Search

Lutetium oxyorthosilicate Lu2SiO5 (LSO) and pyrosilicate Lu2Si2O7 (LPS) activated by Ce3+ or Pr3+ are known to be effective and fast scintillation materials for the detection of X-rays and γ-rays. Their performances can be further improved by co-doping with aliovalent ions. Herein, we investigate the Ce3+(Pr3+) → Ce4+(Pr4+) conversion and the formation of lattice defects stimulated by co-doping with Ca2+ and Al3+ in LSO and LPS powders prepared by the solid-state reaction process. The materials were studied by electron paramagnetic resonance (EPR), radioluminescence spectroscopy, and thermally stimulated luminescence (TSL), and scintillation decays were measured. EPR measurements of both LSO:Ce and LPS:Ce showed effective Ce3+ → Ce4+ conversions stimulated by Ca2+ co-doping, while the effect of Al3+ co-doping was less effective. In Pr-doped LSO and LPS, a similar Pr3+ → Pr4+ conversion was not detected by EPR, suggesting that the charge compensation of Al3+ and Ca2+ ions is realized via other impurities and/or lattice defects. X-ray irradiation of LPS creates hole centers attributed to a hole trapped in an oxygen ion in the neighborhood of Al3+ and Ca2+. These hole centers contribute to an intense TSL glow peak at 450–470 K. In contrast to LPS, only weak TSL peaks are detected in LSO and no hole centers are visible via EPR. The scintillation decay curves of both LSO and LPS show a bi-exponential decay with fast and slow component decay times of 10–13 ns and 30–36 ns, respectively. The decay time of the fast component shows a small (6–8%) decrease due to co-doping. [ABSTRACT FROM AUTHOR]

Conjugated BaI2:Eu (5 at.%) nanocrystalline particles were synthesized, decorated with golden nanoparticles (GNP). GNP demonstrated some hydrophilic effect, leading to the BaI2·H2O phase creation. The Eu2+ luminescence intensity was reduced according to the GNP content. This was due to the decreased number of Eu2+ ions in the BaI2, most probably, arising from the Au substitution for Ba competing with Eu. Moreover, the decay time of luminescence was decreased upon GNP content. This was explained by the moderation of negative charge in the GNP, leading to the repulsion with an electron in the excited Eu2+. [ABSTRACT FROM AUTHOR]

The influence of Mo on the electronic states and crystalline structure, as well as morphology, phase composition, luminescence, and defects in ZnO rods grown as free-standing nanoparticles, was studied using a variety of experimental techniques. Mo has almost no influence on the luminescence of the grown ZnO particles, whereas shallow donors are strongly affected in ZnO rods. Annealing in air causes exciton and defect-related bands to drop upon Mo doping level. The increase of the Mo doping level from 20 to 30% leads to the creation of dominating molybdates. This leads to a concomitant drop in the number of formed ZnO nanorods. [ABSTRACT FROM AUTHOR]

Erbium-doped Y3Al5O12 (YAG) single crystals grown using the micro-pulling-down technique were investigated. Three Er concentrations were chosen: 0.1, 0.3 and 1 at%. Er3+ electron paramagnetic resonance (EPR) spectra were measured in the ground and first excited states. The corresponding g tensors and 167Er hyperfine interaction were changing upon Er content indicating moderation of the Er-O bond length and/or Er local surrounding. Photoluminescence (PL) and radioluminescence (RL) spectra were complex, consisting of strongly overlapped typical Er3+ transitions. In addition, there were other broad PL band (3.1 eV) and RL band (3.95 eV) attributed to the F+ center and yttrium substituting for aluminum (YAl), respectively. The X-ray excited decay kinetics exhibited a decrease of the decay time of the YAl from hundreds of nanoseconds to nanoseconds upon Er doping level. This is discussed and explained considering EPR data. [ABSTRACT FROM AUTHOR]

Nanorods of erbium-doped zinc oxide (ZnO:Er) were fabricated using a hydrothermal method. One batch was prepared with and another one without constant ultraviolet (UV) irradiation applied during the growth. The nanorods were free-standing (FS) as well as deposited onto a fused silica glass substrate (GS). The goal was to study the atomistic aspects influencing the charge transport of ZnO nanoparticles, especially considering the differences between the FS and GS samples. We focused on the excitons; the intrinsic defects, such as zinc interstitials, zinc vacancies, and related shallow donors; and the conduction electrons. UV irradiation was applied for the first time during the ZnO:Er nanorod growth. This led to almost total exciton and zinc vacancy luminescence reduction, and the number of shallow donors was strongly suppressed in the GS samples. The effect was much less pronounced in the FS rods. Moreover, the exciton emission remained unchanged there. At the same time, the Er3+ content was decreased in the FS particles grown under constant UV irradiation while Er3+ was not detected in the GS particles at all. These phenomena are explained. [ABSTRACT FROM AUTHOR]

CsPbBr3 nanocrystals have been identified as a highly promising material for various optoelectronic applications. However, they tend to coexist with Cs4PbBr6 phase when the reaction conditions are not controlled carefully. It is therefore imperative to understand how the presence of this phase affects the luminescence performance of CsPbBr3 nanocrystals. We synthesized a mixed CsPbBr3-Cs4PbBr6 sample, and compared its photo- and radioluminescence properties, including timing characteristics, to the performance of pure CsPbBr3 nanocrystals. The possibility of energy transfer between the two phases was also explored. We demonstrated that the presence of Cs4PbBr6 causes significant drop in radioluminescence intensity of CsPbBr3 nanocrystals, which can limit possible future applications of Cs4PbBr6-CsPbBr3 mixtures or composites as scintillation detectors. [ABSTRACT FROM AUTHOR]