Search

This paper demonstrates reliability-based design for tensile rupture and pullout limit states for mechanically stabilized earth (MSE) walls constructed with geosynthetic (geogrid) reinforcement. The general approach considers the accuracy of the load and resistance models that appear in each limit state equation plus uncertainty due to the confidence (level of understanding) of the designer at the time of design. The reliability index is computed using a closed-form solution that is easily implemented in a spreadsheet. The general approach provides a quantitative link between nominal factor of safety, which is familiar in allowable stress design practice, and reliability index used in modern civil engineering reliability-based design practice. A well-documented MSE wall case study is used to demonstrate the general approach and to compare margins of safety using different load and resistance model combinations. A practical outcome from the case study example is the observation that the pullout limit state is much less likely to control design than the ultimate tensile rupture state for walls with continuous reinforcement coverage. The more accurate "simplified stiffness method" that is used to compute tensile loads in the reinforcement under operational conditions is shown to generate a more cost-effective reinforcement option than the less accurate American Association of State Highway and Transportation Officials (AASHTO) simplified method. [ABSTRACT FROM AUTHOR]

The paper reports the details of numerical models used to predict the performance of two 3.6 m-high well-instrumented wrapped-face walls. The walls were nominally identical except that the reinforcement material in one wall was a steel welded wire mesh and in the other a biaxial polypropylene geogrid. The backfill soil was modelled using both linear and nonlinear elastic-plastic constitutive models. A general hyperbolic (nonlinear) axial load-strain-time model was used for the reinforcement. The numerical results show good agreement with measured performance features for the welded wire mesh wrapped-face wall. Agreement between numerical predictions of facing displacements and maximum reinforcement loads was less accurate for the very flexible geogrid wrapped-face wall. The discrepancies are believed to be related to the unusually flexible wrapped face used in the geogrid wall construction. Numerically predicted and measured maximum reinforcement loads are compared to loads using the AASHTO reinforcement strength-based design approach (Simplified Method) and the Simplified Stiffness Method which is an empirical reinforcement stiffness-based method. The paper provides physical test data that can be used to benchmark other numerical models, highlights lessons learned during the development of the models, and identifies reasonable expectations for numerical model accuracy for models of similar complexity used to simulate the performance of mechanically stabilized earth (MSE) wall structures under operational conditions. [ABSTRACT FROM AUTHOR]