Search

The conventional technique for positioning seafloor geophones in ocean bottom seismic exploration encounters several challenges, including the significant impact of outliers on positioning results, underutilization of high-precision observations, and low efficiency in real-time data processing. These issues inevitably affect the quality of seismic exploration outcomes. To address these challenges and enhance the accuracy of geophone positioning, this paper proposes a rigorous real-time acoustic positioning method for geophones based on sequential adjustment and Baarda's outlier detection approach. The proposed method comprises three key steps: grouping the original acoustic observations, constructing the intra-group acoustic positioning model, and synthesizing the positioning results across the different groups. The validity and practicality of this approach are confirmed through a simulation experiment as well as the field experiment conducted in the Bohai Sea, China. The results demonstrate that the proposed method effectively eliminates outliers in the original observations and maximizes the utilization of high-quality observations. Compared to traditional acoustic positioning methods, it significantly reduces positioning errors from meters to decimeters, and in some cases can achieve centimeter-level precision. When the sound velocity profile in the operating sea area is measured, the method can attain the posterior standard deviation at the millimeter level and positioning errors within 10 cm. When the sound velocity profile is unknown, the method can achieve the posterior standard deviation at centimeter-level and positioning errors of approximately 20 cm. [ABSTRACT FROM AUTHOR]

Sub-bottom sediment classifications have been widely used in marine science and engineering to obtain high-resolution information on types of sediments; however, these are often plagued by inaccuracies. Classification difficulties arise from the inability to effectively filter multiple reflections, extract representative lithology characteristic parameters, identify sub-bottom layer interfaces, extract image samples, control sample quality, optimise characteristic parameters, etc. To generate a highly accurate sub-bottom profile sediment map, a five-step classification method that considers two key lithology characteristic parameters of sub-bottom profile acoustic data was proposed. First, multiple reflections were filtered from the sea surface and sub-bottom layer interfaces of the primary signal. Second, two key characteristic parameters (relative backscattering intensity difference and attenuation compensation residual) were calculated. These reflect the relative differences in backscattering intensity and the attenuation compensation between adjacent interfaces based on the sound intensity attenuation model of a sub-bottom profile. Third, a combined method based on the sediment quality factor and peak trough of the echo signal loss level curve was employed to identify the actual interfaces between layers. An additional technique was proposed to determine the image sample width and preferred characteristic parameters. The resulting high-quality image samples and preferred characteristic parameters not only resulted in a faster convergence rate and increased ability of self-aggregation and identification, but also ensured that the training results met the convergence accuracy requirement. Ultimately, the preferred image samples were trained to classify the overall sub-bottom map of a selected test area of approximately 36 km2 in Bahai Bay, China. Compared with traditional methods, a considerably higher sediment identification accuracy was obtained. The experimental results indicate that the contribution rate of the two key lithology characteristic parameters was 65.49% according to principal component analysis, and the internal and external compatibilities were 97.98% and 84.76% for the training image samples, respectively. The total identification accuracy for the sub-bottom profile map was 98.2%. The two key characteristic parameters accurately captured the acoustic characteristics of sub-bottom sediments, significantly improving sediment classification. These results show that this method could be used to help refine the distributional estimates of submarine mineral resources. • A combined filtering method using predictive deconvolution and iterative feedback was proposed. • Two key parameters were derived from sound intensity attenuation model of sub-bottom profile. • Sample width selection and characteristic parameter preferred-selection method were proposed. • Experimental result indicated that identification accuracy for sub-bottom profile map was 98.2%. [ABSTRACT FROM AUTHOR]