Search

The tight oil/gas reservoirs in China have showed the great exploration prospects and high production potential, with the characteristics of low porosity, low permeability, and significant heterogeneity in formation rocks. It remains a challenge to sort out the relations between reservoir wave responses and rock physical properties, and the further studies on the wave response patterns of tight reservoirs are in an urgent demand. The shear modulus and S- (shear) wave attenuation of rocks are affected by the properties of pore fluid and confining pressure. The ultrasonic wave experiments are performed on eight partially-saturated tight sandstone samples at different confining pressures, and we estimate S-wave attenuation with the spectral-ratio method. Results show that S-wave attenuation decreases with increasing confining pressure, and the water saturation case shows more loss compared to the oil saturation case, while the gas saturation case gives the lowest attenuation. We observe the S-wave relaxation peak at an intermediate water saturation for the gas-water partial-saturation case in general. S-wave attenuation increases with increasing porosity or permeability. Based on the measured rock physical properties, and combined with the Voigt–Reuss–Hill (VRH) average, differential effective medium (DEM) model and squirt-flow model, a tight rock attenuation model is proposed for analyzing the attenuation characteristics of fluid-saturated rocks at different confining pressures. The model reasonably describes the S-wave attenuation characteristics. The model predictions of S-wave attenuation show apparent pressure- and fluid-sensitivity at full saturation and partial saturation conditions. For sample TS1-19 at full saturation with different confining pressures, the S-wave peak attenuation predicted by the model ranges from 11.6 to 69.5, and decreases with confining pressure, while the relaxation frequency shifts to high frequency end. For the partial saturation condition of the sample, the predicted S-wave peak attenuation ranges from 15.5 to 39.8 at a confining pressure of 30 MPa and increases with water saturation, while the relaxation frequency shifts to low frequency end. For all the samples at 30MPa confining pressure, the predicted S-wave attenuation ranges from 5.6 to 38.6. At the full-saturation case, the predicted S-wave attenuation increases with porosity and decreases with confining pressure. For the partial saturation case, the S-wave attenuation predicted with the model and the Voigt and Reuss bounds generally increases with water saturation, whereas the experimentally-measured attenuation exhibits the peak attenuation at an intermediate saturation. [ABSTRACT FROM AUTHOR]

Tight sandstone reservoirs basically have low porosity and permeability, a complex pore structure and a heterogeneous distribution of immiscible fluids. With the development of theoretical models, it is common to characterize rock properties, i.e., pore structure, microfractures, fluid type and saturation, etc., based on acoustic and electrical properties. We have taken four tight sandstone samples and performed X-ray diffraction and cast thin section analyses. We measure porosity and permeability as well as ultrasonic properties and electrical conductivity at different confining pressures and fluid saturations. These measurements show that the P-wave velocity, P-wave attenuation and conductivity strongly depend on the type and saturation of the fluid and the microstructure of the rock. We propose a combined acoustic-electrical model based on the concept of equivalent medium and on the double porosity, patchy saturation and squirt flow models. We then create rock physics templates calibrated with wellbore log data to estimate fluid saturation and equant and soft porosities, which are well corroborated by gas production reports. This work demonstrates the link between combined acoustic-electrical responses and rock properties and provides an effective approach for applications in reservoirs. [ABSTRACT FROM AUTHOR]