Search

Global demand for energy is rapidly increasing, and resources for the production of petroleum-based fuels are running out. For this, renewable fuels like biodiesel and hydrotreated vegetable oil biofuel are considered important alternatives to replace such fuels. In this study, we evaluated the in vitro genotoxicity effect on HepG2 cells of organic material extracted from particulate matter emissions of an engine fueled with conventional diesel or mixtures of diesel with 10% of biomass. The emissions were collected in two operational modes, 2410 rpm (slope simulation) and 1890 rpm (plane). Genotoxicity was evaluated through two methods, chromosomal aberration test and the alkaline comet assay. The former did not show any genotoxic effect, but the latter exhibited a statistically significant effect despite the operational mode of the engine and the concentration organic material extracted. In conclusion, regardless of the concentration of organic material extracted from particulate matter, the operational mode of the engine, or the fuel used, a significant damage of the DNA was found. In general, at the physicochemical level, a decrease in the amount of emissions of the used fuels is not directly related to a decrease in the genotoxicity potential. [ABSTRACT FROM AUTHOR]

Polycyclic aromatic hydrocarbon (PAH), oxy- and nitro-derivate PAH (OPAH and NPAH) emissions from a direct injection diesel engine fueled with conventional fossil diesel (D), waste cooking oil biodiesel (B100), and their two blends (B20 and B50) were compared. The results show that B100 can reduce low molecular weight PAHs such as naphthalene, acenaphthylene, and fluorene as much as 90% compared with diesel. However, the emissions of high molecular weight PAHs including benzo[b]fluoranthene, benzo[k]fluoranthene, and benzo[a]pyrene decrease slightly when using B100. The emission levels for PAHs and OPAHs present comparable, while NPAH emission levels are five to ten times lower than those of PAHs and OPAHs. Compared with diesel, PAH and NPAH emissions significantly decrease. On the contrary, an increase trend of OPAH emission has been observed with adding biodiesel. For the specific parent PAHs and its oxygenated and nitrated derivatives, the fractions of parent PAHs gradually decrease with increasing biodiesel content in the blends, while the corresponding oxygenated and nitrated derivative fractions observably increase, especially for the high molecular weight compounds. Considering the increase of OPAH and NPAH fractions in total particle-phase PAHs when using biodiesel, in-depth biodiesel cytotoxicity assessment should be conducted. [ABSTRACT FROM AUTHOR]

A chemical characterization of diesel and hydrotreated vegetable oil (HVO) soot has been developed using diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) before and after the reaction with different probe gases. Samples were generated under combustion conditions corresponding to an urban operation mode of a diesel engine and were reacted with probe gas-phase molecules in a Knudsen flow reactor. Specifically, NHOH, O and NO were used as reactants (probes) and selected according to their reactivities towards specific functional groups on the sample surface. Samples of previously ground soot were diluted with KBr and were introduced in a DRIFTS accessory. A comparison between unreacted and reacted soot samples was made in order to establish chemical changes on the soot surface upon reaction. It was concluded that the interface of diesel and HVO soot before reaction mainly consists polycyclic aromatic hydrocarbons, nitro and carbonyl compounds, as well as ether functionalities. The main difference between both soot samples was observed in the band of the C=O groups that in diesel soot was observed at 1719 cm but not in HVO soot. After reaction with probe gases, it was found that nitro compounds remain on the soot surface, that the degree of unsaturation decreases for reacted samples, and that new spectral bands such as hydroxyl groups are observed. [ABSTRACT FROM AUTHOR]

Metal-containing fuel additives catalyzing soot combustion in diesel particle filters are used in a widespread manner, and with the growing popularity of diesel vehicles, their application is expected to increase in the near future. Detailed investigation into how such additives affect exhaust toxicity is therefore necessary and has to be performed before epidemiological evidence points towards adverse effects of their application. The present study investigates how the addition of an iron-based fuel additive (Satacen®3, 40 ppm Fe) to low-sulfur diesel affects the in vitro cytotoxic, oxidative, (pro-)inflammatory, and mutagenic activity of the exhaust of a passenger car operated under constant, low-load conditions by exposing a three-dimensional model of the human airway epithelium to complete exhaust at the air-liquid interface. We could show that the use of the iron catalyst without and with filter technology has positive as well as negative effects on exhaust toxicity compared to exhaust with no additives: it decreases the oxidative and, compared to a non-catalyzed diesel particle filter, the mutagenic potential of diesel exhaust, but increases (pro-)inflammatory effects. The presence of a diesel particle filter also influences the impact of Satacen®3 on exhaust toxicity, and the proper choice of the filter type to be used is of importance with regards to exhaust toxicity. [Figure not available: see fulltext.] [ABSTRACT FROM AUTHOR]