Search

The technology of aerobic granular sludge (AGS) seems prospective in wastewater bio-treatment. The characteristics as well as compactness and structure of AGS have been proved to significantly affect the effectiveness of thus far deployed methods for sewage sludge processing, including anaerobic digestion (AD). Therefore, it is deemed necessary to extend knowledge on the possibilities of efficient AGS management and to seek viable technological solutions for methane fermentation of sludge of this type, including by means of using the pre-treatment step. Little is known about the pre-treatment method with solidified carbon dioxide (SCO 2 ), which can be recovered in processes of biogas upgrading and enrichment, leading to biomethane production. This study aimed to determine the impact of AGS pre-treatment with SCO 2 on the efficiency of its AD. An energy balance and a simplified economic analysis of the process were also carried out. It was found that an increasing dose of SCO 2 applied in the pre-treatment increased the concentrations of COD, N-NH 4 + , and P-PO 4 3- in the supernatant in the range of the SCO 2 /AGS volume ratios from 0.0 to 0.3. No statistically significant differences were noted above the latter value. The highest unit yields of biogas and methane production, reaching 476 ± 20 cm 3 /gVS and 341 ± 13 cm 3 /gVS, respectively, were obtained in the variant with the SCO 2 /AGS ratio of 0.3. This experimental variant also produced the highest positive net energy gain, reaching 1047.85 ± 20 kWh/ton total solids (TS). The use of the higher than 0.3 SCO 2 doses was proved to significantly reduce the pH of AGS (below 6.5), thereby directly diminishing the percentage of methanogenic bacteria in the anaerobic bacterial community, which in turn contributed to a reduced CH 4 fraction in the biogas.

Appropriate management is necessary to mitigate the environmental impacts of wastewater sludge. One lesser-known technology concerns the use of solidified CO 2 for dewatering, sanitization, and digestion improvement. Solidified CO 2 is a normal byproduct of natural gas treatment processes and can also be produced by dedicated biogas upgrading technologies. The way solidified CO 2 is sourced is fully in line with the principles of the circular economy and carbon dioxide mitigation. The aim of this review is to summarize the current state of knowledge on the production and application of solid CO 2 in the pretreatment and management of sewage sludge. Using solidified CO 2 for sludge conditioning causes effective lysis of microbial cells, which destroys activated sludge flocs, promotes biomass fragmentation, facilitates efficient dispersion of molecular associations, modifies cell morphology, and denatures macromolecules. Solidified CO 2 can be used as an attractive tool to sanitize and dewater sludge and as a pretreatment technology to improve methane digestion and fermentative hydrogen production. Furthermore, it can also be incorporated into a closed CO 2 cycle of biogas production-biogas upgrading-solidified CO 2 production-sludge disintegration-digestion-biogas production. This feature not only bolsters the technology's capacity to improve the performance and cost-effectiveness of digestion processes, but can also help reduce atmospheric CO 2 emissions, a crucial advantage in terms of environment protection. This new approach to solidified CO 2 generation and application largely counteracts previous limitations, which are mainly related to the low cost-effectiveness of the production process., Competing Interests: The authors declare no conflict of interest.

Background: Carbon dioxide (CO2) is the major contributor to the global emissions of greenhouse gases, which necessitates the search for its fixation and utilization methods. Engaging photosynthesizing microorganisms for its biosequestration is one of the prospective technologies applied to this end. Considering the paucity of literature works on the possibilities of deploying CO2 from biogas combustion to intensify microalgae production, this research aimed to identify the feasibility of using this type of CO2 in Chlorella vulgaris culture by evaluating biomass production yield and CO2 biosequestration effectiveness., Methods: The experiment was performed in glass PBR, in which the culture medium occupied the volume of 1.0 dm3, and the gaseous phase occupied 0.3 dm3. The reactors were continuously illuminated by fluorescent lamps. The temperature of flue gases and air fed to reactors, and culture temperature was 20 °C ± 2 °C., Results: The use of flue gases promoted a more rapid biomass growth, reaching 77.8 ± 3.1 mgVS/dm3⋅d, and produced a higher microalgae concentration, i.e., 780 ± 58 mgVS/dm3. Nevertheless, the flue gas-fed culture turned out to be highly sensitive, which was manifested in a decreased culture medium pH and relatively quickly achieved decay phase of the C. vulgaris population. The microalgae effectively assimilated CO2, reducing its concentration from 13 ± 1% to 1 ± 0.5% in the effluent from the photobioreactor., Conclusions: The flue gases were found not to affect the qualitative composition of the microalgal biomass. However, strict control and monitoring of microalgae biomass production is necessary, as well as rapid responses in flue gas-fed systems. This is an important hint for potential operators of such technological systems on the large scale. Regardless of the possibility of deploying microalgae to fix and utilize CO2, a justified avenue of research is to look for cheap sources of CO2-rich gases., Competing Interests: The authors declare no conflict of interest., (© 2023 The Author(s). Published by IMR Press.)

