Search

In this work, we performed transient reflection measurements using the pump–probe protocol to investigate the influence of lattice defects induced by 380 keV argon (Ar) ions on the phonon dynamics of interlayer shearing (E 2 g 1 ) and in-plane carbon stretching (E 2 g 2 ) modes in highly oriented pyrolytic graphite (HOPG). The frequency and decay rate of E 2 g 1 - and E 2 g 2 -mode phonons were changed significantly at the fluence of 1 × 10 14 ions/cm 2. This indicated that significant structural changes in HOPG due to 380 keV Ar-ion irradiation were expressed as changes in the frequency and decay rate of phonons. In HOPG irradiated with 380 keV Ar + at the fluence of 1 × 10 14 ions/cm 2 , our measurement results indicated that compressive and tensile stresses contributed to in-plane and interlayer graphite structures, respectively. [ABSTRACT FROM AUTHOR]

Glassy carbon substrates were implanted with 100 keV platinum ions. The implanted samples were analyzed using cross-sectional transmission electron microscopy (TEM) and x-ray photoelectron spectroscopy. Ion beam sputtering significantly affected the depth profile during platinum-ion implantation. Cross-sectional TEM revealed that the implanted platinum atoms were in the amorphous state and did not aggregate. Chemical state analysis of the platinum-ion-implanted glassy carbon substrates suggested that lattice defects in the substrates owing to the platinum-ion implantation caused the platinum–carbon interaction with electron transfer from platinum to carbon. [ABSTRACT FROM AUTHOR]

Proton exchange membrane fuel cells (PEMFCs) have attracted considerable attention as distributed power sources for automotive and residential applications. In PEMFCs, platinum (Pt) nanoparticles supported on carbon materials are used as electrocatalysts for oxygen reduction reactions. However, improved durability of the electrocatalysts is urgently required for commercialization purposes. We describe an ion implantation technique for the preparation of Pt nanoparticles with superior catalytic properties, suitable for fuel cell applications. The Pt nanoparticles were obtained by implanting a glassy carbon (GC) substrate with 100 keV Pt-ions, followed by electrochemical etching and a heat treatment. Electrochemical measurements of the Pt nanoparticles prepared by the proposed implantation technique demonstrated superior durability when compared to those prepared by the conventional magnetron sputtering method. We suggested that the defective structure of the GC substrate, caused by the Pt-ion implantation, has led to the improved electrochemical stability of the GC substrate and Pt-carbon support interactions, thereby enhancing the durability of our Pt nanoparticles. [ABSTRACT FROM AUTHOR]