Search

Sediment fluxes to the seafloor govern the fate of elements and compounds in the ocean and serve as a prerequisite for research on elemental cycling, benthic processes and sediment management strategies. To quantify these fluxes over seafloor areas, it is necessary to scale up sediment mass accumulation rates (MAR) obtained from multiple sample stations. Conventional methods for spatial upscaling involve averaging of data or spatial interpolation. However, these approaches may not be sufficiently precise to account for spatial variations of MAR, leading to poorly constrained regional sediment budgets. Here, we utilize a machine learning approach to scale up porosity and 210 Pb data from 145 and 65 stations, respectively, in the Skagerrak. The models predict the spatial distributions by considering several predictor variables that are assumed to control porosity and 210 Pb rain rates. The spatial distribution of MAR is based on the predicted porosity and existing sedimentation rate data. Our findings reveal highest MAR and 210 Pb rain rates to occur in two parallel belt structures that align with the general circulation pattern in the Skagerrak. While high 210 Pb rain rates occur in intermediate water depths, the belt of high MAR is situated closer to the coastlines due to lower porosities at shallow water depths. Based on the spatial distributions, we calculate a total MAR of 34.7 Mt yr -1 and a 210 Pb rain rate of 4.7 · 10 14 dpm yr -1 . By comparing atmospheric to total 210 Pb rain rates, we further estimate that 24% of the 210 Pb originates from the local atmospheric input, with the remaining 76% being transported laterally into the Skagerrak. The updated MAR in the Skagerrak is combined with literature data on other major sediment sources and sinks to present a tentative sediment budget for the North Sea, which reveals an imbalance with sediment outputs exceeding the inputs. Substantial uncertainties in the revised Skagerrak MAR and the literature data might clo

Carbon dioxide removal (CDR) technologies at a gigaton scale need to be developed and implemented within the next decades to keep global warming below 1.5 °C. Coastal enhanced silicate weathering is one of the proposed CDR techniques that aims to accelerate the natural process of CO2-sequestration during marine chemical weathering of silicate minerals. To this end, finely ground rock containing olivine (MgxFe2− xSiO4) could be dispersed in dynamic coastal environments, where local biotic and abiotic factors potentially enhance the weathering process. However, accurate predictions of the olivine dissolution rate and the associated CO2 sequestration under in situ conditions are currently lacking and ecosystem impacts remain to be assessed. Previously, it has been hypothesized that in situ grain collisions, induced by bed load transport due to currents and waves, could accelerate the in situ chemical weathering of olivine particles. To examine this, we investigated the effects of continuous grain tumbling on olivine dissolution in natural seawater. A 70-day experiment was conducted in which forsterite olivine sand was continuously tumbled in filtered seawater at different rotation speeds, and dissolution rates were measured on a weekly basis. Results showed that continuously tumbled olivine dissolved 8 to 19 times faster compared to stagnant (no rotation) conditions. Olivine dissolution was complete and stoichiometric (except for Ni release), air-seawater CO2 exchange was not significantly rate limiting, and minimal particle fragmentation and secondary mineral formation were observed. Hence, we infer that olivine weathering was mainly enhanced via advective pore water flushing, which limits saturation effects at the grain scale. Overall, this study provides evidence that ambient physical stresses in coastal environments could enhance marine silicate weathering, which has implications for bo, BT/Environmental Biotechnology

High alkalinity values observed in coastal seas promote the uptake of CO2 from the atmosphere. However, the alkalinity budget of coastal areas and marginal seas is poorly understood, even though some of the recently observed alkalinity enhancement can be ascribed to riverine fluxes and anaerobic processes in shelf sediments. Here, we investigate the alkalinity budget of the Baltic Sea to identify previously unrecognized alkalinity sources. We quantify the generation of alkalinity and dissolved calcium (Ca) in this marginal sea applying simple mass balance calculations. Using this approach, we identify alkalinity and Ca sources of approximately 324 Gmol yr-1 and 122 Gmol yr-1, respectively, that cannot be ascribed to the riverine input. The magnitude of the Ca source suggests that a major fraction of the excess alkalinity (244 Gmol yr-1) is induced by the dissolution of calcium carbonate (CaCO3). A review of available field data shows that carbonate-bearing rocks at the coast and the seabed of the Baltic Sea are rapidly eroded and may provide sufficient CaCO3 to close the Ca budget. Hence, dissolution of eroded CaCO3 is the most likely source for the Ca enrichment observed in Baltic Sea water. This hypothesis is supported by mass accumulation rates of sediments derived from radioisotope data that are evaluated to derive a basin-wide rate of mud to muddy sand accumulation at the bottom of the Baltic Sea. The resulting value (139 Tg yr-1) exceeds current estimates of riverine particle fluxes into the Baltic Sea by more than one order of magnitude and confirms that rates of till erosion are sufficiently high to account for the Ca and most of the alkalinity excess in Baltic Sea water. Finally, we show that deliberate addition of CaCO3 to sediments deposited in the Baltic Sea could neutralize significant amounts of CO2 and help to achieve net-zero greenhouse gas emissions in the Baltic region.

kein Abstract verfügbar, +This text was published in Ismaiel-Wendt, Johannes Salim and Schoon, Andi. Postcolonial Repercussions: On Sound Ontologies and Decolonised Listening, Bielefeld: transcript Verlag, 2022. https://doi.org/10.1515/9783839462522. It is posted here by permission of transcript Verlag for personal use only, not for redistribution. + ID der Publikation: hslu_90456 + Art des Beitrages: Buchkapitel/Beitrag in Sammelband + Herausgeberschaft: Johannes Salim Ismaiel-Wendt; Andi Schoon + Seiten: 133 - 152 + Titel der Reihe: SOUND STUDIES + Nummer des Reihentitels: 6 + Sprache: Englisch + Letzte Aktualisierung: 2022-08-26 09:56:34

Enhanced weathering of mafic and ultra-mafic minerals has been suggested as a strategy for carbon dioxide removal (CDR) and a contribution to achieve a balance between global CO2 sources and sinks (net zero emission). This study was designed to assess CDR by dissolution of ultramafic sand (UMS) in artificial seawater (ASW). Fine grained UMS with an olivine content of ~75% was reacted in ASW for up to 134 days at 1 bar and 21.5–23.9°C. A decline in total alkalinity (TA) was observed over the course of the experiments. This unexpected result indicates that TA removal via precipitation of cation-rich authigenic phases exceeded the production of TA induced by olivine dissolution. The TA decline was accompanied by a decrease in dissolved inorganic carbon and Ca concentrations presumably induced by CaCO3 precipitation. Temporal changes in dissolved Si, Ca, Mg, and TA concentrations observed during the experiments were evaluated by a numerical model to identify secondary mineral phases and quantify rates of authigenic phase formation. The modeling indicates that CaCO3, FeOOH and a range of Mg-Si-phases were precipitated during the experiments. Chemical analysis of precipitates and reacted UMS surfaces confirmed that these authigenic phases accumulated in the batch reactors. Nickel released during olivine dissolution, a potential toxic element for certain organisms, was incorporated in the secondary phases and is thus not a suitable proxy for dissolution rates as proposed by earlier studies. The overall reaction stoichiometry derived from lab experiments was applied in a box model simulating atmospheric CO2 uptake in a continental shelf setting induced by olivine addition. The model results indicate that CO2 uptake is reduced by a factor of 5 due to secondary mineral formation and the buffering capacity of seawater. In comparable natural settings, olivine addition may thus be a less efficient CDR method than previously believed.