Search

A new method for capacity and spectral efficiency increases is a full-duplex communication, where sending and receiving are done simultaneously. Hence, severe interference leaked from the transmitter to the receiver, which can disrupt the system's operation completely. For interference reduction, the transceiver tries to estimate the interfering symbols to remove their effects. A typical method is to use the Hammerstein model. In this method, nonlinear power amplifier (PA) and multipath channel are modeled with a successive nonlinear system and a finite impulse response filter. Then, the model parameters are adjusted, and interference symbols are estimated from the transmitted symbols. In the Hammerstein method, the interference symbols are estimated directly from the transmitted symbols. But practically, the transmitted symbols first pass through the pulse-shaping filter and become a signal. Then, this signal passes through the nonlinear PA and communication channel. Finally, the received signal is filtered by the matched filter (MF) at the receiver and converted to the symbols again. In this procedure, the amplifier and the communication channel affect the transmitted signal directly and distort transmitted symbols indirectly. Therefore, in the practical situation, when we consider the transmitter's pulse-shaping filter and the receiver's MF, the estimated symbols with the Hammerstein method are erroneous. To solve this problem, a new MF at the receiver is proposed and adjusted according to the interfering signal. We have shown that this method is far better than the Hammerstein method. [ABSTRACT FROM AUTHOR]

Continuous-variable quantum key distribution (CV-QKD) provides a theoretical unconditionally secure solution to distribute symmetric keys among users in a communication network. However, the practical devices used to implement these systems are intrinsically imperfect, and, as a result, open the door to eavesdropper attacks. In this work, we study the impact of transmitter stage imperfections on the performance and security of a Discrete Modulated (DM) CV-QKD system using M-symbol Quadrature Amplitude Modulation (M-QAM) and Amplitude and Phase Shift Keying (M-APSK) coupled with Probabilistic Constellation Shaping (PCS). Assuming two different modulation stage topologies, we first deform the constellations and then evaluate the secure key rate achievable with the deformed constellation. The presented results show that, due to the erroneously estimated channel parameters, non-monitored imbalances greatly reduce the system's performance, with situations where Bob and Alice estimate that no secure bits can be obtained while the real value of the key rate is still positive. Our results show the importance of monitoring these constellation imbalances and show that the optimal constellation may vary depending on the degree of device imperfection. [ABSTRACT FROM AUTHOR]

We consider a dual function radar communications network and propose a waveform diversity-based approach to embed both target and scheduling data in the transmitter pulses. The scheduling data of radar signal bandwidth, carrier frequency, and waveform along with the information on target detection, range, and Doppler are shared among the network radar nodes without a need for designated communication links. Scheduling and target information are encoded to bits and transmitted over the radar coherent processing interval using up- and down-chirps. We derive exact expressions of probability of bit error and false alarm rate for sharing scheduling and target information data between two radar nodes. The effect of different parameters and data sharing on the radar performance is analyzed and validated by computer simulations. Using the cross-ambiguity function, we show the capability of the up- and down- chirp sequence transmission scheme in reducing range sidelobes compared to the conventional transmission of only the up- (or down-) chirps. To overcome the limited data rate associated with only using two chirp waveforms, we consider orthogonal chirp division multiplexing and derive its CAF. We demonstrate the suitability of OCDM for high data rate radar operations by examining the mainlobe width and sidelobe levels of the zero-Doppler and zero-delay cuts of the CAF. [ABSTRACT FROM AUTHOR]

Underwater visible light communication emerges as a promising technique to enhance the capacity of underwater wireless communication networks for upcoming generation. Major technical problem with underwater visible light communication systems in motion is the pointing, acquisition, and tracking. To ease pointing, acquisition, and tracking, hence it is important to navigate optical information beam over broad range and adjust the transmitter beam divergence angle according to the link condition, which is adjusted by the Optisystem software. In this paper, performance comparison among wide range of transmittance optical beams in underwater visible light communications system for high-speed communication is presented for PIN as well as for Avalanche photodiode. The effect of using variable transmittance beam-divergence angle on the bit-error rate, signal-to-noise ratio, communication link distance is also investigated. OptiSystem and MATLAB software is used to implement the underwater visible light communication transceiver system. Finally, it is shown in the paper that in the presence of pointing errors, adaptive beam control techniques improve the performance of high-speed Underwater visible light communication system. [ABSTRACT FROM AUTHOR]

In this paper, we propose a signal processing method in passive radar using the multi-user (MU) multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) signal as the illuminator of opportunity. The MU-MIMO-OFDM modulation is adopted in the fifth-generation (5G) communication. We consider the scenario where multiple mobile users share the same time–frequency resources but separate spatially in different beams formed a prior by the MU-MIMO transmitter antenna array, which is a quite general case in realistic 5G communication. A beam-by-beam matched filter is proposed for weak target sensing. Interference suppression is also discussed. The interference in this scenario is more complicated than that in the traditional passive radar. In the MU-MIMO communication system, the base station (BS) transmits multiple signals to different beam regions simultaneously for the communication between the BS and mobile users. For a specific beam region where the radar receiver is located, the interference consists of not only the direct and multipath interference (DMI) of the signal transmitted by the BS to this beam region, but also the inter-user interference (IUI) from the other beam regions. The DMI and IUI degrade the weak target detection capability significantly. In this paper, we propose a suppression method for jointly eliminating the DMI and IUI. Simulations verify the effectiveness of these methods. [ABSTRACT FROM AUTHOR]

Free space optics (FSO) communication is a very recent mechanism. It is mainly needed when physical connection between the transmitter and the receiver is practically impossible and when high bandwidth data transmission is expected. This paper walks through the investigation of the performance of FSO communication adopting spectral amplitude coding optical code division multiple access (SAC-OCDMA) systems at different weather scenarios. The suggested system uses enhanced double weight codes as signature codes by 3 clients, simultaneously. To eliminate multiple access interference and phase induced intensity noise, two different detection schemes are used; single photodiode (SPD) and modified-AND subtraction detection schemes. Furthermore, a comparison between PIN and APD detectors is performed. The performance is evaluated through its propagation distance, received power, Q-factor and bit error rate (BER). The obtained numerical results reveal both Q-factor and BER are modified by 30%. Accordingly, the system performance is enhanced by 30%, when using SAC-OCDMA-FSO with SPD detection technique compared with modified-AND subtraction technique. [ABSTRACT FROM AUTHOR]

The implementation of beamforming schemes on the base station side has been widely employed in recent communication networks. Thanks to the small size of microstrip antenna elements in millimeter-wave (mmWave) frequencies, the implementation of uplink beamforming in small-size user equipments (UEs) is now available and recently becoming popular. The practical implementation of beamforming on the UE side is limited by a variety of challenges and bottlenecks, of which the most significant are the hardware and software complexity as well as power consumption, and hence the low-complexity beamsteering techniques such as analog beamsteering is generally preferred to other schemes on the UE side. In this paper, we consider a mmWave D2D underlaid cellular network, wherein D2D UEs are equipped with low-complexity beamsteering capable antennas. The problem is then formally defined as to find the channel scheduling together with assigning optimal directivity angle and transmit powers of D2D UEs corresponding to the maximum throughput of D2D network. We will employ novel distributed solution approach based on generalized benders decomposition scheme. More specifically, we manage to obtain the closed-form solutions of the primal and master subproblems through which the optimal solution variables can be obtained in a low-complexity distributed scheme. [ABSTRACT FROM AUTHOR]