Search

The share of biofuels in the transportation sector is increasing. Previous studies revealed that the use of biofuels decreases the size of particles (which is linked to an increase in particulate toxicity). Current emission regulations do not consider small particles (sub-23 nm); however, there is a focus in future emissions regulations on small particles. These and the fact that within cold-start emissions are higher than during the warmed-up operation highlight the importance of a research that studies particulate matter emissions during cold-start. This research investigates the influence of biofuel on PN and PM concentration, size distribution, median diameter and cumulative share at different size ranges (including sub-23 nm and nucleation mode) during cold-start and warm-up operations using diesel and 10, 15 and 20% mixture (coconut biofuel blended with diesel). During cold-start, between 19 and 29% of total PN and less than 0.8% of total PM were related to the nucleation mode (sub-50 nm). Out of that, the share of sub-23 nm was up to 9% for PN while less than 0.02% for PM. By using biofuel, PN increased between 27 and 57% at cold-start; while, the increase was between 4 and 19% during hot-operation. The median diameter also decreased at cold-start and the nucleation mode particles (including sub-23 nm particles) significantly increased. This is an important observation because using biofuel can have a more adverse impact within cold-start period which is inevitable in most vehicles’ daily driving schedules.

Diesel particulate filters (DPF) are widely adopted in diesel vehicles to meet the increasingly stringent emission regulations, which require continuous passive regenerations or/and periodic active regenerations to burn off the accumulated particulate matter (PM). In spite of many laboratory studies using DPF benches and engine/chassis dynamometers, there is currently a lack of investigation on DPF regeneration under real-world conditions. Therefore, this study was conducted to investigate the impact of active DPF regenerations on the fuel consumption and gaseous and particulate emissions performance of a diesel light goods vehicle under real-driving conditions by using the state-of-the-art portable emission measurement system. In total, 60 real-driving emission (RDE) tests (∼1200 km in total) were performed on the same route during the same periods of a day, to minimise the effect of uncontrollable real-world factors on the performance evaluation. The results showed that real-world active DPF regenerations occurred every 130 km for the studied vehicle. Although they did not occur frequently, DPF regenerations increased the trip-averaged fuel consumption rate by 13% on average. CO and THC emission factors tended to increase with DPF regenerations because the post combustion used to achieve the high exhaust temperature for regeneration of the filter occurred under oxygen-lean conditions. Total NOx emissions were not affected but NO2/NOx ratio was greatly reduced by DPF regeneration due to lower NO oxidation by the diesel oxidation catalyst and higher NO2 reduction by the DPF. Finally, DPF regenerations sharply increased PM emission factors by 27 times compared with a trip without DPF regeneration, resulting in significant exceedance of the emission limit.

Surrogate fuels for hydrothermal liquefaction (HTL) algae biocrude depicting its nitrogen (N) and sulphur (S) content were simulated in this study and tested in a multi-cylinder diesel engine. The influence of N and S presence in the fuel on its combustion behaviour and emissions profile was investigated. To our knowledge, N and S-containing fuels in reference to HTL algae biocrude, have not been reported in an internal combustion engine in the literature, which is the unique and novelty of the current work. The presence of N and S in the fuel affected its physical properties. The density of the surrogate fuel was slightly higher than that of diesel, while viscosity, in general, was maintained. The flash point of the N and S-fuel was reduced in the presence of N. N had a stronger effect than S in reducing the lower heating value (LHV) of the surrogate fuel than that of diesel. Compared to diesel, emissions of both carbon monoxide (CO) and unburned hydrocarbons (HC) were lower for N and S-containing fuels. Increasing nitrogen oxides (NOx) and sulphur dioxide (SO2) emissions were observed with increasing N and S content, respectively, in the fuels. A significant increase in particle mass (PM) emissions was observed at high concentrations of N (4.5 wt%) and S (0.2–0.4 wt%). Such values of S are found in some off-road and marine applications. Therefore, HTL biofuel can be a low-sulphur alternative fuel for shipping industry because its fuel properties similar to that of bunker fuel.