Search

COVID-19 pandemic raised a debate regarding the role of airborne transmission. Information regarding virus-laden aerosol concentrations is still scarce in community indoors and what are the risks for general public and the efficiency of restriction policies. This work investigates, for the first time in Italy, the presence of SARS-CoV-2 RNA in air samples collected in different community indoors (one train station, two food markets, one canteen, one shopping centre, one hair salon, and one pharmacy) in three Italian cities: metropolitan city of Venice (NE of Italy), Bologna (central Italy), and Lecce (SE of Italy). Air samples were collected during the maximum spread of the second wave of pandemic in Italy (November and December 2020). All collected samples tested negative for the presence of SARS-CoV-2, using both real-time RT-PCR and ddPCR, and no significant differences were observed comparing samples taken with and without customers. Modelling average concentrations, using influx of customers' data and local epidemiological information, indicated low values (i.e. < 0.8 copies m -3 when cotton facemasks are used and even lower for surgical facemasks). The results, even if with some limitations, suggest that the restrictive policies enforced could effectively reduce the risk of airborne transmissions in the community indoor investigated, providing that physical distance is respected., (© 2021. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.)

The spread of SARS-CoV-2 by contact (direct or indirect) is widely accepted, but the relative importance of airborne transmission is still controversial. Probability of outdoor airborne transmission depends on several parameters, still rather uncertain: virus-laden aerosol concentrations, viability and lifetime, minimum dose necessary to transmit the disease. In this work, an estimate of outdoor concentrations in northern Italy (region Lombardia) was performed using a simple box model approach, based on an estimate of respiratory emissions, with a specific focus for the cities of Milan and Bergamo (Italy). In addition, the probability of interaction of virus-laden aerosol with pre-existing particles of different sizes was investigated. Results indicate very low (<1 RNA copy/m 3 ) average outdoor concentrations in public area, excluding crowded zones, even in the worst case scenario and assuming a number of infects up to 25% of population. On average, assuming a number of infects equal to 10% of the population, the time necessary to inspire a quantum (i.e. the dose of airborne droplet nuclei required to cause infection in 63% of susceptible persons) would be 31.5 days in Milan (range 2.7-91 days) and 51.2 days in Bergamo (range 4.4-149 days). Therefore, the probability of airborne transmission due to respiratory aerosol is very low in outdoor conditions, even if it could be more relevant for community indoor environments, in which further studies are necessary to investigate the potential risks. We theoretically examined if atmospheric particles can scavenge virus aerosol, through inertial impact, interception, and Brownian diffusion. The probability was very low. In addition, the probability of coagulation of virus-laden aerosol with pre-existing atmospheric particles resulted negligible for accumulation and coarse mode particles, but virus-laden aerosol could act as sink of ultrafine particles (around 0.01 μm in diameter). However, this will not change significantly the dynamics behaviour of the virus particle or its permanence time in atmosphere., (Copyright © 2020 Elsevier Inc. All rights reserved.)

Although biogas production can have some benefits, there is a research gap on potential influence of biogas plant emissions on local air quality, thus an accurate and comprehensive evaluation of impacts of this technology is needed. This study deals with this issue by means of a characterisation of air pollution near an industrial area including a biogas production (from biomass) and combustion plant located in South Italy. The methodology consists in advanced statistical analysis on concentration of gaseous pollutants, particles concentration and size distribution in number and mass, and PM 2.5 chemical composition. High-temporal resolution measurements, supported by ancillary meteorological parameters, and source apportionment of PM 2.5 using Positive Matrix Factorization (PMF) receptor model, are performed. The integrated approach provides the emissive picture consisting in different anthropogenic sources (i.e. traffic, biomass burning, and industrial facilities) with particular focus on biogas plant emissions. Results showed that CO and nitrogen oxides were influenced by vehicular traffic and biomass combustion, however, a contribution of the plant to NO was observed. SO 2 was influenced mainly by transport from the industrial zone, but a second local contribution compatible with the emissions of the biogas plant was detected. Number particle concentrations were analysed in four size ranges: nanoparticles (D < 0.05 μm), ultrafine particles (D < 0.3 μm), accumulation (0.3 < D < 1 μm) and coarse particles (D > 1 μm). Nanoparticles and ultrafine particles were mainly influenced by vehicular traffic and biomass burning, instead, a contribution of the plant was individuated in the accumulation mode. PMF5 identified the contribution of six sources: crustal (14.7% ± 2.1% of measured PM 2.5 ); marine aerosol (aged) (12.9% ± 2.3%); biomass burning (32.8% ± 1.4%); secondary sulphate (19.7% ± 2.4%); primary industrial emissions (5.4% ± 2.3%); traffic and secondary nitrate (17.0% ± 3.9%). The plant is likely to contribute to both sources, the industrial and the traffic plus secondary nitrate., Competing Interests: Declaration of competing Interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper., (Copyright © 2020 Elsevier B.V. All rights reserved.)