Search

A commercial phage biocontrol for reducing Listeria monocytogenes has been described as an effective tool for improving fresh produce safety. Critical challenges in the phage application must be overcome for the industrial application. The validation studies were performed in two processing lines of two industry collaborators in Spain and Denmark, using shredded iceberg lettuce as the ready-to-eat (RTE), high process volume product. The biocontrol treatment optimized in lab-scale trials for the application of PhageGuard ListexTM was confirmed in industrial settings by four tests, two in Spain and two in Denmark. Results showed that the method of application that included the device and the processing operation step was appropriate for the proper application. The proper dose of Phage Guard ListexTM was reached in shredded iceberg lettuce and the surface was adequately covered for the successful application of phages. There was no impact on the headspace gas composition (CO2 and O2 levels), nor on the color when untreated and treated samples were compared. The post-process treatment with PhageGuard ListexTM did not cause any detrimental impact on the sensory quality, including flavor, texture, browning, spoilage, and visual appearance over the shelf-life as the phage solution was applied as a fine, mist solution.

Haloacetic acids (HAAs) are one of the most important chlorinated disinfection by-products generated during water disinfection in the fresh-cut industry, and they can remain in the product, resulting in a consumer health risk. In this study, ultra-high-pressure liquid chromatography-tandem multiple reaction monitoring mass spectrometry (UHPLC-MRM) analysis used for drinking water was optimized and applied for the quantification of nine HAAs (HAA9) in fresh-cut lettuce and process water samples, with the complex matrix interferences for separation, and quantification problems. The method showed good selectivity, specificity and linearity, satisfactory values for trueness (recoveries of 80–116 %), precision (<22 %), and uncertainty (<55 %). Quantification limits varied from 1 to 5 µg L−1 or µg kg−1. The matrix effect for tribromoacetic, bromochloroacetic and chlorodibromoacetic acid was corrected by matrix-matched calibration and standard addition. After storage at -20 °C, only monobromoacetic acid was the HAA which loss happened after 7 days. The application of the methodology in lettuce and process water samples from the industry was successfully implemented. Therefore, this method could be employed for the quality control and regulatory analysis of HAAs in fresh products and process water from the fruit and vegetable industry

Since 2020, there is a new European Regulation (EU, 2020/741) on minimum requirements for water reuse, where routine and validation monitoring requirements (log reductions of indicator microorganisms and reference pathogens) have been established. Many reclamation facilities that are already in operation might have difficulties to comply with these performance targets. Existing disinfection systems must be expanded and upgraded. In the case of UV disinfection systems, fluence requirements must be determined to properly design with a focus on the safety and economic-environmental viability of reclaimed water. This study can be used as a reference to develop fluence-response curves for Clostridium perfringens spores, Escherichia coli, and total and F-specific coliphages, indicator microorganisms referred to in the new European Regulation. Eight UV-LED collimated beam tests were performed. Samples were obtained from filtered effluent of secondary treatment from two wastewater treatment plants (WWTPs) which ranged between 30 and 54%. Results showed UV sensitivity of 33.46 mJ/cm2 log I for C. perfringens spores and 2.86 mJ/cm2 log I for E. coli, both from environmental origin. Coliphages were inactivated below the limit of quantitation. The non-dominance of MS2 phages in environmental F-specific coliphages was observed

Postharvest research must enable us to translate fundamental knowledge into innovative and sustainable solutions to reduce postharvest losses. These include genetic improvements by selecting cultivars with good flavour and texture and long postharvest life, sensor improvements to monitor and control the ripeness and the optimal maturity for harvest, and improvements in quality control and storage conditions. New packaging technologies using biodegradable and recycled materials are promising solutions for helping with environmental sustainability. However, they should also be adequate for fresh produce quality maintenance. The innovative actions should combine appropriate optimal temperature and relative humidity during storage, transport, and distribution to create the desired conditions around the commodity for freshness preservation. To achieve these goals, collaborative actions that integrate all the aspects related to postharvest losses are needed starting from the agricultural production activities to processing, marketing, distribution, and even consumers.