Search

A fully coupling model for the diffusion induced finite elastoplastic bending of bilayer electrodes in lithium-ion batteries is proposed. The effect of the mechanical stress on the lithium diffusion is accounted for by the mechanical part of the chemical potential derived from the Gibbs free energy along with the logarithmic stress and strain. Eight dimensionless parameters, governing the stress-assisted diffusion and the diffusion induced elastoplastic bending, are identified. It is found that the finite plasticity starting from the interface of the bilayer increases the chemical potential gradient and thereby facilitates the lithium diffusion. The full plastic flow makes the abnormal lithium concentration distribution possible, i.e., the concentration at the lithium inlet can be lower than the concentration at the interface (downstream). The increase in the thickness of the active layer during charging is much larger than the eigen-stretch due to lithiation, and this excess thickening is found to be caused by the lithiation induced plastic yield. [ABSTRACT FROM AUTHOR]

This article demonstrates the design of charging strategies for lithium ion batteries with considering the balance between diffusion induced stress and total charge time for two- and three-stage charge methods. For the two-stage galvanostatic-potentiostatic charge method the low mechanical stress can be achieved without increasing total charge time by switching the galvanostatic to the potentiostatic at the time moment when the lithium concentration at the surface of particles reaches the limit c ¯ surf = 0 . A three-stage method, which consists of an initial galvanostatic stage of high current, a galvanostatic stage of low current and a potentiostatic ending stage, is suggested. Employing the initial galvanostatic stage of high current is helpful not only in accelerating the charge process, but also in controlling the mechanical stress once the electrical current and time duration of the initial galvanostatic stage are properly designed. [ABSTRACT FROM AUTHOR]

Abstract: This paper proposes a strategy to reduce the diffusion induced stress and enhance the capacity of a layered electrode by allowing the plastic deformation of current collector. Based on analytical formulations of the stress in whole electrode, three types of elastoplastic behaviors of current collector, i.e. pure elastic deformation, plastic shakedown and cyclic plasticity, are identified. Criterions separating the three cases are proposed. It is found applying a thin current collector and allowing it to plastically yield in the charge/discharge cycles is beneficial not only to capacity as more space can be provided for active materials but also to electrochemical stability because the stress in active layer is significantly reduced. Structural design corresponding to plastic shakedown shows good balance between the said improvements and structural safety, whereas the case of cyclic plasticity further enhances the improvements. Therefore, structural designing scheme is provided for the former case according to the criterion of plastic shakedown but for the latter one based on the Coffin–Manson relation with expected cycle life. [Copyright &y& Elsevier]