Search

Background: Driven by climate change mitigation, EU countries are committed to improve energy efficiency of their building stock by implementing the energy performance of buildings directive (EPBD). Should higher energy efficiency result in better indoor environmental quality (IEQ), this policy could also be seen as an opportunity to improve public health across Europe.Objectives: This paper focuses on the assessment of the effects of energy retrofits on occupant satisfaction with IEQ and health in multifamily buildings.Methods: Data on occupant satisfaction with IEQ and health were collected from the occupants of 39 Finnish and 15 Lithuanian multifamily buildings (an average of five apartments per building, one adult per apartment) both before and after energy retrofits (such as improving thermal insulation, windows, heating and/or ventilation systems). Parallel to the data collected from the occupants, data on several IEQ parameters, including temperature, temperature factor, and air change rate, were collected from their apartments. Moreover, data from seven Finnish and five Lithuanian non-retrofitted control buildings were collected according to the same protocol.Results: Occupant satisfaction regarding indoor temperature was associated with both retrofit status (OR 5.3, 95% CI 2.6-11.0) and measured IEQ parameters (indoor temperature OR 1.4 per 1 °C increase, temperature factor OR 1.1 per 1% increase, and air change rate OR 5.6 per 1/h increase). Additional positive associations were found between retrofit status and occupants reporting absence of upper respiratory symptoms (OR 1.8, 95% CI 1.1-2.9) as well as not missing work or school due to respiratory infections (OR 4.1, 95% CI 1.2-13.8), however, these associations were independent of the measured IEQ parameters.Conclusions: There seems to be a strong subjective component related to the observed changes in occupant satisfaction with IEQ and health as a result of energy retrofitting in buildings. Further studies are needed to verify the actual mechanisms, as well as possible long term effects. [ABSTRACT FROM AUTHOR]

This paper uses an example of an architect designed and occupied suburban house in the temperate climate of Perth, Western Australia to demonstrate how climatic design and low-technology active systems can deliver thermal comfort in average climatic conditions. However when thermal conditions are more extreme acceptable temperature ranges may not be met. Thermal monitoring in the house over eight days of extreme temperatures in summer and winter shows that acceptable temperature ranges may not be met in winter. During extreme winter conditions south facing rooms fall below comfort conditions by up to 3 K in the late night and early morning. The conclusion drawn is that in naturally ventilated buildings personal and psychological behavioral adaptation must go hand-in-hand with climatic design. This behavioral adaptation may become more important in the future if current climatic extremes become the new normal. [ABSTRACT FROM AUTHOR]

Many newly built, energy-efficient terraced houses are characterised by high indoor air temperatures and thermal comfort issues, because these state-of-the-art houses were designed and built without considering the warming climate conditions in the summer. As a result, many of these residential buildings are at risk of overheating and require careful implementation of passive cooling design systems when retrofitting. This study reviews the overheating risk and energy effectiveness of six passive design strategies tested and implemented in an innovative terraced house located in southeast London during the long-term heatwaves experienced in both the UK and continental Europe in the summer of 2018. A quantitative research methodology is employed based on an extensive monitoring campaign conducted to measure environmental conditions, including indoor air temperature, relative humidity and CO 2 of each occupied space in a prototype base-case building. In the subsequent phase of the research, retrofit strategies were investigated by modelling and simulation using the Integrated Environmental Solutions (IES) software suite for data validation. The preliminary results of the modelling and simulation confirmed the survey findings of high levels of occupant discomfort and relatively high cooling loads. The internal operating temperatures of the simulated rooms remained high throughout the day and night during the long-term heatwaves, ranging from a minimum of 24.7 °C to a maximum of 32.1 °C. The results highlight significant deviations in the estimated energy consumption of the base-case building as well as in the energetic and environmental indexes of the passive cooling design strategies. The study will contribute to the strategic design of retrofit interventions to effectively reduce cooling energy consumption by considering occupants' thermal comfort, thermal adaptation and energy use. Graphical abstract to this article can be found online at – The Graphical abstract illustrates the adopted and developed comprehensive methodological design approach for the study. [Display omitted] [ABSTRACT FROM AUTHOR]

• A numerical model is developed to study indoor thermal conditions during heat waves. • Moisture buffering can have an important influence on the indoor thermal conditions. • Pre-cooling before the start of a heat wave can lower indoor temperature moderately. • Moisture-desorption cooling has a large potential in reducing indoor heat stress. Urban areas are increasingly impacted by the urban heat island effect, especially during heat waves. In the context of improving energy efficiency in buildings, passive and energy-efficient cooling methods are needed for reducing indoor heat stress and lowering building energy consumption during heat waves. In this study, a whole building simulation model that includes both moisture and heat transport in wall envelopes and indoor environment is developed. An analytical solution and two test cases are used to validate the developed model. The developed model is applied to study indoor thermal conditions in urban areas in Zurich, Switzerland in a hot summer. The results show that indoor temperature could not be accurately simulated when moisture transport in the wall envelopes is neglected. Due to the urban heat island effect, night ventilation is not sufficient to cool down the indoor environment during the heat wave in the urban area. The potential of precooling before the heat wave and moisture-desorption cooling from hygroscopic materials have been studied to reduce indoor heat stress in the urban area. The average operative temperature during the heat wave can be reduced by 0.43 °C by precooling before the start of the heat wave, whereas desorption cooling from hygroscopic materials could reduce the average operative temperature during heat waves by 1.31 °C. A combination of these two mitigation measures could lead to enhanced passive cooling effect. There is a large potential of using desorption of hygroscopic material to reduce heat stress during heatwaves, while minimizing energy consumption of buildings. [ABSTRACT FROM AUTHOR]

• Real historic buildings with artworks are examined. • Indoor environment, thermal comfort and energy performance were assessed. • The indoor environment is simulated and validated with on-site measurements. • Future indoor climate conditions were predicted for a 2050 scenario. • Future climate change will increase cooling demand. Climate change will affect the indoor temperature of historic buildings, impacting the preservation of artworks and the thermal comfort of users, and possibly leading to increased energy consumption. These buildings generate more emissions than new buildings and in most European countries, preservation principles take precedence over energy efficiency and the reduction of emissions. This research is a key topic for the mitigation of climate change and proposes a method for assessing the impact of climate change on the preservation of artworks, thermal comfort, and energy consumption. An experimental method was followed, combining analytical formulations, on-site measurements, and Heating, Ventilation and Air Conditioning systems in order to identify the adequate hygrothermal parameters for historic buildings. The climate change scenario predicted for 2050 was based on projected temperature variation. The case studies were Baroque churches, historic buildings located in the south of Europe. Data obtained from a monitoring campaign carried out in these churches was used to validate dynamic simulation models. The churches analysed showed an increase in cooling demand and a decrease in heating demand. Furthermore, in order to ensure human comfort and the preservation of artworks, it was necessary to implement active systems in operation for 12-hour periods. These results suggest an energy overconsumption, as the energy consumption for human comfort and artwork preservation was 50% higher than the energy consumption of active systems for the preservation of valuable historic objects. In addition, the annual energy consumption decreases for future scenarios for 2050 in the case of artwork preservation and thermal comfort, but increases by almost 15% for the preservation of works of art due to higher level relative humidity. Before historic buildings can be adapted, it is essential to understand the influence of the future climate on their design, construction, and environmental conditions. [ABSTRACT FROM AUTHOR]