Search

Novel building materials were manufactured and analyzed for 226Ra, 232Th and 40K using an HPGe gamma-ray spectrometer. The results show that the highest value of 40K was 4530 Bq per kg which was measured in a sample containing fly ashes from olive stones. The highest values of 226Ra and 232Th activities were 181 and 185 Bq per kg, which were measured in a sample with fly ashes from the co-combustion of coal and coke, respectively. On the other hand, the lowest values of 40K, 226Ra and 232Th activities were obtained for samples incorporating mussel shells. The radiological health hazard parameters, such as radium equivalent activity (Raeq), activity concentration index (I), absorbed and effective dose rates, associated with these radionuclides were evaluated. These values are within the EU recommended limits in building materials, except for samples of concrete containing fly ashes from olive stones, coal and coke. This study has contributed to the inclusion of industrial wastes that have not been collected previously in the Naturally Occurring Radioactive Material (NORM) databases on radioactivity of building materials.

Bisphenol A (BPA) is a high-production-volume chemical with endocrine disrupting properties commonly used as color developer in thermal paper. Concerns about the potential hazards of human BPA exposure have led to the increasing utilization of alternatives such as bisphenol S (BPS) and bisphenol F (BPF). This study was designed to assess: (i) BPA, BPS, and BPF concentrations in 112 thermal paper receipts from Brazil, France, and Spain by liquid chromatography coupled to mass spectrometry (LC-MS); and (ii) hormone-like activities of these receipts using two receptor-specific bioassays, the E-Screen for (anti-)estrogenicity and PALM luciferase assay for (anti-)androgenicity. BPA was present in 95.3% of receipts from Spain, 90.9% of those from Brazil, and 51.1% of those from France at concentrations up to 20.27 mg/g of paper. Only two samples from Brazil, two from Spain, and ten from France had a BPS concentration ranging from 6.46 to 13.29 mg/g; no BPA or BPS was detected in 27.7% of French samples. No BPF was detected in any receipt. Estrogenic activity was observed in all samples from Brazil and Spain and in 74.5% of those from France. Anti-androgenic activity was observed in > 90% of samples from Brazil and Spain and in 53.2% of those from France. Only 25.5% of French samples were negative for both estrogenic and anti-androgenic activity. Estrogenic and anti-androgenic activities per gram of paper were up to 1.411 µM estradiol (E2) equivalent units (E2eq) and up to 359.5 mM procymidone equivalent units (Proceq), respectively. BPA but not BPS concentrations were positively correlated with both estrogenic and anti-androgenic activities. BPA still dominates the thermal paper market in Brazil and Spain, and BPS appears to be one of the main alternatives in France. There is an urgent need to evaluate the safety of alternatives proposed to replace BPA as developer in thermal printing. The large proportion of samples with hormonal activity calls for the adoption of preventive measures.

Thermal paper contains potentially toxic additives, such as bisphenol A (BPA), as a common color developer. Because of its known endocrine disrupting effects, structural analogues to BPA, such as bisphenol S (BPS), D-8 and Pergafast 201, have been used as alternatives, but little is known about the presence and toxicological effects of alternatives other than BPS. In this study, thermal paper is screened by direct probe ambient mass spectrometry (rapid pre-screening method not requiring sample preparation) and by liquid chromatography (LC) with high resolution time-of flight (TOF-MS) mass spectrometry. Cash receipts and other thermal paper products (cinema tickets, boarding passes and luggage tags) were analyzed. Besides BPA and BPS, other developers only recently reported (Pergafast 201, D-8) or to the best of our knowledge not reported before (D-90, TGSA, BPS-MAE) were frequently found as well as some related unreported impurities (2,4-BPS that is a BPS related impurity and a TGSA related impurity). To gain some insight into the potential estrogenicity of the detected developers, a selection of extracts was further analyzed using a LC-nanofractionation platform in combination with cell-based bioassay testing. These preliminary results seems to indicate very low or absence of estrogenic activity for Pergafast 201, D-8, D-90, TGSA and BPS-MAE in comparison to BPA and BPS, although further dose-response tests with authentic standards are required to confirm these results. Compounds for which standards were available were also tested for developmental toxicity and neurotoxicity using zebrafish (Danio rerio) embryos. TGSA and D-8 induced similar teratogenic effects as BPA in zebrafish embryos. BPS and 2,4-BPS did not induce any developmental effects but 2,4-BPS did alter the locomotor activity at the tested concentration. Our findings suggest that the alternatives used as alternatives to BPA (except BPS) might not be estrogenic. However, TGSA and D-8 showed abnormal developmental effects similar to BPA.