The increased concentration of CO2 in the atmosphere has a strong impact on global warming. Therefore, efficient technologies must be used to reduce CO2 emissions. One of the methods is the biofixation of CO2 by microalgae and cyanobacteria. This is now a widely described technology that can improve the economics of biomass production and reduce CO2 emissions. There are no reports on the possibility of using it to clean exhaust gases from biogas combustion. The aim of the research was to determine the possibility of using Arthrospira platensis cultures to remove CO2 from biogas combustion. The efficiency of biomass production and the effectiveness of biological CO2 fixation were evaluated. The use of exhaust gases led to a more efficient increase in cyanobacterial biomass. The growth rate in the exponential phase was 209 ± 17 mgVS/L·day, allowing a biomass concentration of 2040 ± 49 mgVS/L. However, the use of exhaust gases led to a decrease in the pH of the culture medium and a rapid decline in the Arthrospira platensis population. The cyanobacteria effectively fixed CO2, and its concentration was limited from 13 ± 1% to 1.3 ± 0.7%. There was no influence of the exhaust gases on changes in the qualitative composition of the cyanobacterial biomass. In the culture fed with exhaust gas, the A. platensis population quickly entered the death phase, which requires close monitoring. This is an important indication for potential operators of large-scale photobioreactors. [ABSTRACT FROM AUTHOR]

The most common technology for the recovery of energy and valuable materials from sewage sludge is anaerobic digestion (AD). Ensuring thermophilic conditions during AD has been proven to cause process intensification and an improvement in its final outcomes. Nonetheless, the search is underway for other methods to bolster the effectiveness of the AD of aerobic granular sludge (AGS), which is characterized by a compact and complex structure. A prospective AGS pre-treatment technology entails the use of solidified carbon dioxide (SCO2). The present study focused on an evaluation of the AGS pre-treatment with SCO2 on the thermophilic AD technological effects. It evaluated the effect of the SCO2 pre-treatment method on changes in the concentrations of organic and biogenic compounds in the dissolved phase and the yield and kinetics of biogas and methane production in periodical reactors, as well as enabled the development of an empirical organizational model of biogas production. SCO2 introduced to AGS caused an increase in the content of COD, N-NH4+, and P-PO43− in the AGS dissolved phase at SCO2/AGS volumetric ratios ranging from 0 to 0.3. A further increase in the SCO2 dose did not cause any statistically significant differences in this respect. The highest biogas and methane yields were obtained at SCO2/AGS of 0.3 and reached 482 ± 21 cm3/gVS and 337 ± 14 cm3/gVS, respectively. The higher SCO2 doses used led to a significant decrease in the pH value of the AGS, which, in turn, contributed to a decreasing CH4 concentration in the biogas. [ABSTRACT FROM AUTHOR]

