Search

Surface plasmon resonance (SPR) sensing methods enable highly sensitive, fast response, and label-free analysis of biomolecular interactions. For SPR sensors, sensitivity and full width at half maximum (FWHM) are two incompatible performance parameters. We propose a refractive index (RI) sensor using a dual-core photonic crystal fiber (PCF) and SPR effects to achieve high sensitivity and a narrow FWHM simultaneously. The air holes of the sensor appear in a hexagonal arrangement, and polishing technology introduces two polishing planes into the cladding. A gold film is deposited on one side of the polished plane to form a highly sensitive RI sensing channel. Five gold nanowires are deposited on the other side of the polished plane to form a RI sensing channel with a narrow FWHM. We analyzed and optimized its structural parameters using the finite element method and determined the optimal structural parameters. The numerical results demonstrate that the maximum sensitivity of the sensor is 21,000 nm/RIU with the narrowest FWHM of 31 nm. Therefore, measuring the refractive index simultaneously with two sensing channels increases the detection accuracy of the measurement. In addition, the findings further indicate that variations in structural parameters do not significantly impact the sensing performance of the sensor, which makes the production of the sensor relatively simple. In conclusion, our work provides a new research method for realizing high sensitivity and a narrow FWHM simultaneously. [ABSTRACT FROM AUTHOR]

A D-shaped photonic crystal fiber (PCF) surface plasmon resonance (SPR) sensor is proposed to measure the refractive index in visible and near-infrared regions. Compared with traditional PCF, the use of D-shaped PCF can avoid filling materials and coatings in the hole. The plasma material of sensors is silver, and graphene is coated on the surface of the silver film. Graphene layer can not only prevent the oxidation of the silver but also improve the performance of the sensor. Then the influence of structural parameters on the sensor performance is studied by the finite element method (FEM). Results show that the performance of the sensor is not sensitive to the structural parameters, which makes the sensor has a good manufacturing tolerance. Moreover, when the refractive index (RI) of the analyte is 1.33 ~ 1.41, the maximum wavelength sensitivity is 13,750 nm/RIU, and the corresponding RI resolution is 7.27 × 10−6 RIU−1. In addition, the maximum figure of merit is 201 RIU−1. The proposed sensor is advanced with high sensitivity, simple structure and big fabrication tolerance, which could become a competitive candidate for water pollution monitoring, medical diagnosis, biochemical analysis, and detection fields. [ABSTRACT FROM AUTHOR]