The reuse of deinking paper mill effluent based on reverse osmosis is limited by silica scaling on the membranes. The removal of silica during softening processes is one of the most used approaches as it can treat large volumes of water at low cost, but when the water hardness is low, the addition of magnesium compounds is necessary. In the present investigation, MgCl2·6H2O was selected as magnesium source to analyze the effect of pH, dosage, temperature, and contact time on silica removal. Moreover, the silica removal mechanism was analyzed under different operational conditions. The results show that it is possible to obtain high silica removal rates (>70%) at an intermediate dosage (750 mg/L of MgCl2·6H2O) either at high pH (12.0) and ambient temperature (20 °C) or lower pHs, i.e., pH = 10.5, but at higher temperatures 35-50 °C. The kinetic study demonstrates that contact times lower than 30 min are enough for silica removal with independence of the temperature. SEM-energy-dispersive X-ray spectroscopy (EDX) and Fourier transform infrared spectroscopy (FTIR) analysis of the solids obtained confirms that silica is removed through the formation of magnesium silicates. The EDX analysis showed that, independently of the operational conditions, the atomic Si/Mg ratio was around 0.7 which indicates that antigorite (Mg3Si2O5(OH)4) is the predominant specie formed.

BACKGROUND: The objectives of the study were to develop web-based Spanish and Catalan versions of the EQ-5D-Y, and to compare scores and psychometric properties with the paper version. METHODS: Web-based and paper versions of EQ-5D-Y were included in a cross-sectional study in Palafolls (Barcelona), Spain and administered to students (n = 923) aged 8 to 18 years from 2 primary and 1 secondary school and their parents. All students completed both the web-based and paper versions during school time with an interval of at least 2 h between administrations. The order of administration was randomized. Participants completed EQ-5D-Y, a measure of mental health status (the Strengths and Difficulties Questionnaire), and sociodemographic variables using a self-administered questionnaire. Parents questionnaire included parental level of education and presence of chronic conditions in children. Missing values, and floor and ceiling effects were compared between versions. Mean score differences were computed for the visual analogue scale (VAS). Percentage of agreement, kappa index (k) and intraclass correlation coefficient (ICC) were computed to analyze the level of agreement between web-based and paper versions on EQ-5D-Y dimensions and VAS. Known groups validity was analyzed and compared between the two formats. RESULTS: Participation rate was 77 % (n = 715). Both formats of EQ-5D-Y showed low percentages of missing values (n = 2, and 4 to 9 for web and paper versions respectively), and a high ceiling effect by dimension (range from 79 % to 96 %). Percent agreement for EQ-5D-Y dimensions on the web and paper versions was acceptable (range 89 % to 97 %), and k ranged from 0.55 (0.48-0.61, usual activities dimension) to 0.75 (0.68-0.82, mobility dimension). Mean score difference on the VAS was 0.07, and the ICC for VAS scores on the two formats was 0.84 (0.82-0.86). Both formats showed acceptable ability to discriminate according to self-perceived health, reporting chronic conditions, and mental health status. CONCLUSIONS: The digital EQ-5D-Y showed almost identical VAS scores and acceptable levels of agreement on dimensions. Both formats demonstrated acceptable levels of construct validity. Availability of the Spanish and Catalan web-version will facilitate its use in HRQOL assessment and in economic evaluation. The study was financed by the Spanish Ministry of Health, contract N° PI12/01296.

This paper analyzes the generation and composition of municipal solid waste in Spanish towns and cities with more than 5000 inhabitants, which altogether account for 87 % of the Spanish population. To do so, the total composition and generation of municipal solid waste fractions were obtained from 135 towns and cities. Homogeneity tests revealed heterogeneity in the proportions of municipal solid waste fractions from one city to another. Statistical analyses identified significant differences in the generation of glass in cities of different sizes and in the generation of all fractions depending on the hydrographic area. Finally, linear regression models and residuals analysis were applied to analyze the effect of different demographic, geographic, and socioeconomic variables on the generation of waste fractions. The conclusions show that more densely populated towns, a hydrographic area, and cities with over 50,000 inhabitants have higher waste generation rates, while certain socioeconomic variables (people/car) decrease that generation. Other socioeconomic variables (foreigners and unemployment) show a positive and null influence on that waste generation, respectively.