Search

Fiber-reinforced polymer composites are manufactured using various methods, with vacuum-assisted resin transfer molding (VARTM or VARIM). This study's primary focus lies in assessing how the orientation of sampling impacts the mechanical properties of glass fiber-reinforced pure and nanocomposites. 2 wt.% nano Al2O3- doped and non-doped composites were produced using the VARTM process. Tensile, flexural, and density test specimens were extracted from three distinct zones and two distinc direction those aligned horizontally to the resin flow (HRF) and those oriented vertically to the resin flow (VRF). Remarkably, results showed up to a 3.91% increase in values from samples in the third zone, particularly on the vacuum outlet side. To facilitate precise stress value comparisons across plates, uniform sample orientation and consistent zone selection are essential. [ABSTRACT FROM AUTHOR]

Composite materials made up of polymer matrix reinforced with synthetic fibers have gained popularity of late owing to their enhanced mechanical properties. However, very little work is reported to date on metals being used as filler material. Research gaps were obtained pertaining to the use of metallic fillers in synthetic fiber reinforced polymer composites. This paper demonstrates an attempt to fabricate composites made of Epoxy polymer matrix and E-glass fiber reinforcement with Mild Steel in its powdered form as fillers. Composites are prepared in varying weight percentages of the filler in the order of 2 wt. %, 4 wt. % and 6 wt. %. Hand layup method is employed for fabricating these composites which are later subjected to compression. Further, the samples are machined according to ASTM D3039 standard for tensile test and ASTM D256 standard for Izod impact test. Hardness test is also performed using a Shore D Durometer and these properties are compared with the unfilled samples. The results indicated that the weight percentage of the filler clearly influenced the mechanical properties of the developed composites. This study also revealed that the hardness and tensile strength of these composites improved with the incorporation of fillers up to 2 wt. % whereas, the impact strength improved up to 4 wt. %. Thereafter, there was a decline in their impact and tensile properties. However, hardness marginally increased beyond 4 wt. %. This area is open for research with regard to their usability under tribological, high temperature or magnetic conditions. [ABSTRACT FROM AUTHOR]