Search

Ultrathin sheets of two-dimensional (2D) materials like transition metal dichalcogenides have attracted strong attention as components of high-performance light-harvesting devices. Here, we report the implementation of Schottky junction-based photovoltaic devices through site-selective surface doping of few-layer WSe2 in lateral contact configuration. Specifically, whereas the drain region is covered by a strong molecular p-type dopant (NDP-9) to achieve an Ohmic contact, the source region is coated with an Al2O3 layer, which causes local n-type doping and correspondingly an increase of the Schottky barrier at the contact. By scanning photocurrent microscopy using green laser light, it could be confirmed that photocurent generation is restricted to the region around the source contact. The local photoinduced charge separation is associated with a photoresponsivity of up to 20 mA W–1 and an external quantum efficiency of up to 1.3%. The demonstrated device concept should be easily transferrable to other va...

Chemical doping has been investigated as an alternative method of conventional ion implantation for two-dimensional materials. We herein report chemically doped multilayer molybdenum disulfide (MoS2) field effect transistors (FETs) through n-type channel doping, wherein triethanolamine (TEOA) is used as an n-type dopant. As a result of the TEOA doping process, the electrical performances of multilayer MoS2 FETs were enhanced at room temperature. Extracted field effect mobility was estimated to be ∼30 cm2 V−1 s−1 after the surface doping process, which is 10 times higher than that of the pristine device. Subthreshold swing and contact resistance were also improved after the TEOA doping process. The enhancement of the subthreshold swing was demonstrated by using an independent FET model. Furthermore, we found that the doping level can be effectively controlled by the heat treatment method. These results demonstrate a promising material system that is easily controlled with high performance, while elucidating the underlying mechanism of improved electrical properties by the doping effect in a multilayered scheme.

Doping effects in devices based on two-dimensional (2D) materials have been widely studied. However, detailed analysis and the mechanism of the doping effect caused by encapsulation layers has not been sufficiently explored. In this work, we present experimental studies on the n-doping effect in WSe

International audience; Two-dimensional materials have outstanding scalability due to their structural and electrical properties for the logic devices. Here, we report the current fluctuation in multilayer WSe2 field effect transistors (FETs). In order to demonstrate the impact on carrier types, n-type and p-type WSe2 FETs are fabricated with different work function metals. Each device has similar electrical characteristics except for the threshold voltage. In the low frequency noise analysis, drain current power spectral density (SI) is inversely proportional to frequency, indicating typical 1/f noise behaviors. The curves of the normalized drain current power spectral density (NSI) as a function of drain current at the 10 Hz of frequency indicate that our devices follow the carrier number fluctuation with correlated mobility fluctuation model. This means that current fluctuation depends on the trapping-detrapping motion of the charge carriers near the channel interface. No significant difference is observed in the current fluctuation according to the charge carrier type, electrons and holes that occurred in the junction and channel region.

We report that noise level was reduced by passivating WSe2 field effect transistors (FETs) with high-k dielectric material. Low frequency noise and I-V characteristics of the device were measured from WSe2 FETs before and after the passivation with ZrO2 to confirm the effect of passivation by high-k dielectric material. As a result, there was no significant change in the I–V characteristics. In the low frequency noise analysis, our device showed 1/f noise behaviors, in agreement with the carrier number fluctuation (CNF) model. The passivation process contributed to the reduction of trap sites at the top surface, leading to the decrease of noise level at the low current regime. Extracted volume trap densities were reduced from 2.0 × 1020 cm−3eV−1 to 8.7 × 1019 cm−3eV−1.

Doping effects in devices based on two-dimensional (2D) materials have been widely studied. However, detailed analysis and the mechanism of the doping effect caused by encapsulation layers has not been sufficiently explored. In this work, we present experimental studies on the n-doping effect in WSe2 field effect transistors (FETs) with a high-k encapsulation layer (Al2O3) grown by atomic layer deposition. In addition, we demonstrate the mechanism and origin of the doping effect. After encapsulation of the Al2O3 layer, the threshold voltage of the WSe2 FET negatively shifted with the increase of the on-current. The capacitance-voltage measurements of the metal insulator semiconductor (MIS) structure proved the presence of the positive fixed charges within the Al2O3 layer. The flat-band voltage of the MIS structure of Au/Al2O3/SiO2/Si was shifted toward the negative direction on account of the positive fixed charges in the Al2O3 layer. Our results clearly revealed that the fixed charges in the Al2O3 encapsulation layer modulated the Fermi energy level via the field effect. Moreover, these results possibly provide fundamental ideas and guidelines to design 2D materials FETs with high-performance and reliability.