Search

An 11 m high dry-stacked masonry concrete block wall reinforced with a high-density polyethylene (HDPE) geogrid was designed, instrumented, and monitored for a period of 2 years as part of a highway-widening project southeast of Seattle, Washington, in the USA. An extensive materials-testing program was conducted to characterize the geogrid and backfill soil properties. The empirical-based K-stiffness method was used to design the wall, and this approach resulted in a 35% reduction in total required reinforcement strength compared with the American Association of State Highway and Transportation Officials / Federal Highway Administration (AASHTO/FHWA) simplified method. The cost savings more than compensated for the cost of the instrumentation program. Geogrid strains were measured using strain gauges and extensometers, and the walls were surveyed to monitor facing deformations. The stiffness of the geogrid materials was computed from the results of laboratory in-isolation constant-load (creep) tests. The time- and strain-dependent stiffness values, in combination with measured strains, were used to compute measured reinforcement loads at the reinforcement connections and at locations within the reinforced soil backfill. The measured loads were compared with class A, B, and C1 predictions using the AASHTO/FHWA simplified and K-stiffness methods. These comparisons demonstrate that the simplified method significantly overestimated reinforcement loads, whereas the K-stiffness method provided estimates that were judged to be in better agreement with the measured results. The paper also quantifies the influence of construction procedures on reinforcement strains and load, shows that long-term creep of the reinforcement after 2 years after construction is negligible, and identifies lessons learned. [ABSTRACT FROM AUTHOR]

The paper presents the numerical modelling details using the finite difference method (FDM) to simulate the performance of a well-instrumented geogrid-reinforced incremental concrete panel soil retaining wall. Two different constitutive models were investigated for the backfill soil (linear elastic-plastic model and nonlinear elastic-plastic model). Both constant stiffness and strain-dependent secant stiffness models were used for the reinforcement elements. The paper provides valuable lessons to modellers to simulate the performance of this type of earth retaining structure. For example, parametric investigation of the effect of a constant Young's modulus ranging from 40 to 120 MPa for the linear-elastic Mohr-Coulomb model had only minor influence on the wall facing displacements and reinforcement loads. However, the choice of magnitude of transient compaction pressure near the facing can result in large differences in facing displacements. The paper also demonstrates that the method of construction including the location, sequence, and stiffness of the temporary supports used to construct the wall plays an important role on measured and predicted wall performance. The physical measurements reported in this paper provide a benchmark for numerical modellers to verify other numerical models for walls of the type investigated here. [ABSTRACT FROM AUTHOR]

Current limit equilibrium-based design methods for the internal stability design of geosynthetic reinforced soil walls in North America are based on the American Association of State Highway and Transportation Officials (AASHTO) Simplified Method. A deficiency of this approach is that the influence of the facing type on reinforcement loads is not considered. This paper reports the results of two instrumented full-scale walls constructed in a large test facility at the Royal Military College of Canada. The walls were nominally identical except one wall was constructed with a stiff face and the other with a flexible wrapped face. The peak reinforcement loads in the flexible wall were about three and a half times greater than the stiff-face wall at the end of construction and about two times greater at the end of surcharging. The stiff-face wall analysis using the Simplified Method gave a maximum reinforcement load value that was one and a half times greater than the measured value at the end of construction. Furthermore, the surcharge pressure required to reach the creep-limited strength of the reinforcement was about two times greater than the predicted value. The results demonstrate quantitatively that a stiff facing in a reinforced soil wall is a structural component that can lead to significant reductions in reinforcement loads compared to flexible facing systems. [ABSTRACT FROM AUTHOR]