Search

Estrogen levels were assessed in surface sediments from one of the most industrialized and urbanized estuarine systems in Latin America (SSES, Santos and São Vicente estuarine system). Estriol (E3) presented quantifiable levels in all sampled sites, ranging from 20.9 ng g -1 to 694.2 ng g -1 . 17β-estradiol (E2) and 17α-ethinylestradiol (EE2) were also detected in almost all sampled sites. The highest concentration of E2 was 23.9 ng g -1 , whereas high levels of EE2 86.3 ng g -1 . The occurrence of estrogens in SSES was diffuse and partially related to a domestic sewage outfall. Estrogens were also found in areas with substantial contribution of sanitary effluents from domiciles not covered by sanitation services. Our results reinforce that studies on environmental contamination by estrogens should not be spatially limited to the vicinities of point sources. These results contribute to raise awareness on the need of a formal approach to assess ecological risks of estrogens in the SSES., (Copyright © 2019 Elsevier Ltd. All rights reserved.)

Indoor dust is considered an important human exposure route to flame retardants (FRs), which has arised concern due the toxic properties of some of these substances. In this study, ten organophosphorus flame retardants (OPFRs), eight polybrominated diphenyl ethers (PBDEs) and four new brominated flame retardants (NBFRs) were determined in indoor dust from different places in Araraquara-SP (Brazil). The sampled places included houses, apartments, offices, primary schools and cars. The analysis of the sample extracts was performed by gas chromatography coupled to mass spectrometry and two ionization techniques were used (electron ionization - EI; electron capture negative ionization - ECNI). OPFRs were the most abundant compounds and tris(2-butoxyethyl) phosphate (TBOEP), tris(phenyl) phosphate (TPHP), tris(1,3-dichloroisopropyl) phosphate (TDCIPP) and tris(2-chloroisopropyl) phosphate (TCIPP) were present at the highest concentrations. Among the brominated FRs, the most ubiquitous compounds were BDE-209, bis(2-ethylhexyl) tetrabromophthalate (BEH-TEBP) and decabromodiphenyl ethane (DBDPE). Statistical analysis revealed that there were differences among dust typologies for TBOEP, TDCIPP, ethylhexyl diphenyl phosphate (EHDPHP), BDE-209, 2-ethylhexyl 2,3,4,5-tetrabromobenzoate (EH-TBB), BEH-TEBP and DBDPE, which were attributed to different construction materials in each particular environment and to the age of the buildings. The highest levels of brominated FRs were observed in offices, TBOEP was at high concentration in primary schools, and TDCIPP was at high concentration in cars. A preliminary risk assessment revealed that toddlers were exposed to TBOEP levels higher than the reference dose when considering the worst case scenario. The results obtained in this study showed for the first time that although Brazil does not regulate the use of FRs, these substances are present in indoor dust at levels similar to the observed in countries that have strict fire safety standards, and that humans are exposed to complex mixtures of these contaminants via indoor dust., (Copyright © 2017 Elsevier Ltd. All rights reserved.)

The presence of estrogenic mycotoxins, such as zearalenone (ZEN), in surface waters is an emerging environmental issue. Little is known about its phototransformation behavior, which may influence its environmental fate. In this context, the phototransformation of ZEN was investigated in pure water, river water and estuarine water using simulated sunlight irradiation. Kinetic studies revealed that two concomitant processes contribute to the fate of ZEN under solar irradiation: photoisomerization and photodegradation. This phototransformation followed a pseudo-first order kinetics. ZEN degrades quickly in natural waters and slowly in deionized water, with half-lives (t 1/2 ) of 28 ± 4 min (estuarine water), 136 ± 21 min (river water) and 1777 ± 412 min (deionized water). The effects of different water constituents on the phototransformation of ZEN in aqueous solution have been assessed (NaCl, Ca 2+ , Mg 2+ , Fe 3+ , NO 3 - and oxalate ions, synthetic seawater, Fe(III)-oxalate and Mg(II)-oxalate complexes, humic acids, fulvic acids and XAD-4 fraction). In the presence of synthetic seawater salt (t 1/2  = 18 ± 5 min) and Fe(III)-oxalate complexes (t 1/2  = 61 ± 9 min), the transformation rate increased considerably in relation to other water constituents tested. The solution pH also had a considerable effect in the kinetics with maximum transformation rates occurring around pH 8.5. These results allow us to conclude that phototransformation by solar radiation can be an important degradation pathway of ZEN in natural waters., (Copyright © 2016 Elsevier Ltd. All rights reserved.)

