Search

We present the use of the redox active MIL‐100(Fe) metal‐organic framework (MOF) as a catalyst for the oxidation of 5‐hydroxymethyl furfural (HMF) into 2,5‐furan dicarboxylic acid (FDCA) in water. The MOF is synthesised in water alone under mild hydrothermal conditions and 1H NMR is used to analyse the products of HMF oxidation. The MOF in combination with the co‐catalyst TEMPO provides a total selectivity of desired products of 74 % with a maximum FDCA yield of 57 % seen after 24 hours at only 70 °C. The catalyst is recycled ten times with no loss in activity and no evidence of a reduction in the crystallinity of the MOF. [ABSTRACT FROM AUTHOR]

Metal organic framework UiO‐66 is studied as an adaptable heterogeneous catalyst for glucose conversion. UiO‐66 was modified by; i) partial linker substitution, ii) particle size modulation and iii) linker defects. We studied the effect of crystallinity and functional groups on the glucose conversion and product yields. The main products are: i) fructose from the isomerisation of glucose, ii) mannose from the epimerisation of glucose and iii) 5‐hydroxymethyl furfural from the dehydration of fructose. We found that defective and nano crystalline UiO‐66 catalyst performs best for isomerisation. When 50 % of the linkers of UiO‐66 are replaced by a sulfonate‐containing linker, the catalyst shows higher isomerisation activity than other UiO‐66 catalysts. Naphthalene‐dicarboxylate linkers were introduced to induce hydrophobicity and this catalyst further increased isomerisation activity showing 31 % fructose selectivity. Finally, the promising catalysts were tested in a flow reactor and a bifunctional mixed linker catalyst possessing both hydrophobic and acidic functional groups is shown to be stable in a time‐on‐stream study. [ABSTRACT FROM AUTHOR]

Abstract: Heterogeneous catalysts are desired for the conversion of glucose, the most abundant sugar in renewable biomass, but presently their synthesis requires highly toxic chemicals with long synthesis times. We report the conversion of glucose into fructose and 5‐hydroxymethylfurfural on a heterogeneous catalyst that is stable and selective and operates in the most environmentally benign solvent, water. We used a bifunctional solid with Lewis and Brønsted acid sites by partially replacing the organic linker of the zirconium organic framework UiO‐66 with 2‐monosulfo‐benzene‐1,4‐dicarboxylate. This catalyst showed high product selectivity (90 %) to 5‐hydroxymethylfurfural and fructose at 140 °C in water after a reaction time of 3 h. It was recyclable and showed only a minor loss in activity after the third recycle, offering a realistic solution for the bottleneck glucose isomerization reaction for scale‐up and industrial application of biomass utilization. [ABSTRACT FROM AUTHOR]

An attempt is made to immobilize the homogeneous metal chloride/EMIMCl catalyst for glucose dehydration to 5-hydroxymethylfurfural. To this end, ionic liquid fragments were grafted to the surface of SBA-15 to generate a heterogenized mimick of the homogeneous reaction medium. Despite a decrease in the surface area, the ordered mesoporous structure of SBA-15 was largely retained. Metal chlorides dispersed in such ionic liquid film are able to convert glucose to HMF with much higher yields as is possible in the aqueous phase. The reactivity order CrCl2 > AlCl3 > CuCl2 > FeCl3 is similar to the order in the ionic liquid solvent, yet the selectivity are lower. The HMF yield of the most promising CrCl2-Im-SBA-15 can be improved by using a H2O:DMSO mixture as the reaction medium and a 2-butanol/MIBK extraction layer. Different attempts to decrease metal chloride leaching by using different solvents are described. © 2013 American Institute of Chemical Engineers Environ Prog, 33: 657-662, 2014 [ABSTRACT FROM AUTHOR]

Lignocellulosic biomass, a cheap and plentiful resource, could play a key role in the production of sustainable chemicals. The simple sugars contained in the renewable lignocellulosic biomass can be converted into commercially valuable products such as 5-hydroxymethyl furfural (HMF). A platform molecule, HMF can be transformed into numerous chemical products with potential applications in a wide variety of industries. Of the hexoses contained in the lignocellulosic biomass, the successful production of HMF from glucose has been a challenge. Various heterogeneous catalysts have been proposed over the last decade, ranging from zeolites to metal organic frameworks. The reaction conditions vary in the reports in the literature, which makes it difficult to compare catalysts reported in different studies. In addition, the slight variations in the synthesis of the same material in different laboratories may affect the activity results, because the selectivity towards desired products in this transformation strongly depends on the nature of the active sites. This poses another difficulty for the comparison of different reports. Furthermore, over the last decade the new catalytic systems proposed have increased profoundly. In this article, we summarize the heterogeneous catalysts: Metal Organic Frameworks (MOFs), zeolites and conventional supported catalysts, that have been reported in the recent literature and provide an overview of the observed catalytic activity, in order to provide a comparison. [ABSTRACT FROM AUTHOR]

