Search

The aim of this study was to compare the shaping ability of a modified ProTaper Next technique (PTNm) with that of TruNatomy (TN) in lower molars mesial curved canals using micro-computed tomography (Micro-CT). Sixty mesial canals of first mandibular molars were randomly assigned between two groups (n = 30). After canal scouting with K-File #10, glide path and shaping were carried out with TN or PTNm systems. The PTNm sequence consists of ProGlider, followed by ProTaper Next X1 and apical finishing with NiTiFlex #25 up to working length (WL) to ensure adequate apical cleaning. Samples were scanned using micro-CT and pre- and post-shaping volumes were matched to analyse geometric parameters: the volume of removed dentin; the difference of canal surface; centroid shift, minimum and maximum root canal diameters; cross-sectional areas; the ratio of diameter ratios (RDR) and the ratio of cross-sectional areas (RA). Measurements were assessed 2 mm from the apex and in relation to the middle and coronal root canal thirds. Data were analysed using ANOVA (p < 0.05). No statistically significant differences were found between the groups for any parameter at each level of analysis, except for RA at the coronal level (p = 0.037). The PTNm system showed the tendency to enlarge more in the coronal portion with a lower centroid shift at apical level compared with TN sequence (p > 0.05). Both PTNm and TN sequences demonstrated similar maintenance of original anatomy during the shaping of lower molar mesial curved canals. [ABSTRACT FROM AUTHOR]

To evaluate shear stress (SS) and normal pressure (NP) at the tooth-restoration interface of highly-filled flowable resin composite applied to deep margin elevation technique through FEM analysis generated by a microCT scan. A reference maxillary molar with two class II cavities was prepared according to deep margin elevation protocol. A geometrical model was segmented from a micro-CT scan generating separate volumes of enamel, dentin and restorative materials. The 3D Finite Element (FE) model was subsequently built-up and an axial chewing load was simulated. Data concerning the tooth-restoration interface were analyzed in terms of SS and NP. Different materials and techniques were tested in order to evaluate the effects of the restorative material, the usage of a highly-filled flowable composite as liner and the substrate of the cervical area. Both SS and NP presented similar distribution, but showed significant differences between tested materials. Composites showed more homogeneous behavior in stress distribution compared to ceramic. The use of a highly-filled flowable composite as liner on the cervical margin significantly reduced SS and NP on the cavity floor and the cervical margin area. Lastly, stress distribution in the cavity floor area varied according to the cervical margin substrate: enamel showed a protective role in stress distribution. Highly-filled flowable resin composites showed encouraging results when applied to deep margin elevation from an interfacial mechanical point of view. Further studies are needed to validate these data and to better define the role of cervical enamel in stress distribution. • Micro-CT can be used to create a realistic finite element model of the tooth-restoration complex. • Highly-filled flowable resin reduced shear and normal pressure stresses on the cavity floor. • Shear and normal pressure stresses presented similar distributions, being influenced by the different materials. • Resin-based materials showed a more homogeneous behavior in stress distribution compared to ceramic. [ABSTRACT FROM AUTHOR]