Search

A strain profile measurement technique using a chirped fibre Bragg grating (CFBG) sensor by implementing an integration of differences (IOD) method is reported in this paper. Using the IOD method the spatial distribution of strain along the length of the CFBG is extracted from its power reflectance spectra. As a proof of concept demonstration, the developed technique is applied to measure the polymerisation shrinkage strain profile of a photo-cured polymer dental composite which exhibits a non-uniform strain distribution attributed to the curing lamp characteristics. The result from the CFBG technique is compared with that of an FBG array embedded in the dental composite and is correlated with the degree of conversion of the material which also depends on the curing lamp intensity distribution. This technology will have significant impact and applications in a range of medical, materials and engineering areas where strain or temperature gradient profile measurement is required in smaller scales.

Objectives To test the hypothesis that restoration of class II mesio-occlusal-distal (MOD) cavities can be strengthened through judicious choice of restoration geometry and material properties. Methods An intact extracted human maxillary molar tooth was digitized, segmented, reconstructed, and four 3D restored tooth models were developed with four different restoration geometries: one straight, one single-curved, and two double-curved. Stress analysis was conducted for representative loading using finite element analysis, and maximum principal stresses were determined at the dentine-enamel and restoration-enamel junctions. A range of restorative material elastic moduli (5–80 GPa) and Poisson's ratios (0.25–0.35) were studied. Vertical loads of 400 N were applied on occlusal points, while the roots of the molar teeth, below the crevices, were supported in all directions. All the materials were modelled as homogeneous, isotropic, and elastic. Results The maximum principal stresses at the restoration-enamel junctions were strongly dependent on the MOD restoration geometries. Peak stresses occurred along the palatal surface of the restoration rather than the opposite buccal surface. Double-curved restorations showed the lowest peak stress at restoration-enamel junctions. Choice of the mechanical properties of restorative material in the range of 5–35 GPa further reduced stress concentrations on the enamel. Significance Class II MOD restorations may be stronger if designed with double-curved marginal geometries that can reduce stress concentrations. Designs with convex and concave geometries were particularly effective because they reduced stress concentrations dramatically. Results suggest that relatively minor changes to the geometry of a restoration can have a substantial effect on stress at the restoration-enamel junction and motivate future experimental analysis.