Search

Triply periodic minimal surfaces (TPMS) and honeycomb structures are typical representatives of porous structures. In this paper, multi‐layer structures based on the combination of P‐surfaces and honeycomb structures are fabricated and the compression deformation characteristics are investigated based on quasi‐static compression tests and finite element simulation. The results show that the established finite element model can better simulate the deformation and damage modes of the multi‐layer structure, and the multi‐layer structure exhibits layer‐by‐layer deformation and sequential compression collapse in the deformation process. The tensile stress is crucial in the deformation and damage process of the P‐structure layer. The honeycomb structure layers show two different deformation modes: the inverted bell‐shaped "upward extrusion" and the bell‐shaped "downward extrusion." [ABSTRACT FROM AUTHOR]

Progressive deformation of honeycomb structures subjected to in-plane loading was approximately analyzed by using the collapse modes of hexagonal unit cells. The collapse modes were categorized as freely compressive, restricted compressive, and shear. Moreover, there were five characteristic deformation patterns, namely deformation bands. Average stresses of the collapsing honeycomb models were evaluated in terms of the plastic collapse stress per hinge and total number of hinges of progressively arising deformation bands. The displacements of the models were obtained by multiplying the displacement per cell with the number of collapsed cells. The present method was used to analyze progressive deformation of typical honeycomb structures. The validity of the stress-displacement relations derived for some structures was confirmed by comparing them with finite element method (FEM) results. Our method is much simpler than FEM but just as effective. [ABSTRACT FROM AUTHOR]

Abstract: The in-plane impact behavior of honeycomb structures randomly filled with rigid inclusions was studied by using the finite element method to clarify the effect of inclusions on the deformation process, mean stress, densification strain, and absorbed energy. The deformation processes of the models were disturbed by inclusions; shear bands were pinned, and the cell regions surrounded by inclusions were shielded. Mean stress, densification strain, and absorbed energy per unit volume normalized by the values of the model without inclusions were found to be only dependent on the fraction of inclusions. As the volume fraction of inclusions increased, the normalized mean stress linearly increased and the normalized densification strain linearly decreased. The normalized absorbed energy per unit volume could be approximated by an inverted parabolic equation. The energy absorption of models with inclusions having volume fractions from 0 to 0.25 was larger than that of the models without inclusions. In particular, honeycomb models with fractions of inclusion from 0.1 to 0.2 exhibited the maximum absorbed energy. The model with a volume fraction larger than 0.4 could not be compressed because the inclusions in the model had already percolated before deformation. The in-plane impact behavior of honeycomb structures as energy absorbing materials can be designed by using the approximate equation and selecting the volume fraction of inclusions. [Copyright &y& Elsevier]