Search

The discharge current waveform affects the processing characteristics and surface integrity by affecting the process of energy input. At present, although the rectangular current waveform is widely used in electrical discharge machining (EDM), there is not enough evidence to prove that it is the most suitable. Therefore, in this study, the influence of the discharge current waveforms on processing characteristics and surface integrity was investigated and compared under similar pulse energy. Three types of discharge current waveforms including rectangular (Rec), triangular (Tri), and trapezoidal (Tra) are used for processing. The material removal amount, surface topography, roughness, phase compositions, white layer thickness, and residual stress were investigated and analyzed. The results showed that Tri could remove the most materials per pulse-on duration, followed by Tra. Compared with Rec, the size of craters and debris on the sample surface produced by the Tri and Tra was larger. The surface roughness and residual stress of samples processed by Tri were the highest. When the discharge current waveform was constant, XRD spectra of samples fabricated by EDM under different pulse energy were almost the same. Compared with Rec, the diffraction peaks of samples produced by Tri and Tra were reduced. When the pulse energy was low, the white layer of samples processed by Rec was thinner than that processed by Tri. This phenomenon was reversed when the pulse energy was high. The white layer thickness of the sample fabricated by Tra was between the samples processed by Rec and Tri regardless of pulse energy. [ABSTRACT FROM AUTHOR]

The influences of electrical and non-electrical parameters on surface integrity during the EDM process have been widely researched in past years. However, the effect of the energy input process at the same discharge energy is seldom reported. To select more suitable processing parameters according to the processing requirements, we have studied the influence of the energy input process on processing characteristics and surface properties. Two different energy input modes (high discharge current with short pule-on time (HIST) and low discharge current with long pule-on time (LILT)) are used. When the discharge energy is the same, the HIST mode has a higher material removal amount, while the sample produced by the LILT mode presents a lower surface roughness and residual stress. More surface cracks are detected on the samples processed by the LILT mode, and their dimensions in terms of length and width are greater than that of the HIST mode. The microstructure of the EDM surface is composed of α-Fe, γ-Fe, and cementite. When the discharge energy is higher than 0.24 mJ, the intensities of diffraction peaks γ-Fe and cementite on the EDM workpiece surface produced by the HIST mode are higher. The white layer thickness is related to the discharge energy and its input process. When the discharge energy is lower than 0.51 mJ, the white layer is thinner under the LILT mode. However, the white layer of the EDM sample fabricated by the HIST mode is thinner when the discharge energy is higher than 0.51 mJ. [ABSTRACT FROM AUTHOR]