Search

Results of experimental investigation of the low-frequency shear elasticity of liquids depending on the angle of shear strain are presented. A cluster model of the liquid structure is suggested to explain the low-frequency viscoelastic relaxation. [ABSTRACT FROM AUTHOR]

The article deals with a study which developed an experimental method for determining the viscoelastic behavior of a sedimentary rock. The viscoelastic behavior of a sedimentary rock was investigated through a series of impact tests. It relates how the frequency dependence of the viscoelastic storage modulus and loss modulus is obtained. It describes the rock viscosity and its effect on stress wave propagations in the sedimentary rock.

In this paper, we consider a multi-dimensional system of thermoelasticity type III with a viscoelastic damping acting on a part of the boundary. We establish a general decay result, from which the usual exponential and polynomial decay rates are only special cases. [ABSTRACT FROM AUTHOR]

Chrome-free leather such as glutaraldehyde-tanned leather behaves very differently from chrome-tanned leather. Information regarding its viscoelasticity has not been previously reported. Hysteresis and stress relaxation are two essential properties associated with viscoelasticity. We have designed a cyclic tensile test to measure these properties to gain insight into the structural difference between chrome-free and chrome-tanned leather. Observations revealed that chrome-free leather tanned with glutaraldehyde has a higher hysteresis than chrome-tanned leather. Stress relaxation experiments, on the other hand showed chrome-free leather has very similar relaxation curves as chrome-tanned leather. Both leathers demonstrate a rapid decrease in stress for the first few seconds followed by a much slower decay thereafter. The chrome-free leather, however, has a greater initial stress than chrome-tanned leather, indicating a higher stiffness than chrome-tanned leather. Moreover, observations showed the viscoelasticity of leather was affected significantly by its fatliquor content. A decrease of loading energy in a cyclic stress–strain experiment resulted from higher fatliquor content in leather. [ABSTRACT FROM AUTHOR]

An approach is proposed to determine the dissipation function in viscoelasticity theory. The first and second laws of thermodynamics and naive and integrated viscoelastic models are considered by the example of linear viscoelasticity [ABSTRACT FROM AUTHOR]

Polymer composites reinforced by carbon nanotubes have been extensively researched for their strength and stiffness properties. Unless the interface is carefully engineered, poor load transfer between nanotubes (in bundles) and between nanotubes and surrounding polymer chains may result in interfacial slippage and reduced performance. Interfacial shear, although detrimental to high stiffness and strength, could result in very high mechanical damping, which is an important attribute in many commercial applications. We previously reported evidence of damping in nanocomposites by measuring the modal response (at resonance) of cantilevered beams with embedded nanocomposite films. Here we carry out direct shear testing of epoxy thin films containing dense packing of multiwalled carbon nanotube fillers and report strong viscoelastic behaviour with up to 1,400% increase in loss factor (damping ratio) of the baseline epoxy. The great improvement in damping was achieved without sacrificing the mechanical strength and stiffness of the polymer, and with minimal weight penalty. Based on the interfacial shear stress (∼0.5 MPa) at which the loss modulus increases sharply for our system, we conclude that the damping is related to frictional energy dissipation during interfacial sliding at the large, spatially distributed, nanotube–nanotube interfaces. [ABSTRACT FROM AUTHOR]

An analytic method for inverting the constitutive compliance equations of viscoelasticity for resins is developed. These equations describe the HWKK/H rheological model, which makes it possible to simulate, with a good accuracy, short-, medium- and long-term viscoelastic processes in epoxy and polyester resins. These processes are of first-rank reversible isothermal type. The time histories of deviatoric stresses are simulated with three independent strain history functions of fractional and normal exponential types. The stiffness equations are described by two elastic and six viscoelastic constants having a clear physic meaning (three long-term relaxation coefficients and three relaxation times). The time histories of axiatoric stresses are simulated as perfectly elastic. The inversion method utilizes approximate constitutive stiffness equations of viscoelasticity for the HWKK/H model. The constitutive compliance equations for the model are a basis for determining the exact complex shear stiffness, whereas the approximate constitutive stiffness equations are used for determining the approximate complex shear stiffness. The viscoelastic constants in the stiffness domain are derived by equating the exact and approximate complex shear stiffnesses. The viscoelastic constants are obtained for Epidian 53 epoxy and Polimal 109 polyester resins. The accuracy of the approximate constitutive stiffness equations are assessed by comparing the approximate and exact complex shear stiffnesses. The constitutive stiffness equations for the HWKK/H model are presented in uncoupled (shear/bulk) and coupled forms. Formulae for converting the constants of shear viscoelasticity into the constants of coupled viscoelasticity are given as well. [ABSTRACT FROM AUTHOR]