Although the particulate matter (PM) emissions from biodiesel fuelled engines are acknowledged to be lower than those of fossil diesel, there is a concern on the impact of PM produced by biodiesel to human health. As the oxidative potential of PM has been suggested as trigger for adverse health effects, it was measured using the Electron Spin Resonance (OP(ESR)) technique. Additionally, Energy Dispersive X-ray Fluorescence Spectroscopy (EDXRF) was employed to determine elemental concentration, and Raman Spectroscopy was used to describe the amorphous carbon character of the soot collected on exhaust PM from biodiesel blends fuelled test-bed engine, with and without Selective Catalytic Reduction (SCR). OP(ESR) results showed higher oxidative potential per kWh of PM produced from a blend of 20% soybean biodiesel and 80% ULSD (B20) engine compared with a blend of 5% soybean biodiesel and 95% ULSD (B5), whereas the SCR was able to reduce oxidative potential for each fuel. EDXRF data indicates a correlation of 0.99 between concentration of copper and oxidative potential. Raman Spectroscopy centered on the expected carbon peaks between 1100cm(-1) and 1600cm(-1) indicate lower molecular disorder for the B20 particulate matter, an indicative of a more graphitic carbon structure. The analytical techniques used in this study highlight the link between biodiesel engine exhaust and increased oxidative potential relative to biodiesel addition on fossil diesel combustion. The EDXRF analysis confirmed the prominent role of metals on free radical production. As a whole, these results suggest that 20% of biodiesel blends run without SCR may pose an increased health risk due to an increase in OH radical generation., (Copyright © 2015 Elsevier B.V. All rights reserved.)

Butyltin compounds (BTs), including tributyltin (TBT) and its degradation products, dibutyltin and monobutyltin, have been found in a diversity of aquatic systems and causing toxic effects in target and nontarget organisms. They enter in coastal systems through different sources (as antifouling paints, industrial effluents, etc.) where they interact with biotic and abiotic components, and their distribution is commonly determined by the morphological and hydrodynamic conditions of the coastal systems. In this study, we discuss the contamination by BTs on a spatial scale (eight estuaries with three subareas each) and in different compartments of the estuaries (sediments, suspended particulate matter (SPM), and estuarine catfish tissues (liver and gills). Lower concentrations of BTs were found in the sediments (n.d. to 338 ng g(-1)) in comparison to studies before a ban of TBT in antifouling paints was enacted, mostly indicating an old input or preservation related with sediment properties and composition. For SPM samples (n.d. to 175 ng L(-1)) as well as in fish tissues (n.d. to 1426 ng g(-1)), the presence of these compounds was frequent, especially in the fish due to their movement throughout the estuaries and the potential to assess point sources of BTs. These results indicate that BTs persist in the environment, with variation in amounts between investigated estuaries and even at locations inside the same estuary, because of ideal preservation conditions, transport to remote areas, and input from different sources.

Ultraviolet (UV) filters are widely used in the formulation of personal care products (PCPs) to prevent damage to the skin, lips, and hair caused by excessive UV radiation. Therefore, large amounts of these substances are released daily into the aquatic environment through either recreational activities or the release of domestic sewage. The concern regarding the presence of such substances in the environment and the exposure of aquatic organisms is based on their potential for bioaccumulation and their potential as endocrine disruptors. Although there are several reports regarding the occurrence and fate of UV filters in the aquatic environment, these compounds are still overlooked in tropical areas. In this study, we investigated the occurrence of the organic UV filters benzophenone-3 (BP-3), ethylhexyl salicylate (ES), ethylhexyl methoxycinnamate (EHMC), and octocrylene (OC) in six water treatment plants in various cities in Southeast Brazil over a period of 6 months to 1 year. All of the UV filters studied were detected at some time during the sampling period; however, only EHMC and BP-3 were found in quantifiable concentrations, ranging from 55 to 101 and 18 to 115 ng L(-1), respectively. Seasonal variation of BP-3 was most clearly noticed in the water treatment plant in Araraquara, São Paulo, where sampling was performed for 12 months. BP-3 was not quantifiable in winter but was quantifiable in summer. The levels of BP-3 were in the same range in raw, treated and chlorinated water, indicating that the compound was not removed by the water treatment process.

