Search

Rapid heat treatment is an important method to improve the properties of steel. Moreover, the study of the phase transformation process plays an important role in the formulation of rapid heat treatment. This paper investigates phase transformation behavior and microstructure evolution of ultrafine bainite at varying heating rates, and reveals the influence mechanism of retained austenite on austenitizing. Results showed that the decomposition of retained austenite was influenced by the diffusion of Si element. Therefore, the decomposition temperature of retained austenite is severely affected by the heating rate. Retained austenite completely transformed into cementite and ferrite when heating rate was below 5 °C/s. A small amount of retained austenite was kept when the heating rate was higher than 5 °C/s. The kept austenite effectively suppressed the hysteresis of Ac1and resulted in a unique mechanism of austenite grain formation. When the heating rate range was 5–10 °C/s, some new austenite skipped the nucleation process and grew directly on the kept austenite, forming the large austenite grains. And other new austenite was obtained via nucleation and growth process. Thus, the grain size of bimodal distribution is formed. This leads to the phenomenon of austenite memory effect. When the heating rate was increased to 50 °C/s and higher, the austenite grain size was less than 14 μm. Therefore, rapid heating makes the phase transition lag. When the heating rate is high enough, part of the austenite is kept, which has an important influence on austenitizing process of the steel.

Phase transformation during austenitizing process and heat treatment process under slow cooling of high-carbon bainitic bearing steel is still unclear. Direct nano-scale microscopic observation and in-situ X-ray diffraction investigations have been used to conduct in-situ investigates of phase transformation of the tested steel, including austenitizing and two-step isothermal process under slow cooling. Results show that the austenitizing process of the sample mainly includes the formation of austenite and dissolution of cementite. Rapid phase transformation stage during the austenitizing process occurs, and it is caused by the diffusion rate of alloying and carbon atoms at different temperatures. The martensitic and bainitic transformation can occur during the low-temperature two-step isothermal transformation. Moreover, the initial bainitic transformation rate greatly accelerates due to the introduction of preformed phase. The evolution of supercooled austenite have been explored to further understand the phase transformation behavior. The analysis of diffraction peak of undercooled austenite shows that the asymmetry of austenite peak occurs before the two-step isothermal process. The asymmetry is attributed to the development of carbon-rich and carbon-poor zones in austenite. The proportion of filmy austenite in austenite increases as the bainitic isothermal time prolonged. Moreover, the increase rate of carbon concentration in filmy untransformed austenite is large.