Search

We study the cross-layer energy efficiency of cooperative MIMO networks. At the physical layer, the transmit power determines the outage probability and the number of contending nodes per unit area. At the medium access control (MAC) layer, accessing the channel takes additional time and energy, which impacts the throughput and the energy efficiency. Then, we propose a new cooperative MAC protocol based on IEEE 802.11 in order to coordinate cooperation and to improve the energy efficiency. Moreover, we focus on slow fading scenarios and we analyze the performance of antenna selection (AS), singular value decomposition (SVD) diversity beamforming, and spatial multiplexing (SM) transmission schemes. Results show that SVD and SM have smaller delay and, consequently, larger throughput; however, AS is more energy efficient. [ABSTRACT FROM PUBLISHER]

The effective deployment of Internet of Things (IoT) applications such as smart cities, smart farming and smart transport systems must ensure the network robustness, scalability and longevity. Therefore, guaranteeing the successful delivery of information and extending the lifetime of the nodes that make up a wireless sensor network (WSN) are two essential aspects for IoT applications. This work evaluates the performance of a cooperative WSN by adopting two multiantenna schemes: antenna selection (AS) and beamforming transmission using the singular value decomposition (SVD) technique. In addition, cooperation is established according to an ON–OFF probability, so that the RF receiving circuits of the relays are activated in a probabilistic way, aiming at reducing the energy consumption of the sensors, extending their useful lifetime. Our main goal is to increase the amount of information effectively transmitted by the network, keeping an outage probability constraint. The results show that, when both techniques are used, there is a significant gain in the amount of information effectively transmitted by the network, with emphasis on the AS scheme at short transmission distances. By increasing the number of antennas, it was found that a lower ON–OFF probability is required, i.e., a trade-off is established between the nodes' hardware complexity and their need for cooperation. [ABSTRACT FROM AUTHOR]

Energy-efficiency is crucial for modern radio-frequency (RF) receivers dedicated to Internet of Things applications. Energy-efficiency enhancements could be achieved by lowering the power consumption of integrated circuits, using antenna diversity or even with an association of both strategies. This paper compares two wideband RF front-end architectures, based on conventional low-noise amplifiers (LNA) and low-noise transconductance amplifiers (LNTA) with N-path filters, operating with three transmission schemes: single antenna, antenna selection and singular value decomposition beamforming. Our results show that the energy-efficiency behavior varies depending on the required communication link conditions, distance between nodes and metrics from the front-end receivers. For short-range scenarios, LNA presents the best performance in terms of energy-efficiency mainly due to its very low power consumption. With the increasing of the communication distance, the very low noise figure provided by N-path LNTA-based architectures outperforms the power consumption issue, yielding higher energy-efficiency for all transmission schemes. In addition, the selected front-end architecture depends on the number of active antennas at the receiver. Hence, we can observe that low noise figure is more important with a few active antennas at the receiver, while low power consumption becomes more important when the number of active RF chains at the receiver increases. [ABSTRACT FROM AUTHOR]