Search

Rubber blends based on styrene–butadiene rubber, ethylene–propylene–diene monomer rubber and a combination of both rubbers were cured with different sulfur and peroxide curing systems. In sulfur curing systems, two type of accelerators, namely tetramethylthiuram disulfide, N-cyclohexyl-2-benzothiazole sulfenamide, and combinations of both accelerators were used. In peroxide curing systems, dicumyl peroxide, and a combination of dicumyl peroxide with zinc diacrylate or zinc dimethacrylate, respectively, were applied. The work was aimed at investigating the effect of curing systems composition as well as the type of rubber or rubber combinations on the curing process, cross-link density and physical–mechanical properties of vulcanizates. The dynamic mechanical properties of the selected vulcanizates were examined too. The results revealed a correlation between the cross-link density and physical–mechanical properties. Similarly, there was a certain correlation between the cross-linking degree and glass transition temperature. The tensile strength of vulcanizates based on rubber combinations was higher when compared to that based on pure rubbers, which points out the fact that in rubber combinations, not only are the features of both elastomers combined, but improvement in the tensile characteristics can also be achieved. When compared to vulcanizates cured with dicumyl peroxide, materials cured with a sulfur system exhibited higher tensile strength. With the application of co-agents in peroxide vulcanization, the tensile strength overcame the tensile behavior of sulfur-cured vulcanizates. [ABSTRACT FROM AUTHOR]

Manganese‐zinc ferrite, nickel‐zinc ferrite, and the combinations of both ferrites in constant level 200 phr were incorporated into acrylonitrile‐butadiene rubber. The amount of carbon black was constant in each composite −25 phr. The second series of composites was fabricated with similar composition, but the total content of ferrites or ferrites combinations was 300 phr, while the content of carbon black was 25 phr. The work was focused on investigation of electromagnetic absorption shielding effectiveness of composites and their physical‐mechanical properties. During the study, good correlation between conductivity, permittivity, and electromagnetic absorption parameters was established. Higher conductivity was reflected in higher permittivity of composites, which subsequently resulted in their lower absorption shielding performance. The experimental outputs revealed that absorption shielding effectiveness was enhanced with increasing with proportion of nickel‐zinc ferrite, which pointed out to higher absorption shielding potential of nickel‐zinc ferrite. The physical‐mechanical properties were found not to be influenced by the type of ferrite or ferrites combinations. The higher overall content of ferrites in rubber matrix caused the decrease in tensile characteristics of composites, suggesting that ferrites are inactive fillers considering the physical‐mechanical properties. [ABSTRACT FROM AUTHOR]