Search

We present a new high-fidelity method of calibrating a cross-track scanning microwave radiometer using Global Positioning System (GPS) radio occultation (GPSRO) measurements. The radiometer and GPSRO receiver periodically observe the same volume of atmosphere near the Earth's limb, and these overlapping measurements are used to calibrate the radiometer. Performance analyses show that absolute calibration accuracy better than 0.25 K is achievable for temperature sounding channels in the 50-60-GHz band for a total-power radiometer using a weakly coupled noise diode for frequent calibration and proximal GPSRO measurements for infrequent (approximately daily) calibration. The method requires GPSRO penetration depth only down to the stratosphere, thus permitting the use of a relatively small GPS antenna. Furthermore, only coarse spacecraft angular knowledge (approximately one degree rms) is required for the technique, as more precise angular knowledge can be retrieved directly from the combined radiometer and GPSRO data, assuming that the radiometer angular sampling is uniform. These features make the technique particularly well suited for implementation on a low-cost CubeSat hosting both radiometer and GPSRO receiver systems on the same spacecraft. We describe a validation platform for this calibration method, the Microwave Radiometer Technology Acceleration (MiRaTA) CubeSat, currently in development for the National Aeronautics and Space Administration (NASA) Earth Science Technology Office. MiRaTA will fly a multiband radiometer and the Compact TEC/Atmosphere GPS Sensor in 2015. [ABSTRACT FROM PUBLISHER]

Tipping calibration is an important technique for the absolute calibration of ground-based microwave radiometers. The standard tipping calibration is usually used in clear atmosphere. The spatial variations of liquid water in cloudy atmosphere may lead to great calibration errors in the process of standard tipping calibration. A new method of tipping calibration for ground-based microwave radiometers is proposed, which uses an accurate channel to calibrate another inaccurate channel in cloudy atmosphere. The simulation and measurements show that the method proposed here can eliminate the radiation of cloud liquid water and calibrate the radiometer under cloudy-sky conditions effectively. A relative tipping calibration is also introduced to retrieve the parameters in cloudy atmosphere. It has been proven that the relative tipping calibration can reduce the retrieval error significantly in cloudy atmosphere even though neither of the two channels is accurate. [ABSTRACT FROM PUBLISHER]

The local oscillators (LOs) of the Soil Moisture and Ocean Salinity mission payload are used to shift the operating frequency of the 72 receivers to an optimal intermediate frequency needed for the signal processing. The LO temperature variations produce phase errors in the visibility, which result in a blurring of the reconstructed brightness temperature (Tb) image. At the end of the commissioning phase, it was decided to calibrate the LO every 10 min while waiting for a more in-depth analysis. During short periods of time, the LO calibration has been performed every 2 min to assess the impact of a higher calibration rate on the quality of the data. In this paper, by means of a decimation experiment, the relative errors of 6- and 10-min calibration interval data sets are estimated using the 2 min as a reference. A noticeable systematic across- and along-track pattern of amplitude \pm0.3 K is observed for Tb differences between 10 and 2 min, whereas this is reduced between 6 and 2 min. A simulation experiment confirms that the nature of such systematic pattern is due to the visibility phase errors induced by the LO calibration rate. Such pattern is propagated into the sea surface salinity (SSS) retrievals. Overall, the SSS error increase (relative to the 2 min SSS data) is about 0.39 and 0.14 psu for the 10- and 6-min data sets, respectively. This paper shows that a LO calibration rate of at least 6 min would noticeably improve the SSS retrievals. [ABSTRACT FROM AUTHOR]

Soil Moisture and Ocean Salinity (SMOS) brightness temperature synthesized images are obtained after a comprehensive error correction procedure that takes into account both on-ground and in-flight calibration measurements. However, the final images are still contaminated by small, although nonnegligible, spatial errors: the so-called pixel bias. Since spatial errors in the 2-D SMOS images are not zero mean along track, these errors produce clearly visible artifacts aligned to this direction. Fortunately, spatial errors have been found to be very stable and can be minimized once the image distortion pattern is properly measured by observing a target at a uniform brightness temperature distribution. This letter describes the procedure to compute a multiplicative mask that largely reduces spatial errors over the ocean. Preliminary results to assess the mask performance are also presented by computing the reduction of the rms spatial error for a number of targets selected to have significant temporal and geographical diversity. [ABSTRACT FROM PUBLISHER]

Since its launch in December 1999, Terra MODIS has been making continuous Earth observations for more than seven years. It has produced a broad range of land, ocean, and atmospheric science data products for improvements in studies of global climate and environmental change. Among its 36 spectral bands, there are 20 reflective solar bands and 16 thermal emissive bands (TEBs). MODIS TEBs cover the mid-wave infrared and long-wave infrared spectral regions with wavelengths from 3.7 to 14.4 μm. They are calibrated on-orbit using an onboard black- body (BB) with its temperature measured by a set of thermistors on a scan-by-scan basis. This paper will provide a brief overview of MODIS TEB calibration and characterization methodologies and illustrate onboard BB functions and TEB performance over more than seven years of on-orbit operation and calibration. Discussions will be focused on TEB detector short-term stability and noise characterization and changes in long-term response (or system gain). Results show that Terra MODIS BB operation has been extremely stable since launch. When operated at its nominal controlled temperature of 290 K, the BB temperature variation is typically less than ±0.30 mK on a scan-by-scan basis, and there has been no time-dependent temperature drift. In addition to excellent short-term stability, most TEB detectors continue to meet or exceed their specified noise characterization requirements, thus enabling calibration accuracy and science data product quality to be maintained. Excluding the noisy detectors identified prelaunch and those that occurred postlaunch, the changes in TEB responses have been less than 0.7% on an annual basis. The optical leak corrections applied to bands 32-36 have been effective and stable over the entire mission. [ABSTRACT FROM AUTHOR]

Ten underflights of the Special Sensor Microwave Imager/Sounder (SSMIS) with Conical Scanning Millimeter-wave Imaging Radiometer (CoSMIR) onboard the NASA ER-2 aircraft were conducted over the coastal region of California between March 2004 and March 2005. The measured brightness temperature (Tb) values from both sensors are collocated and compared at frequencies of 50.3, 52.8, 53.6, 91.655, 150, 183.3 ± 1,183.3 ± 3, and 183.3 ± 6.6 GHz. The more transparent channels at 50.3, 91.655, and 150 GHz are strongly affected by the changes in surface emission and low-level liquid clouds. Thus, the average differences in Tb values (δTb), measured by the two sensors, and their changes from flight to flight are difficult to assess. For the remaining opaque channels, using the CoSMIR measurements as reference, the lowest SSMIS Tb values occur when the SSMIS is completely under the Earth's shadow. As the satellite moves out of the Earth's shadow in the ascending passes, the SSMIS Tb values are found to gradually increase with more exposure to the sun. The magnitudes of these Tb changes are about 4-5 K for the three 183.3-GHz channels and about 2 K for the 52.8- and 53.6-GHz channels. [ABSTRACT FROM AUTHOR]