Search

Cracking of suspensions during drying is a common problem. While additives, e.g. binders and surfactants, can mitigate this problem, some applications, such as printing conductive pastes or sintering green bodies, do not lend themselves to the use of additives. Capillary suspensions provide an alternative formulation without additives. In this work, we use simultaneous stress and weight measurements to investigate the influence of formulation and drying conditions. Capillary suspensions dry more homogeneously and with lower peak stresses, leading to an increased robustness against cracking compared. An increase in dry film porosity is not the key driver for the stress reduction. Instead, the capillary bridges, which create strong particle networks, resist the stress. Increasing the relative humidity enhances this effect, even for pure suspensions. While lower boiling point secondary liquids, e.g. water, persist for very long times during drying, higher boiling point liquids offer further potential to tune the the drying process.

Hypothesis: Lateral accumulation and film defects during drying of hard particle coatings is a common problem, typically solved using polymeric additives and surface active ingredients, which require further processing of the dried film. Capillary suspensions with their tunable physical properties, devoid of polymers, offer new pathways in producing uniform and defect free particulate coatings. Experiments: We investigated the effect of small amounts of secondary liquid on the coating's drying behavior. Stress build-up and weight loss in a temperature and humidity controlled drying chamber were simultaneously measured. Changes in the coating's reflectance and height profile over time were related with the weight loss and stress curve. Findings: Capillary suspensions dry uniformly without defects. Lateral drying is inhibited by the high yield stress, causing the coating to shrink to an even height. The bridges between particles prevent air invasion and extend the constant drying period. The liquid in the lower layers is transported to the interface via corner flow within surface pores, leading to a partially dry layer near the substrate while the pores above are still saturated. Using capillary suspensions for hard particle coatings results in more uniform, defect free films with better printing characteristics, rendering high additive content obsolete.