Search

For battery electrodes, measured capacity decays as charge/discharge current is increased. Such rate-performance is important from a practical perspective and is usually characterised via galvanostatic charge-discharge measurements. However, such measurements are very slow, limiting the number of rate experiments which are practical in a given project. This is a particular problem during mechanistic studies where many rate measurements are needed. Here, building on work by Heubner at al., we demonstrate chronoamperometry (CA) as a relatively fast method for measuring capacity-rate curves with hundreds of data points down to C-rates below 0.01C. While Heubner et al. reported equations to convert current transients to capacity vs. C-rate curves, we modify these equations to give capacity as a function of charge/discharge rate, R. We show that such expressions can be combined with a basic model to obtain simple equations which can fit data for both capacity vs. C-rate and capacity vs. R. We demonstrate that these equations can accurately fit experimental data within normal experimental ranges of rate. However, we also observe that, at high rates, the curves obtained from CA deviate from the normal behaviour showing a new, previously unobserved, decay feature. We associate this feature with the very early part of the current transient where electronic motion dominates the current. Using a simple model, we show that the dependence of the high-rate time constant on electrode thickness can be linked to electrode conductivity.

A significant problem associated with batteries is the rapid reduction of charge-storage capacity with increasing charge/discharge rate. For example, improving this rate-performance is required for fast-charging of car batteries. Rate-performance is related to the timescales associated with charge or ionic motion in both electrode and electrolyte. However, no quantitative model exists which can be used to fit experimental data to give insights into the dominant rate-limiting processes in a given electrode-electrolyte system. Here we develop an equation which can be used to fit capacity versus rate data, outputting three parameters which fully describe rate-performance. Most important is the characteristic time associated with charge/discharge which can be expressed by a simple equation with terms describing each rate-limiting process, thus linking rate-performance to measurable physical parameters. We have fitted these equations to ~200 data sets from ~50 papers, finding exceptional agreement, and allowing parameters such as diffusion coefficients or electrolyte conductivities to be extracted. By estimating relevant physical parameters, it is possible to show which rate-limiting processes are dominant in a given situation, facilitating rational design and cell optimization. In addition, this model predicts the upper speed limit for Li/Na ion batteries, in agreement with the fastest electrodes in the literature.

Nematic liquid crystal (LC) molecules adsorbed on two dimensional materials are aligned along the crystal directions of the hexagonal lattice. It was demonstrated that short electric pulses can reorient the aligned LC molecules in the preferred armchair direction of hexagonal boron nitride (h-BN). Several states with a variety of colors were obtained by changing the direction and strength of the electric pulses. The ab initio calculations based on density functional theory was carried out to determine the favorable adsorption configurations of the LC molecules on the h-BN surface. A non-volatile display, in which pixel resolution can be determined by grains of hexagonal surface, is proposed, which can offer a pathway towards dynamic high-quality pixels with low power consumption, and could define a new paradigm for all non-volatile display applications.