A novel, simple, rapid and eco-friendly method based on dispersive liquid-liquid microextraction using a bromosolvent was developed to determine six estrogenic mycotoxins (zearalenone, zearalanone, α-zearalanol, β-zearalanol, α-zearalenol and β-zearalenol) in water samples by liquid chromatography-electrospray ionization tandem mass spectrometry in the negative mode (LC-ESI-MS/MS). The optimal conditions for this method include the use of 100 μL bromocyclohexane as an extraction solvent (using a non-dispersion solvent), 10 mL of aqueous sample (adjusted to pH 4), a vortex extraction time of 2 min, centrifugation for 10 min at 3500 rpm and no ionic strength adjustment. The calibration function was linear and was verified by applying the Mandel fitting test with a 95% confidence level. No matrix effect was observed. According to the relative standard deviations (RSDs), the precision was better than 13% for the repeatability and intermediate precision. The average recoveries of the spiked compounds ranged from 81 to 118%. The method limits of detection (LOD) and quantification (LOQ) considering a 125-fold pre-concentration step were 4-20 and 8-40 ng L(-1), respectively. Next, the method was applied to the analysis of the environmental aqueous samples, demonstrating the presence of β-zearalanol and zearalanone in the river water samples., (Copyright © 2015 Elsevier B.V. All rights reserved.)

Recently introduced rapidly mutating Y-chromosomal short tandem repeat (RM Y-STR) loci, displaying a multiple-fold higher mutation rate relative to any other Y-STRs, including those conventionally used in forensic casework, have been demonstrated to improve the resolution of male lineage differentiation and to allow male relative separation usually impossible with standard Y-STRs. However, large and geographically-detailed frequency haplotype databases are required to estimate the statistical weight of RM Y-STR haplotype matches if observed in forensic casework. With this in mind, the Italian Working Group (GEFI) of the International Society for Forensic Genetics launched a collaborative exercise aimed at generating an Italian quality controlled forensic RM Y-STR haplotype database. Overall 1509 male individuals from 13 regional populations covering northern, central and southern areas of the Italian peninsula plus Sicily were collected, including both "rural" and "urban" samples classified according to population density in the sampling area. A subset of individuals was additionally genotyped for Y-STR loci included in the Yfiler and PowerPlex Y23 (PPY23) systems (75% and 62%, respectively), allowing the comparison of RM and conventional Y-STRs. Considering the whole set of 13 RM Y-STRs, 1501 unique haplotypes were observed among the 1509 sampled Italian men with a haplotype diversity of 0.999996, largely superior to Yfiler and PPY23 with 0.999914 and 0.999950, respectively. AMOVA indicated that 99.996% of the haplotype variation was within populations, confirming that genetic-geographic structure is almost undetected by RM Y-STRs. Haplotype sharing among regional Italian populations was not observed at all with the complete set of 13 RM Y-STRs. Haplotype sharing within Italian populations was very rare (0.27% non-unique haplotypes), and lower in urban (0.22%) than rural (0.29%) areas. Additionally, 422 father-son pairs were investigated, and 20.1% of them could be discriminated by the whole set of 13 RM Y-STRs, which was very close to the theoretically expected estimate of 19.5% given the mutation rates of the markers used. Results obtained from a high-coverage Italian haplotype dataset confirm on the regional scale the exceptional ability of RM Y-STRs to resolve male lineages previously observed globally, and attest the unsurpassed value of RM Y-STRs for male-relative differentiation purposes., (Copyright © 2014 Elsevier Ireland Ltd. All rights reserved.)

This paper describes the validation of a method consisting of solid-phase extraction followed by gas chromatography-tandem mass spectrometry for the analysis of the ultraviolet (UV) filters benzophenone-3, ethylhexyl salicylate, ethylhexyl methoxycinnamate and octocrylene. The method validation criteria included evaluation of selectivity, analytical curve, trueness, precision, limits of detection and limits of quantification. The non-weighted linear regression model has traditionally been used for calibration, but it is not necessarily the optimal model in all cases. Because the assumption of homoscedasticity was not met for the analytical data in this work, a weighted least squares linear regression was used for the calibration method. The evaluated analytical parameters were satisfactory for the analytes and showed recoveries at four fortification levels between 62% and 107%, with relative standard deviations less than 14%. The detection limits ranged from 7.6 to 24.1 ng L(-1). The proposed method was used to determine the amount of UV filters in water samples from water treatment plants in Araraquara and Jau in São Paulo, Brazil., (Copyright © 2014 Elsevier B.V. All rights reserved.)