Search

The paper presents the results of a study of parameters used for determining the amount of organic pollutants in wastewater flowing into a collective wastewater treatment plant with a population equivalent of about 120 000 PE. The plant constituted part of a sewage system. Assays were performed for biochemical oxygen demand (BOD5), chemical oxygen demand (CODCr), permanganete index (CODMn) and total organic carbon (TOC). In addition, the pH of wastewater and its alkalinity were determined. Sampling of incoming wastewater and measurement of physicochemical parameters were performed once a week, in the spring. A total of 44 samples of wastewater were collected. The correlations between the individual parameters and the correlations between the ratios of these parameters were determined. It was found that it was possible to estimate, with suffi cient accuracy, the values of selected parameters for determining the concentrations of organic compounds in municipal wastewater, knowing the values of other parameters in this group. Moreover, it was shown that, knowing the relationship between the analyzed parameters, one can find multiple regression equations for a given type of wastewater, which allow one to calculate the remaining relationships with a good fit, i.e. a determination factor R2greater than 0.6

The sludge generated from wastewater treatment facilities contains high nutrients and is characterized by high heating values. Thus, the sludge enriched with organic matter and nutrients is a potential candidate for its application as fertilizers and an alternate energy feedstock. Nowadays, energy independence contributes to the economic stability of the country, and therefore the search for alternate energy sources is an acute issue. This paper presents a case study on using sewage sludge as an energy feedstock in Poland. The physicochemical characteristics of the sewage sludge are presented. The fuel properties of sewage sludge generated from different waste water treatment plant (WWTP) are summarized. The calorific value of sewage sludge generated in Poland is insufficient for effective use as an energy raw material, therefore, energy potential of mixture of sludge with other waste have been studied. The general trend of sewage sludge formation and the quantitative forecast for the future showed that in 2020, compared to 2012, sludge accumulation increased by 6.9%, but compared to 2019 - decreased by 3%. From 2012 to 2020 the average, sewage sludge accumulation increased annually by 0.8%. This demonstrates the heterogeneity of waste streams for the production of alternative fuels and a modest increase in sewage sludge production in the coming years. This made it possible to prepare several options for the further development of research in the field of developing technologies for obtaining alternative energy. Also this study will help the prospective researchers understand sewage sludge generation and its use as energy feedstock.

This study analyzed the effect of lightweight aggregates made of fly ash from sewage-sludge thermal treatment (FASSTT LWA) on the effectiveness of phosphorus removal from wastewater in vertical constructed wetlands (CWs), depending on FASSTT LWA content in the CW filling and hydraulic loading rate. It was performed over 13 weeks using 15 lysimeters prepared as double-layer systems. An upper layer was made of FASSTT LWA above the gravel layer with different thicknesses of FASSTT LWA (CW 0 cm: only gravel; CW 12 cm, CW 25 cm; CW 50 cm, and CW 100 cm: only FASSTT LWA). Each filling variant was repeated three times. Wastewater with a mean phosphorus concentration of 7.43 mgP/L was fed to the lysimeters once a day. The hydraulic loading rates tested were 3.0, 5.0, and 7.0 mm/d. Both the increased FASSTT LWA content in the CW filling and the decreasing hydraulic loading rate were found to boost the effectiveness of phosphorus removal in the treated wastewater. Constructed wetland filled in 100 % with FASSTT LWA ensured a reduction in phosphorus concentration below 2.0 mg P/L at all hydraulic loading rates tested.

This paper presents the results of a study on the possibility of applying various configured filters filled with a mixture of Rockfos® and Leca® material for the effective capture of phosphate from domestic wastewater. The tests were carried out for two years at two wastewater flow rates (20 and 40 L/day) in three pairs of filtration columns with a volume of filter material equal to 20 L each. Columns 1A and 1B were filled only with Rockfos®. Columns 2A and 2B contained Rockfos® and two 5-cm layers of Leca®. Columns 3A and 3B were filled with Rockfos® and a 10% addition of Leca®. A high phosphate removal efficiency was obtained at a level of 93.2–94.9% for all columns tested at a flow rate of 20 L/day with a retention time of 12 h. After 250 days of the experiment, the efficiency of phosphate removal decreased significantly, which was associated with a drop in the temperature of the inflowing wastewater (3 Rockfos® with the addition of Leca® in 1 m3/day of wastewater inflow.

The present study was focused on the characterization of the biocenotic diversity of saprotrophic fungi, taking into account the impact of various treatment systems and technological stages as well as the physicochemical properties of wastewater. The biodegradation potential, the hazard posed to humans, animals, and the environment, and the effectiveness of elimination of propagules were evaluated. The most effective elimination of fungal propagules was recorded in hybrid constructed wetland systems with horizontal (HF-CW) and vertical (VF-CW) wastewater flow, especially in the VF-HF objects. The fungal communities present in wastewater from small constructed wetland (CW) and wastewater stabilization ponds (WSP) were dominated by ubiquitous terrestrial molds accompanied by a minimal number of yeasts. The similarity of the species composition of the fungal communities between the treatment plants was generally low, whereas the species diversity together with the population size was very high at the various stages of wastewater treatment. Species with potential pathogenicity to humans and animals accounted for over 45%, i.e., were classified as BioSafety Level 1 and 2 (BSL-1 and BSL-2 groups), and potentially phytopathogenic fungi represented 31.5% of the mycobiota species composition. The dynamics of fungal growth were correlated with the content of organic pollutants and nutrients (nitrogen and phosphorus) and with oxygen deficiency. The accumulation of nitrates corresponded to the decline in the frequency of fungi in treated wastewater. The lowest efficiency of the removal of fungi was exhibited by the biological wastewater stabilization ponds.

Data for the years 2001–2020 on changes in the amount of rainwater in the Roztocze National Park (RNP) in the catchment area of the Świerszcz River (Poland) were investigated to evaluate the possibility of using rainwater in the park for various purposes in the context of ongoing climate variability. An analysis of data from the RNP’s Integrated Monitoring of the Natural Environment showed that the average annual air temperature increased by 2.1 °C over the 20-year period, while the amount of precipitation decreased, especially in the winter seasons. These changes periodically led to a negative hydrological balance. As an effect, the groundwater table was gradually lowering, the flow of the Świerszcz River was reduced, and there were periodic shortages of water feeding the Echo Ponds. Water shortages also negatively affected the flora and fauna of the RNP. In order to quantitatively protect the Park’s water resources, a proposition was made to build a rainwater management system at the Animal Breeding Centre in Florianka to provide water for watering Polish Konik horses, flushing toilets, washing cars and agricultural equipment, and fire-prevention purposes. The excess water would be discharged to a nearby pond, which is an amphibian breeding site. It was estimated that the system was capable of meeting 100% of the demand for lower-quality water in the summer period. Moreover, it was determined that 9109 m3 of rainwater could be obtained annually from the roofs of all public utility buildings located in the RNP.