Search

Transformation of methyl lactate to acrylic acid was investigated over Ca3(PO4)2, Ca2(P2O7) and their mixture in the temperature range of 250-425 °C. The initial concentration of methyl lactate in water was varied from 2 wt% to neat methyl lactate. The results showed that these phosphate catalysts did not contain any measurable amounts of either acid sites or basic sites. The best catalyst was Ca3(PO4)2 giving 62% selectivity to acrylic acid at 75% conversion at 400 °C using GHSV of 95280 h−1 and 2 wt% methyl lactate in the initial feed. This catalyst exhibited larger surface area in comparison to Ca2(P2O7). Elemental analysis revealed that some Ca leaching occurred during reaction, while in case of Ca2(P2O7) the calcium leaching was 3.4 fold higher than observed for Ca3(PO4)2. Long-term results over Ca3(PO4)2 showed that extensive catalyst deactivation occurred during the first 11 h time-on-stream, after which the activity dropped only slightly. In addition to kinetic studies with different parameters, also, kinetic modeling was performed and the activation energies for formation of different products were determined over different catalysts. [ABSTRACT FROM AUTHOR]

Titanium silicates of MWW structures with different Si/Ti ratios were prepared via hydrothermal synthesis using piperidine as the structure directing agent and boric acid as the crystallization agent. All the syntheses resulted in highly crystalline materials independent of the Si/Ti ratio. The observed morphology showed MWW-like well-defined thin hexagonal platelets. The synthesized Ti-MWW materials exhibited higher surface areas and partial meso-porosity compared to the commercial TS-1 catalyst. The coordination of the Ti-species was investigated by UV–vis- and IR-spectroscopy. The MWW titanium silicates were tested for the catalytic performance in the epoxidation of propylene in a laboratory-scale trickle bed reactor to compare their clear different physico-chemical properties with the commercial TS-1. The synthesized Ti-MWW materials showed significantly higher catalytic activities, up to 3.5 times, using acetonitrile as the solvent and enhanced epoxide selectivities partially up to 100% in methanol unlike TS-1. The effect of the Ti content in the MWW and the calcination conditions were investigated in propylene epoxidation, revealing the beneficial effect of a lower calcination temperature and an increased Ti content on the activity. The catalytic results were correlated with the physico-chemical properties of the synthesized materials. [ABSTRACT FROM AUTHOR]

Xylose is nowadays converted into xylitol, a popular special chemical sweetener. Xylitol can be used not only in the pharmaceutical and food industries, but also in cosmetics and synthetic resins because of its countless properties. Conventionally, xylitol is produced by slurry reactors operating in batch with dispersed or supported catalysts. Hydrogen is continuously fed to maintain a constant pressure. In this work, the kinetics of the reaction were investigated to find the optimal operating conditions to minimize the by-products obtained. Given the great performances shown by the new Ru/SiO2 sol–gel derived catalyst in glucose hydrogenation, in this work the mentioned catalyst was tested in the hydrogenation of xylose to xylitol both in batch and in continuous production to prove its stability and activity. [ABSTRACT FROM AUTHOR]