Search

The accumulation of platelets near the blood vessel wall or artificial surface is an important factor in the cascade of events responsible for coagulation and/or thrombosis. In small blood vessels and flow channels this phenomenon has been attributed to the blood phase separation that creates a red blood cell (RBC)-poor layer near the wall. We hypothesized that blood soluble drag-reducing polymers (DRP), which were previously shown to lessen the near-wall RBC depletion layer in small channels, may consequently reduce the near-wall platelet excess. This study investigated the effects of DRP on the lateral distribution of platelet-sized fluorescent particles (diam. = 2 μm, 2.5 × 10⁸/ml) in a glass square microchannel (width and depth = 100 μm). RBC suspensions in PBS were mixed with particles and driven through the microchannel at flow rates of 6-18 ml/h with and without added DRP (10 ppm of PEO, MW = 4500 kDa). Microscopic flow visualization revealed an elevated concentration of particles in the near-wall region for the control samples at all tested flow rates (between 2.4 ± 0.8 times at 6 ml/h and 3.3 ± 0.3 times at 18 ml/h). The addition of a minute concentration of DRP virtually eliminated the near-wall particle excess, effectively resulting in their even distribution across the channel, suggesting a potentially significant role of DRP in managing and mitigating thrombosis.

This paper reports a novel, physiologically significant, microfluidic phenomenon generated by nanomolar concentrations of drag-reducing polymers (DRP) dissolved in flowing blood, which may explain previously demonstrated beneficial effects of DRP on tissue perfusion. In microfluidic systems used in this study, DRP additives were found to significantly modify traffic of red blood cells (RBC) into microchannel branches as well as reduce the near-wall cell-free layer, which normally is found in microvessels with a diameter smaller than 0.3 mm. The reduction in plasma layer size led to attenuation of the so-called "plasma skimming" effect at microchannel bifurcations, increasing the number of RBC entering branches. In vivo, these changes in RBC traffic may facilitate gas transport by increasing the near vessel wall concentration of RBC and capillary hematocrit. In addition, an increase in near-wall viscosity due to the redirection of RBC in this region may potentially decrease vascular resistance as a result of increased wall shear stress, which promotes endothelium mediated vasodilation. These microcirculatory phenomena can explain the previously reported beneficial effects of DRP on hemodynamics in vivo observed in many animal studies. We also report here our finding that DRP additives reduce flow separations at microchannel expansions, deflecting RBC closer to the wall and eliminating the plasma recirculation zone. Although the exact mechanism of the DRP effects on RBC traffic in microchannels is yet to be elucidated, these findings may further DRP progress toward clinical use.

Background: I.V. infusion of drag-reducing polymers (DRPs) has been shown to improve survival time in animals subjected to haemorrhagic shock. We hypothesized that DRPs might prolong survival time in rats following acute myocardial ischaemia (AMI)., Methods: Sixteen adult male rats were anaesthetized and mechanically ventilated. An i.v. infusion of either Dextran-40 2.5% (Control, n=8) or Dextran-40 2.5% containing 50 microg ml(-1) of an aloe vera-based DRP (DRP, n=8) was initiated at 3.5 ml h(-1). The left anterior descending coronary artery was ligated. Blood pressure, skin-tissue perfusion, and heart rate were monitored and arterial blood samples were analysed., Results: The mortality at 60 min following coronary ligation was 0% in the DRP group vs 50% in the control group (P=0.025). DRP-treated animals maintained higher mean arterial pressure [60.9 (5.1) vs 47.5 (5.1) mm Hg, P=0.004] and tissue perfusion [4.2 (3.4) vs 1.2 (0.5) TPU, P=0.029]. The DRP group trended towards better acid-base status with base excess [-5.0 (1.7) vs -8.1 (5.1) mmol litre(-1), P=0.083] and pH [7.42 (0.07) vs 7.35 (0.02), P=0.03]., Conclusions: Administration of nanomolar concentrations of aloe vera-based DRP prolonged survival time in animals with AMI. DRPs may offer a novel method to treat organ/tissue hypoperfusion.

We tried to verify the hypothesis that increases in pump flow during diastole are matched by decreases in left ventricular (LV) output during systole. A calf (80 kg) was implanted with an implantable centrifugal blood pump (EVAHEART, SunMedical Technology Research Corp., Nagano, Japan) with left ventricle to aorta (LV-Ao) bypass, and parameters were recorded at different pump speeds under general anesthesia. Pump inflow and outflow pressure, arterial pressure, systemic and pulmonary blood flow, and electrocardiogram (ECG) were recorded on the computer every 5 ms. All parameters were separated into systolic and diastolic components and analyzed. The pulmonary flow was the same as the systemic flow during the study (p > 0.1). Systemic flow consisted of pump flow and LV output through the aortic valve. The ratio of systolic pump flow to pulmonary flow (51.3%) did not change significantly at variable pump speeds (p > 0.1). The other portions of the systemic flow were shared by the left ventricular output and the pump flow during diastole. When pump flow increased during diastole, there was a corresponding decrease in the LV output (Y = -1.068X + 51.462; R(insert)(2) = 0.9501). These show that pump diastolic flow may regulate expansion of the left ventricle in diastole.

