Search

The most common technology for the recovery of energy and valuable materials from sewage sludge is anaerobic digestion (AD). Ensuring thermophilic conditions during AD has been proven to cause process intensification and an improvement in its final outcomes. Nonetheless, the search is underway for other methods to bolster the effectiveness of the AD of aerobic granular sludge (AGS), which is characterized by a compact and complex structure. A prospective AGS pre-treatment technology entails the use of solidified carbon dioxide (SCO2). The present study focused on an evaluation of the AGS pre-treatment with SCO2 on the thermophilic AD technological effects. It evaluated the effect of the SCO2 pre-treatment method on changes in the concentrations of organic and biogenic compounds in the dissolved phase and the yield and kinetics of biogas and methane production in periodical reactors, as well as enabled the development of an empirical organizational model of biogas production. SCO2 introduced to AGS caused an increase in the content of COD, N-NH4+, and P-PO43− in the AGS dissolved phase at SCO2/AGS volumetric ratios ranging from 0 to 0.3. A further increase in the SCO2 dose did not cause any statistically significant differences in this respect. The highest biogas and methane yields were obtained at SCO2/AGS of 0.3 and reached 482 ± 21 cm3/gVS and 337 ± 14 cm3/gVS, respectively. The higher SCO2 doses used led to a significant decrease in the pH value of the AGS, which, in turn, contributed to a decreasing CH4 concentration in the biogas. [ABSTRACT FROM AUTHOR]

Though deemed a prospective method, the bioconversion of organic waste to biohydrogen via dark fermentation (DF) has multiple drawbacks and limitations. Technological difficulties of hydrogen fermentation may, in part, be eliminated by making DF a viable method for biohythane production. Aerobic granular sludge (AGS) is a little-known organic waste spurring a growing interest in the municipal sector; its characteristics indicate the feasibility of its use as a substrate for biohydrogen production. The major goal of the present study was to determine the effect of AGS pretreatment with solidified carbon dioxide (SCO2) on the yield of H2 (biohythane) production during anaerobic digestion (AD). It was found that an increasing dose of SCO2 caused an increase in concentrations of COD, N-NH4+, and P-PO43− in the supernatant at the SCO2/AGS volume ratios from 0 to 0.3. The AGS pretreatment at SCO2/AGS ratios within the range of 0.1–0.3 was shown to enable the production of biogas with over 8% H2 (biohythane) content. The highest yield of biohythane production, reaching 481 ± 23 cm3/gVS, was obtained at the SCO2/AGS ratio of 0.3. This variant produced 79.0 ± 6% CH4 and 8.9 ± 2% H2. The higher SCO2 doses applied caused a significant decrease in the pH value of AGS, modifying the anaerobic bacterial community to the extent that diminished anaerobic digestion performance. [ABSTRACT FROM AUTHOR]

Studies on harnessing solidified carbon dioxide (SCO2) for municipal sewage sludge (MSS) pre-treatment have been conducted exclusively in batch reactors. This makes it difficult to accurately assess how long-term SCO2 treatment affects anaerobic digestion (AD) conditions and performance. The aim of our study was to evaluate the effect of long-term MSS pre-treatment with SCO2 on AD conditions, anaerobic bacterial community, and biogas composition and yields. The presented experiments are the first studies on the effect of pre-treatment with SCO2 on the efficiency of AD of MSS in continuous reactors. So far, the impact of the organic load rate (OLR) on the efficiency of MSS methane fermentation has not been assessed, which is also a novelty of the conducted research. The AD process was conducted in continuous-stirred, continuous-flow anaerobic with an active volume of 20 dm3. The digestion process was run at 38 ± 1 °C. The experiment was divided into two stages. Raw (non-pretreated) MSS was used in stage 1, whereas the MSS used in stage 2 was pre-treated with SCO2. The SCO2/MSS ratio was 1:3. Each stage was sub-divided into four variants, with different levels of the OLR ranging from 2.0 to 5.0 gCOD/dm3·day. Pre-treatment with SCO2 was found to improve AD performance at an OLR of 3.0–4.0 gVS/dm3·day. The 3.0 gVS/dm3·day variant offered the best biogas production performance—both daily (29 ± 1.3 dm3/day) and per VS added (0.49 ± 0.02 dm3/gVS)—as well as the highest CH4 content in the biogas (70.1 ± 1.0%). In this variant, the highest energy output effect of 187.07 ± 1.5 Wh/day was obtained. The SCO2 pre-treatment was not found to change the pH, FOS/TAC, or the anaerobic bacterial community composition. Instead, these variables were mainly affected by the OLR. Our study shows that MSS pre-treatment with SCO2 at a SCO2/MSS ratio of 0.3 (by volume) significantly improves AD performance in terms of methane production and feedstock mineralization. The pre-treatment was found to have no negative effect on the long-term continuous operation of the reactor. [ABSTRACT FROM AUTHOR]

Appropriate management is necessary to mitigate the environmental impacts of wastewater sludge. One lesser-known technology concerns the use of solidified CO2 for dewatering, sanitization, and digestion improvement. Solidified CO2 is a normal byproduct of natural gas treatment processes and can also be produced by dedicated biogas upgrading technologies. The way solidified CO2 is sourced is fully in line with the principles of the circular economy and carbon dioxide mitigation. The aim of this review is to summarize the current state of knowledge on the production and application of solid CO2 in the pretreatment and management of sewage sludge. Using solidified CO2 for sludge conditioning causes effective lysis of microbial cells, which destroys activated sludge flocs, promotes biomass fragmentation, facilitates efficient dispersion of molecular associations, modifies cell morphology, and denatures macromolecules. Solidified CO2 can be used as an attractive tool to sanitize and dewater sludge and as a pretreatment technology to improve methane digestion and fermentative hydrogen production. Furthermore, it can also be incorporated into a closed CO2 cycle of biogas production–biogas upgrading–solidified CO2 production–sludge disintegration–digestion–biogas production. This feature not only bolsters the technology's capacity to improve the performance and cost-effectiveness of digestion processes, but can also help reduce atmospheric CO2 emissions, a crucial advantage in terms of environment protection. This new approach to solidified CO2 generation and application largely counteracts previous limitations, which are mainly related to the low cost-effectiveness of the production process. [ABSTRACT FROM AUTHOR]