Herein, Zeolitic imidazolate framework-8 (ZIF-8) is considered as an easy and cheap to prepare alternative catalyst for the isomerization of glucose and production of 5-hydroxymethyl furfural (HMF). For the synthesis of the ZIF-8 catalysts two preparation methods were evaluated, being room temperature and hydrothermal synthesis at 140 °C. Of these, the hydrothermal synthesis method yields a material with exceptionally high surface area (1967 m2·g−1). As a catalyst, the ZIF-8 materials generated excellent fructose yields. Specifically, ZIF-8 prepared by hydrothermal synthesis yielded a fructose selectivity of 65% with a glucose conversion of 24% at 100 °C in aqueous reaction medium. However, this selectivity dropped dramatically when the reactions were repeated at higher temperatures (~140 °C). Interestingly, greater quantities of mannose were produced at higher temperatures too. The lack of strong Brønsted acidity in both ZIF-8 materials resulted in poor HMF yields. In order to improve HMF yields, reactions were performed at a lower pH of 1.0. At 140 °C the lower pH was found to drive the reaction towards HMF and double its yield. Despite the excellent performance of ZIF-8 catalysts in batch reactions, their activity did not translate well to the flow reactor over a continuous run of 8 h, which was operating with a residence time of 6 min. The activity of ZIF-8 halved in the flow reactor at 100 °C in ~3 h, which implies that the catalyst's stability was not maintained in the long run. [ABSTRACT FROM AUTHOR]

The metal–organic framework MIL-101(Cr) is known as a solid–acid catalyst for the solution conversion of biomass-derived glucose to 5-hydroxymethyl furfural (5-HMF). We study the substitution of Cr3+ by Fe3+ and Sc3+ in the MIL-101 structure in order to prepare more environmentally benign catalysts. MIL-101(Fe) can be prepared, and the inclusion of Sc is possible at low levels (10% of Fe replaced). On extended synthesis times the polymorphic MIL-88B structure instead forms.Increasing the amount of Sc also only yields MIL-88B, even at short crystallisation times. The MIL-88B structure is unstable under hydrothermal conditions, but in dimethylsulfoxide solvent, it provides 5-HMF from glucose as the major product. The optimum material is a bimetallic (Fe,Sc) form of MIL-88B, which provides ~70% conversion of glucose with 35% selectivity towards 5-HMF after 3 hours at 140 °C: this offers high conversion compared to other heterogeneous catalysts reported in the same solvent. [ABSTRACT FROM AUTHOR]

Utilisation of lignocellulosic agricultural waste biomass could provide a carbon net zero alternative for production of valuable chemicals. However, the progress is hindered because there's no catalyst to carry out a selective and efficient conversion process. In this study a new promising catalyst for this challenging conversion is reported. It is prepared by sulfonation of activated carbon followed by the impregnation of tin (Sn). The catalyst has been characterized by NH 3 -TPD, FTIR, XRF and N 2 physisorption. The catalyst was tested at 120 °C for the conversion of model carbohydrate mixtures prepared in the laboratory and real biomass mixtures of apple fruit biomass waste. The catalytic performance for the conversion of a model carbohydrate mixture resulted in a 5-hydroxymethylfurfural (5-HMF) yield of 30% in 80 min. On the other hand, catalytic testing of real apple pomace biomass showed a 5-HMF yield of 24% in 80 min. The Sn catalyst was also shown to maintain the 5-HMF yield in recycle experiments using a model carbohydrate mixture. Conversely, stability was lower when the Sn catalyst was tested in real apple pomace mixture, which is likely due to the presence of other impurities. • Low temperature (120 °C) conversion of carbohydrates rich agricultural apple fruit waste to 5-HMF. • Cheap and easy method for the preparation of tin doped sulfonated carbon catalysts. • Characterization revealed that the Sn-Fn-Ac catalyst contained both Lewis and Brønsted acidity. • Sn-Fn-AC showed for glucose, fructose and sucrose mixtures 30% 5-HMF yield at conversion of 60%. • Catalytic conversion of carbohydrate mixtures from biomass yielded 24% of 5-HMF respectively. [ABSTRACT FROM AUTHOR]

• Gallium and Tin can be doped in zeolite Y framework successfully. • Ga has similar activity to Sn in the reaction of glucose conversion to HMF. • Ga zeolite Y catalyst can be recycled and regenerated in DMSO. • Ga-Y zeolite gives fructose yield of 5% at 17 % glucose conversion and Sn-Y zeolite gives 17 % yield at 36 % conversion. This study demonstrates the use of gallium and tin modified Y zeolites as catalysts for the conversion of glucose into fructose, mannose and 5-Hydroxymethyl furfural. These catalysts can be synthesised via a simple and scalable procedure that uses commercially available Y zeolite. The catalysts were characterised by various techniques including elemental analysis, electron microscopy, nitrogen physisorption, X-ray diffraction, X-ray photoelectron spectroscopy, ultraviolet-visible spectroscopy, solid state nuclear magnetic resonance spectroscopy and X-ray absorption near edge spectroscopy. It is found that tin containing Y zeolite generate a glucose conversion of 36 % and total product yield of 17 % in water. Meanwhile, gallium containing Y zeolite shows an HMF yield of 33 % when reactions were conducted in DMSO. The recyclability of tin and gallium containing Y zeolites were studied in DMSO and the activities of both materials were shown to remain stable. Furthermore, the spent catalysts can be regenerated via calcination in air. [ABSTRACT FROM AUTHOR]