Search

The emission of black carbon (BC) particles, which cause atmospheric warming by affecting radiation budget in the atmosphere, is the result of an incomplete combustion process of organic materials. The recent wildfire event during the summer 2019–2020 in south-eastern Australia was unprecedented in scale. The wildfires lasted for nearly 3 months over large areas of the two most populated states of New South Wales and Victoria. This study on the emission and dispersion of BC emitted from the biomass burnings of the wildfires using the Weather Research Forecast–Chemistry (WRF–Chem) model aims to determine the extent of BC spatial dispersion and ground concentration distribution and the effect of BC on air quality and radiative transfer at the top of the atmosphere, the atmosphere and on the ground. The predicted aerosol concentration and AOD are compared with the observed data using the New South Wales Department of Planning and Environment (DPE) aethalometer and air quality network and remote sensing data. The BC concentration as predicted from the WRF–Chem model, is in general, less than the observed data as measured using the aethalometer monitoring network, but the spatial pattern corresponds well, and the correlation is relatively high. The total BC emission into the atmosphere during the event and the effect on radiation budget were also estimated. This study shows that the summer 2019–2020 wildfires affect not only the air quality and health impact on the east coast of Australia but also short-term weather in the region via aerosol interactions with radiation and clouds. [ABSTRACT FROM AUTHOR]

A crucial aspect of regional air quality modelling is the accurate characterisation of local meteorology, as this plays a significant role in the transport and chemical transformation of pollution across a region. This study explores the potential of The Weather Research and Forecasting (WRF) model as an alternative meteorological model to support near-time air quality predictions for the NSW Greater Metropolitan Region (NSW GMR). We develop an optimal WRF configuration for the NSW GMR by downscaling the latest Bureau of Meteorology (BOM) Australian Community Climate and Earth-System Simulator (ACCESS) Numerical Weather Prediction (NWP) data using a three nested domain setup with resolutions of 12km, 4km and 1 km by varying physical parameterisations including two cumulus schemes, two planetary boundary layer schemes, two microphysical schemes, two compatible shortwave and longwave radiation schemes and a standard land surface model. Thus, a set of 16 experiments were executed and evaluated on different days involving high ozone days, bushfire smoke, dust storms and heatwaves. Each simulation was initialised at 12UTC with a forecast horizon of four days, including three hourly updates of boundary conditions. All simulations were evaluated with metrics including Mean Absolute Errors (MAE) and Index of Agreement (IOA) calculated over selected stations operated by NSW Department of Planning, Industry and Environment (NSW DPIE) and BOM for surface and vertical variables (temperature (T), relative humidity (RH), wind speed (WS)) including precipitation (PRECIP) and planetary boundary layer heights (PBLH). Overall, results showed that the best configuration produced acceptable agreements at the surface for T (IOA > 0.8), RH (IOA > 0.7) and WSP (IOA > 0.6). Errors in PBLH were elevated in the mid-boundary layer but was within 100m where vertical profiles of temperature and winds were well simulated. Similarly, experiments with double moment microphysical schemes were better in simulating precipitation. Other performance metrics for the experiments conducted under different case days will also be discussed. [ABSTRACT FROM AUTHOR]

At the end of the dry season, March and April in Southeast Asia (SEA), agricultural refuse burnings occur over the region, mainly in the countries of Myanmar, Thailand, Laos, Cambodia and Vietnam, in preparation for the wet rice plantation. In this study, the impact of biomass burnings at the height of the burning period in March 2019 in mainland SEA on air quality and pollutant transport is modelled using the Weather Research Forecast WRF-Chem air quality model with emission input from the National Center for Atmospheric Research (NCAR) Fire Emission Inventory from NCAR (FINN). FINN is derived from satellite remote sensing data and species emission factors. A simulation of the dispersion of pollutants from biomass burnings from 13 to 19 March 2019, when the burnings was most intense, was performed. Validation of the model prediction using observed meteorological and pollutant data such as AOD measurements on ground from AERONET (Aerosol Robotic Network) and data from MODIS and CALIPSO satellites is carried out at various sites in the region. The results show that impact on air quality was most pronounced in Thailand and Laos but the effect of biomass burnings in mainland SEA at the end of the dry season is widespread in terms of pollutant dispersion and population exposure over the whole region and beyond. It is also shown that the transport of pollutants from biomass burnings in SEA to southern China, Taiwan and beyond is facilitated by the Truong Son mountain range, when under westerly wind, acting as a launching pad to uplift the pollutant plumes to higher altitude which then can be dispersed widely and transported farther from the biomass burning sources in Thailand and Laos. [ABSTRACT FROM AUTHOR]

Dust storms originating from Central Australia and western New South Wales frequently cause high particle concentrations at many sites across New South Wales, both inland and along the coast. This study focussed on a dust storm event in February 2019 which affected air quality across the state as detected at many ambient monitoring stations in the Department of Planning, Industry and Environment (DPIE) air quality monitoring network. The WRF-Chem (Weather Research and Forecast Model—Chemistry) model is used to study the formation, dispersion and transport of dust across the state of New South Wales (NSW, Australia). Wildfires also happened in northern NSW at the same time of the dust storm in February 2019, and their emissions are taken into account in the WRF-Chem model by using Fire Inventory from NCAR (FINN) as emission input. The model performance is evaluated and is shown to predict fairly accurate the PM2.5 and PM10 concentration as compared to observation. The predicted PM2.5 concentration over New South Wales during 5 days from 11 to 15 February 2019 is then used to estimate the impact of the February 2019 dust storm event on three health endpoints, namely mortality, respiratory and cardiac disease hospitalisation rates. The results show that even though as the daily average of PM2.5 over some parts of the state, especially in western and north western NSW near the centre of the dust storm and wild fires, are very high (over 900 µg/m3), the population exposure is low due to the sparse population. Generally, the health impact is similar in order of magnitude to that caused by biomass burning events from wildfires or from hazardous reduction burnings (HRBs) near populous centres such as in Sydney in May 2016. One notable difference is the higher respiratory disease hospitalisation for this dust event (161) compared to the fire event (24). [ABSTRACT FROM AUTHOR]