Search

Anaerobic digestion (AD) is regarded as an effective method to treat waste activated sludge (WAS) and fat, oil and grease (FOG). Co-digestion of WAS/FOG could promote the methane yield but it will cause acid and salinity inhibition. Green waste (GW) was added into the digesters, and its effects on co-digestion of WAS and FOG in the mesophilic batch digester were investigated. Digestive performances (such as hydrolysis, acidogenesis and methanogenesis) were studied emphatically. The results showed that digester L6 (WAS:FOG:GW = 1:2:1, VS basis) presented the highest specific methane yield (SMY, 341.5 mL/g VS). The results of kinetics study verified that there was a slower hydrolysis rate when GW was applied as a co-substrate, which could reduce the potential of acid inhibition. Volatile fatty acid (VFA) and electrical conductivity analysis showed that GW addition could keep moderate VFA concentrations and alleviate the negative effects of high-salinity substrates on the digestive systems. The microbial community and diversity analysis proved that GW addition was beneficial to keep the balance of hydrolytic bacteria, acidogens and acetogens. The results of this study indicated that GW addition could enhance the energy recovery and system stability in the WAS/FOG co-digestive system. [ABSTRACT FROM AUTHOR]

This paper used cetyltrimethylammonium chloride (CTAC) pre-loaded activated carbon (AC) to research nitrate adsorption. Effects of various parameters such as AC types, AC dosage as well as initial pH were studied. The results indicated that the ACs modified by CTAC can get higher nitrate removal. Even pH is neutral and basic, an accepted removal about 2.5 mg/g can be observed. The more CTAC pre-loaded on the AC surface, the higher nitrate adsorption capacity can be obtained. pH is regarded as a key factor affecting interactions between adsorbent and adsorbate, and the results confirmed that the nitrate adsorption on modified AC decreases gradually with the growth of initial pH. Besides, the acidic pH condition is much favoured for adsorption while the results gained a nitrate adsorption about 4.28 mg/g at pH = 3 condition. Sorption mechanism of nitrate on CTAC modified AC was investigated through two kinetic modellings including pseudo-second-order and Weber and Morris intra-particle diffusion model. The results imply that the generalized kinetic models tally well with experimental data. Additionally, interference of co-existing anions is examined, and the results showed that higher co-anions concentration would bring a heavier depression of the nitrate uptake due to its competing for adsorption sites. [ABSTRACT FROM AUTHOR]

The function of sewer as reactors must rely on the biofilm in it. In this paper, the formation, structure, oxygen transfer, and activity of the biofilm under different hydraulic conditions were studied by the microelectrode technology, oxygen uptake rate (OUR) technology, and 454 high-throughput pyrosequencing technology. Results showed that when the wall-shear stresses were 1.12, 1.29, and 1.45 Pa, the porosity of the steady-state biofilm were 69.1, 64.4, and 55.1 %, respectively. The maximum values of OUR were 0.033, 0.027, and 0.022 mg/(L*s), respectively, and the COD removal efficiency in the sewers reached 40, 35, and 32 %, respectively. The research findings had an important significance on how to improve the treatment efficiency of the sewers. [ABSTRACT FROM AUTHOR]

Emission of nitrous oxide (N 2 O) during biological wastewater treatment is of growing concern. This paper reports findings of the effects of carbon/nitrogen (C/N) ratio on N 2 O production rates in a laboratory-scale biological aerated filter (BAF) reactor, focusing on the biofilm during nitrification. Polymerase chain reaction-denaturing gradient gel electrophoresis (PCR-DGGE) and microelectrode technology were utilized to evaluate the mechanisms associated with N 2 O production during wastewater treatment using BAF. Results indicated that the ability of N 2 O emission in biofilm at C/N ratio of 2 was much stronger than at C/N ratios of 5 and 8. PCR-DGGE analysis showed that the microbial community structures differed completely after the acclimatization at tested C/N ratios (i.e., 2, 5, and 8). Measurements of critical parameters including dissolved oxygen, oxidation reduction potential, NH 4 + -N, NO 3 - -N, and NO 2 - -N also demonstrated that the internal micro-environment of the biofilm benefit N 2 O production. DNA analysis showed that Proteobacteria comprised the majority of the bacteria, which might mainly result in N 2 O emission. Based on these results, C/N ratio is one of the parameters that play an important role in the N 2 O emission from the BAF reactors during nitrification.

Sewer biofilms play an important role in the biotransformation of substances for methane and sulfide emission in sewer networks. The dynamic flows and the particular shear stress in sewers are the key factors determining the growth of the sewer biofilm. In this work, the development of sewer biofilm with varying shear stress is specifically investigated to gain a comprehensive understanding of the sewer biofilm dynamics. Sewer biofilms were cultivated in laboratory-scale gravity sewers under different hydraulic conditions with the corresponding shell stresses are 1.12 Pa, 1.29 Pa and 1.45 Pa, respectively. The evolution of the biofilm thickness were monitored using microelectrodes, and the variation in total solids (TS) and extracellular polymer substance (EPS) levels in the biofilm were also measured. The results showed that the steady-state biofilm thickness were highly related to the corresponding shear stresses with the biofilm thickness of 2.4 ± 0.1 mm, 2.7 ± 0.1 mm and 2.2 ± 0.1 mm at shear stresses of 1.12 Pa, 1.29 Pa and 1.45 Pa, respectively, which the chemical oxygen demand concentration is 400 mg/L approximately. Based on these observations, a kinetic model for describing the development of sewer biofilms was developed and demonstrated to be capable of reproducing all the experimental data.