Search

As a piece of high-intensity running equipment, the wear of an internal mixer determines the quality of rubber and its life. In general, the wear of an internal mixer is caused by the friction between the rubber and metal during the mixing process, and the most severe wear position is the end face of the equipment. In this paper, a mixture of multi-walled carbon nanotubes (MWCNTs) and carbon fibers (CFs) are added to rubber by mechanical compounding to obtain MWCNT/CF/carbon black (CB) composites. By investigating the synergistic mechanism of MWCNTs and CFs, we analyze the effect of the MWCNT/CF ratio on the frictional wear of metal on the end face of the internal mixer. At the microscopic level, MWCNTs and CFs form a spatial meshwork with CB particles through synergistic interactions. The CB particles can be adsorbed on the spatial meshwork to promote the dispersion of CB particles. In addition, the formation of oil film can be slowed down due to the spatial meshwork, which could hinder the spillage of aromatic oil. Meanwhile, the spatial meshwork serves as a physical isolation layer between the rubber and metal to reduce friction. Therefore, it dramatically impacts the dispersion degree of CB particles, the friction coefficient, the roughness of the surface, and the wear of metal. It shows that the synergistic effect of MWCNT/CF and CB particles is best when the CF content of the rubber matrix is 5 phr, showing the most stable spatial network structure, the best dispersion of CB particles, and minor wear on the end face of the internal mixer. [ABSTRACT FROM AUTHOR]

The gap between the rotor and the mixer chamber wall is an important factor in determining filler dispersion in rubber compounds. The inner wall of a mixer will wear after working for a long time, which will cause poor filler dispersion and affect the quality of rubber products. In this study, MoDTC was added to carbon black as a kind of filler, and the effect on filler dispersion, the properties of the rubber product, and the friction and wear of rubber and metal in the mixing process were examined. Experimental data showed that after adding 3 phr of MoDTC, carbon black dispersion was greatly improved, the curing time was shortened, and the performance remained stable. It was also found that the Mo element of the compound with 3 phr MoDTC dispersed better than that of the other compounds. Most importantly, adding 3 phr of MoDTC greatly reduced the amount of wear on the metal during the mixing process. However, the opposite effect occurred when the MoDTC content was high. The method proposed in this study can not only improve filler dispersion in rubber but also reduce metal wear to prolong the service life of the mixing chamber when applied to an actual mixing process. [ABSTRACT FROM AUTHOR]