisture content, while thermal modification lowered the equilibrium moisture content. The present study demonstrated the combined effect of thermal modification and mineralisation: the best response to fire as well as resistance to fungi was achieved when the two treatments were combined. Results from the Brinell hardness and three-point bending tests indicate that both modification procedures can slightly impair the mechanical properties of the wood. [ABSTRACT FROM AUTHOR]

Copyright of Acta Silvae et Ligni is the property of Biotechnical Faculty, Slovenian Forestry Institute and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.)

When wood is thermally modified, several chemical reactions take place that change the chemical and physical properties of the wood. These changes correlate with the degree of modification, which is mostly a function of the temperature and duration of modification, and consequently with the mass loss during this process. There is a lack of standardised quality control to verify the degree of heat treatment of wood and thus its quality. One of the possible methods to check the degree of thermal modification of a particular type of wood is thermogravimetry (TG). It is based on the assumption that processes that did not take place during thermal modification continue when the TG experiment is carried out. In this method, calibration curves have to be established based on TG measurements of standard samples that have been thermally modified at different temperatures and whose mass loss during modification is known. The calibration curves show the mass loss during the TG measurement as a function of the mass loss during the previous thermal modification. The course of thermal decomposition during the TG measurements is influenced by many parameters, such as the mass of the sample, the heating rate, the atmosphere in which the measurement takes place, and the shape of the crucible in which the sample is placed. In this paper, the influence of these parameters on the calibration curves was investigated. We have focused on oak wood. The best parameters result in a calibration curve with the largest correlation coefficient R2 and the highest slope of the line k. On this basis, we can determine the mass loss during the thermal modification of unknown samples of the same wood species under the same measurement conditions. [ABSTRACT FROM AUTHOR]