Search

The dew point pressure can be obtained by conventional condensate gas phase test in PVT cylinders. However, in condensate gas reservoirs, the fluid interacts with the fractured-vuggy porous media, which makes the depletion process of condensate gas in pores, fractures or vugs different from that in PVT cylinder. In order to study the mechanism of this difference, three different experimental models were made to carry out the condensate gas depletion production experiment. The results showed that the existence of fracture-vuggy porous media would affect the depletion production process. The pores, fractures and vugs increased the dew point pressure from 26.2 MPa to 26.6 MPa and decreased the condensate oil recovery from 72.8% to 70.7%. When the fractures, vugs and pores are filled with powered fine sand of carbonate rocks, the dew point pressure reaches 27.4 MPa and the condensate oil recovery reduces to 68.4%. The fractured-vuggy porous media will aggravate the retro condensation phenomenon, promote the accumulation of heavy hydrocarbon components on the pore surface and precipitate in the form of condensate oil and hinder the recovery of condensate oil. This work explains the mechanism of the influence of fractured-vuggy porous media on the phase behavior of condensate gas. [ABSTRACT FROM AUTHOR]

For the thick sandstone reservoir, due to gravity differentiation, water drive mainly uses the bottom oil of the reservoir, while gas drive mainly drives the oil along the top of the reservoir. Water-alternating gas (WAG) injection can effectively combine the advantages of water flooding and gas injection, so that gas and water can work in synergy, thus further expanding swept volume and enhancing oil recovery. Over the past half century, the technology has been successfully applied to more than 60 oilfields worldwide, but its mechanism remains to be further studied. In this paper, a total of three tests were conducted through conventional water-flooding (WF), water flooding followed by gas flooding and WAG in sand-packed 2d-model. These experimental processes are recorded by video with time so that the saturation distribution of each phase in porous media can be observed，migration law of gas and water is studied, and the mechanism of WAG displacement is analyzed. The results show that gravity and capillary force have great influence on the process of gas water alternation, thus increasing the overall swept volume of water and gas; The water/gas alternating injection has the highest oil recovery factor (RF) of 75.45% in test 3, in comparison with water flooding followed by gas flooding (70.85% in test 2) and water-flooding (66.7%in test 1); Increase in cycles of WAG tends to reduce residual oil saturation.

Attic karst cave is one of the most common fractured-vuggy structure in Tahe oilfield. In this study, a typical attic-shaped cave was extracted from the geological section of Tahe Oilfield. Under the guidance of similarity criteria, physical experiment models of attic karst cave reservoir filled with oil-wet and water-wet filling medium were designed and fabricated using coated resin sand and cemented quartz sand. Water flooding experiments at different injection rates were carried out using the attic karst cave model filled with filling medium of various wettability. The water flooding characteristics and distribution law of residual oil in the different models were determined by analyzing oil displacement performances and the dynamic production curves. Results showed that when the filling medium is water-wet, water injection rate has a trivial impact on the residual oil distribution pattern. While for the oil-wet media filled situations, the lower the injection rate, the lower the swept area. However, at high injection rates, the spread scope is large but the displacement efficiency remains relatively low. In addition, it was noted that the difference in the wettability of the filling medium caused a difference in the location of the residual oil. [ABSTRACT FROM AUTHOR]