Search

The paper describes load and resistance factor design (LRFD) calibration for the resistance factor used in the Stiffness Method internal stability soil failure limit state for geogrid mechanically stabilized earth (MSE) walls. The Stiffness Method was recently adopted in the current American Association of State Highway and Transportation Officials LRFD Bridge Design Specifications in the US, and will appear in the next edition of the Canadian Highway Bridge Design Code. The paper describes the details of the calibration of the soil failure limit state which is unique to the Stiffness Method. Calibration outcomes include consideration of the concept of level of understanding in the selection of nominal load and resistance values which is unique to LRFD foundation engineering practice in Canada. A practical conclusion from these calculations is that if product line-specific creep test data are available to estimate the reinforcement secant creep stiffness used for design, then a resistance factor of 1.0 is reasonable for US practice. If only minimum average roll value tensile strength data are available, then a value of 0.95 is recommended for US practice. For Canadian practice, the corresponding values for typical level of understanding are 0.90 and 0.85, respectively. [ABSTRACT FROM AUTHOR]

The paper demonstrates load and resistance factor design (LRFD) calibration for tensile strength and pullout strength limit states for steel strip mechanically stabilized earth (MSE) walls using a reliability theory-based approach. The analyses adopt load models found in current North American LRFD specifications in combination with a coupled mechanical-corrosion model for the reinforcement tensile strength and pullout models found in design guidelines and in the research literature. Resistance factors for prescribed load factors and different load and resistance model combinations are compiled in tables. The limitations of the LRFD approach to generate resistance factors that are judged to be acceptable based on current practice are demonstrated. The challenges to generate consistent design outcomes with the same margin of safety expressed probabilistically are identified, and the link to reliability-based design is described. Example designs are provided to show the impact on steel reinforcement quantities and length when using different models in combination with proposed and current specified load and resistance factors. The calibration outcomes will be of value to code writers in Canada and the US for MSE wall design sections in the next editions of national geotechnical foundation LRFD codes. [ABSTRACT FROM AUTHOR]