The purpose of this study was to evaluate the real time relationship between pump flow and pump differential pressure (D-P) during experimentally induced hypertension (HT). Two calves (80 and 68 kg) were implanted with the EVA-HEART centrifugal blood pump (SunMedical Technology Research Corp., Nagano, Japan) under general anesthesia. Blood pressure (BP) in diastole was increased to 100 mm Hg by norepinephrine to simulate HT. Pump flow, D-P, ECG, and BP were measured at pump speeds of 1,800, 2,100, and 2,300 rpm. All data were separated into systole and diastole, and pump flow during HT was compared with normotensive (NT) conditions at respective pump speeds. Diastolic BP was increased to 99.3+/-4.1 mm Hg from 66.5+/-4.4 mm Hg (p<0.01). D-P in systole was under 40 mm Hg (range of change was 10 to 40 mm Hg) even during HT. During NT, the average systolic pump flow volume was 60% of the total pump flow. However, during HT, the average systolic pump flow was 100% of total pump flow volume, although the pump flow volume in systole during HT decreased (33.1+/-5.7 vs. 25.9+/-4.0 ml/systole, p<0.01). In diastole, the average flow volume through the pump was 19.6+/-6.9 ml/diastole during NT and -2.2+/-11.1 ml/diastole during HT (p<0.01). The change in pump flow volume due to HT, in diastole, was greater than the change in pump flow in systole at each pump speed (p<0.001). This study suggests that the decrease of mean pump flow during HT is mainly due to the decrease of the diastolic pump flow and, to a much lesser degree, systolic pump flow.

This study showed the usefulness of maintaining positive pump flow to avoid endocardial suction and as an assist bypass. Three calves were implanted with centrifugal pumps. Hemodynamics and pump parameters were measured at varying pump speeds (from 1,100 to 2,300 rpm). In each test pump, speed was adjusted to create 3 hemodynamic states: both positive and negative flow (PNF), positive and zero flow (PZF), and continuously positive flow (CPF). The pump flow volume was determined during systole (Vs) and diastole (Vd). Vs in PNF was 29.6 ml and was not significantly different from Vs in PZF (p > 0.15). Vd in PNF was significantly different from Vd in PZF (p < 0.05). All bypass rates of PNF were over 30% of pulmonary flow. All PZF bypass rates were between the PNF rate and the CPF rate. These data showed that PZF satisfied the minimum requirement of assist flow and was under 100% bypass. Thus, PZF may avoid endocardial suction.

The degree of platelet adhesion and subsequent thrombus formation is an important measure of biocompatibility for cardiovascular biomaterials. Traditional methods of quantifying platelet adhesion often are limited by the need for direct optical access, limited spatial resolution, or the lack of temporal resolution. We have developed a new imaging system that utilizes fiber optics and fluorescence microscopy for the quantification of platelet adhesion. This fiber optic remote microscope is capable of imaging individual fluorescently labeled platelets in whole blood on opaque surfaces. Using this method, platelet adhesion was quantified on a series of metallic [low-temperature isotropic carbon (LTIC); titanium alloy (Ti); diamond-like carbon (DLC); oxidized titanium alloy (TiO); and polycrystalline diamond (PCD)] and polymeric [woven Dacron (WD)] collagen-impregnated Dacron (HEM), expanded polytetrafluoroethylene (ePTFE), and denucleated ePTFE (dePTFE)] biomaterials designed for use in cardiovascular applications. These materials were perfused with heparinized whole human blood in an in vitro parallel plate flow chamber. Platelet adhesion after 5 min of perfusion ranged from 3.7 +/- 1.0 (dePTFE) to 16.8 +/- 1.5 (WD) platelets/1000 micrometer. The temporal information revealed by these studies provides a comparative measure of the acute thrombogenicity of these materials as well as some insight into their long-term hemocompatibilities. Also studied here were the effects of wall shear rate and axial position on platelet adhesion. A predicted increase in platelet adhesion with increased wall shear rate and a trend toward a decrease in platelet adhesion with increased axial distance was observed with the fiber optic microscope. Future applications for this imaging technique may include the long-term evaluation of thrombosis in blood-contacting devices in vitro and, in animal models, in vivo., (Copyright 2000 John Wiley & Sons, Inc.)

Many types of rotary blood pumps and pump control methods have recently been developed with the goal of clinical use. From experiments, we know that pump flow spontaneously increases during exercise without changing pump control parameters. The purpose of this study was to determine the hemodynamics associated with the long-term observation of calves implanted with centrifugal blood pumps (EVAHEART, Sun Medical Technology Research Corporation, Nagano, Japan). Two healthy female Jersey calves were implanted with devices in the left thoracic cavity. A total of 22 treadmill exercise tests were performed after the 50th postoperative day. During exercise, the following parameters were compared with conditions at rest: heart rate, blood pressure, central venous oxygen saturation (SvO2), pump speed, and pump flow. The pump flow in a cardiac cycle was analyzed by separating the systole and diastole. Compared to the base data, statistically significant differences were found in the following interrelated parameters: the heart rate (66.8 +/- 5.2 vs. 106 +/- 9.7 bpm), mean pump flow (4.8 +/- 0.2 vs. 7.0 +/- 0.3 L/min), and volume of pump flow in diastole (26.0 +/- 1.8 vs. 13.5 +/- 2.5 ml). During exercise, the volume of pump flow in systole was 3 times larger than that measured in diastole. Blood pressure, SvO2, and pump speed did not change significantly from rest to exercise. These results suggested that the mean pump flow depends on the systolic pump flow. Therefore, the increase in the mean pump flow during exercise under constant pump speed was caused by an increase in the heart rate.