Though deemed a prospective method, the bioconversion of organic waste to biohydrogen via dark fermentation (DF) has multiple drawbacks and limitations. Technological difficulties of hydrogen fermentation may, in part, be eliminated by making DF a viable method for biohythane production. Aerobic granular sludge (AGS) is a little-known organic waste spurring a growing interest in the municipal sector; its characteristics indicate the feasibility of its use as a substrate for biohydrogen production. The major goal of the present study was to determine the effect of AGS pretreatment with solidified carbon dioxide (SCO2) on the yield of H2 (biohythane) production during anaerobic digestion (AD). It was found that an increasing dose of SCO2 caused an increase in concentrations of COD, N-NH4+, and P-PO43− in the supernatant at the SCO2/AGS volume ratios from 0 to 0.3. The AGS pretreatment at SCO2/AGS ratios within the range of 0.1–0.3 was shown to enable the production of biogas with over 8% H2 (biohythane) content. The highest yield of biohythane production, reaching 481 ± 23 cm3/gVS, was obtained at the SCO2/AGS ratio of 0.3. This variant produced 79.0 ± 6% CH4 and 8.9 ± 2% H2. The higher SCO2 doses applied caused a significant decrease in the pH value of AGS, modifying the anaerobic bacterial community to the extent that diminished anaerobic digestion performance. [ABSTRACT FROM AUTHOR]

Studies on harnessing solidified carbon dioxide (SCO2) for municipal sewage sludge (MSS) pre-treatment have been conducted exclusively in batch reactors. This makes it difficult to accurately assess how long-term SCO2 treatment affects anaerobic digestion (AD) conditions and performance. The aim of our study was to evaluate the effect of long-term MSS pre-treatment with SCO2 on AD conditions, anaerobic bacterial community, and biogas composition and yields. The presented experiments are the first studies on the effect of pre-treatment with SCO2 on the efficiency of AD of MSS in continuous reactors. So far, the impact of the organic load rate (OLR) on the efficiency of MSS methane fermentation has not been assessed, which is also a novelty of the conducted research. The AD process was conducted in continuous-stirred, continuous-flow anaerobic with an active volume of 20 dm3. The digestion process was run at 38 ± 1 °C. The experiment was divided into two stages. Raw (non-pretreated) MSS was used in stage 1, whereas the MSS used in stage 2 was pre-treated with SCO2. The SCO2/MSS ratio was 1:3. Each stage was sub-divided into four variants, with different levels of the OLR ranging from 2.0 to 5.0 gCOD/dm3·day. Pre-treatment with SCO2 was found to improve AD performance at an OLR of 3.0–4.0 gVS/dm3·day. The 3.0 gVS/dm3·day variant offered the best biogas production performance—both daily (29 ± 1.3 dm3/day) and per VS added (0.49 ± 0.02 dm3/gVS)—as well as the highest CH4 content in the biogas (70.1 ± 1.0%). In this variant, the highest energy output effect of 187.07 ± 1.5 Wh/day was obtained. The SCO2 pre-treatment was not found to change the pH, FOS/TAC, or the anaerobic bacterial community composition. Instead, these variables were mainly affected by the OLR. Our study shows that MSS pre-treatment with SCO2 at a SCO2/MSS ratio of 0.3 (by volume) significantly improves AD performance in terms of methane production and feedstock mineralization. The pre-treatment was found to have no negative effect on the long-term continuous operation of the reactor. [ABSTRACT FROM AUTHOR]

The increasing concentration of anthropogenic CO2 in the atmosphere is causing a global environmental crisis, forcing significant reductions in emissions. Among the existing CO2 capture technologies, microalgae-guided sequestration is seen as one of the more promising and sustainable solutions. The present review article compares CO2 emissions in the EU with other global economies, and outlines EU's climate policy together with current and proposed EU climate regulations. Furthermore, it summarizes the current state of knowledge on controlled microalgal cultures, indicates the importance of CO2 phycoremediation methods, and assesses the importance of microalgae-based systems for long-term storage and utilization of CO2. It also outlines how far microalgae technologies within the EU have developed on the quantitative and technological levels, together with prospects for future development. The literature overview has shown that large-scale take-up of technological solutions for the production and use of microalgal biomass is hampered by economic, technological, and legal barriers. Unsuitable climate conditions are an additional impediment, forcing operators to implement technologies that maintain appropriate temperature and lighting conditions in photobioreactors, considerably driving up the associated investment and operational costs. [ABSTRACT FROM AUTHOR]