Search

In order to study the influence of wind direction on fire spread on building facades, a three-dimensional model of a high-rise building was built with PyroSim software. Numerical simulations were conducted with five wind directions (0°, 45°, 90°, 135° and 180°) and a reference wind speed of 3 m/s. The results show that the fire spread on the building facade was most significant on the leeward side, followed by the upwind condition. The horizontal spread of fire was promoted by crosswinds at 45°, 90° and 135°, while its vertical spread was inhibited. Among these, the inhibitory effect of the 45° crosswind was the greatest. The fire spread area under the leeward condition was the greatest at approximately 341.3 m2, accounting for 17.1% of the facade, and the vertical spread velocity under the condition of no wind was the fastest at 0.075 m/s. In this study, the motion characteristics of facade fire spread under different wind directions were determined, providing supporting evidence to enhance fire safety prevention and control measures in high-rise buildings. [ABSTRACT FROM AUTHOR]

Fire accidents due to oil-immersed transformers seriously threaten the safe operation of power systems. In this paper, the similarity principle was used to design a high-pressure water mist fire-extinguishing test platform for a small-scale transformer fire, and the design method achieved a good fire extinguishing effect. The results indicate that a deflagration phenomenon, lasting about 2–4 s, could be observed after activating the high-pressure water mist system; the flame temperature rose rapidly at first, then dropped sharply, and finally cooled to the indoor temperature. The nozzle's flow rate in this system has a significant impact on the fire extinguishing time. Meanwhile, the adjustment of the upper nozzle height also influenced the fire suppression effectiveness of the system, where a height of 1800 mm achieved the best performance compared to the others. In addition, the ambient wind speed is a very unfavorable factor for transformer fire suppression, where the fire extinguishing efficiency decreases rapidly with the increase in wind speed. Therefore, under low wind speed conditions, the high-pressure water mist system has great advantages in the fire suppression of outdoor oil-immersed transformers, and the above research results can provide a reference for the optimization design of this system. [ABSTRACT FROM AUTHOR]

In order to cope with limited land availability and the increasing urban population, more high-rise buildings are being built throughout cities, but this has also led to new challenges in the emergency evacuation of people. Therefore, we conducted an evacuation experiment of a group of people in the stairwells of high-rise buildings to explore the movement law of groups in stairwells. The experiment had 18 scenes, including the evacuation movement of an independent group and the crowd evacuation movement of different groups. Analyzing the independent groups' movement showed that regardless of the type of group, the average speed of the crowd was more than 1.2 m/s, which was longer than that of previous studies. The more constraints in the evacuation process, the smaller the speed difference between males and females. Group cohesion was mostly concentrated at about 1 s. Moreover, group velocity and cohesion were found to have no significant correlation in stairwell movement. Analyzing the crowd evacuation time of eight different scenes showed that it took longer for crowds bearing weight to evacuate than those not bearing weight. According to the spatiotemporal evolution of crowd evacuation in stairwells, the crowd moves intermittently in the evacuation process, especially in the early and middle stages of evacuation, and the influence of group factors on this process was not obvious. Regardless of the kind of scene or stairwell, the number of pedestrians generally first increased and then decreased to a significantly low value, and the number of pedestrians reached about 30 in the scenario of people without any load. Additionally, the speed of the pedestrians entering the stairwell in the back of the group was not faster than that of the pedestrians in the front, which showed that pedestrians rarely engaged in overtaking behavior. The research results of this paper not only enrich evacuation research but also provide support for the design of high-rise stairs. [ABSTRACT FROM AUTHOR]

A series of Bi2Se3@C materials were prepared through a bismuth metal organic framework (CAU-17) assisted hydrothermal selenization method followed by carbonization, which have been found to be useful as electrode materials for supercapacitor application. The Bi2Se3@C obtained below 500 °C seems to show an excellent specific capacity of 565.9 C g−1 at a current density of 1 A g−1. Furthermore, the performance of Bi2Se3@C in symmetrical supercapacitors (SSCs) is also systemically investigated, and the SSC device achieves a maximum energy density of 39.3 W h kg−1 at a power density of 639.9 W kg−1 and maintains 90.5% of this capacity over 1000 cycles. [ABSTRACT FROM AUTHOR]