Search

The Modified Source Multiplication method is used to determine an unknown reactivity level of a reactor from a known one if one has access to the detector counting for both levels when the reactor is fed by a constant neutron source like an Am-Be source. When available, an accelerator driven source, in continuous mode, can be useful as its intensity can be tunable and then adapted to the experimental conditions. However, in that case, the MSM technique must be extended to account for an external source whose intensity, energy and angular distributions can vary from one measurement to another. In this paper, this Modified Multi-Source Multiplication (MMSM) method is applied to measurements done during the FREYA project in the GUINEVERE facility, operated with the GENEPI-3C accelerator providing a mixture of (D,T) and (D,D) neutrons. The monitoring of these sources through the detection of the associated charged particles allows the calculation of the MMSM factors and the estimate of the reactivity values. The results are compared in different configurations with the reactivity obtained with an Am-Be source or in dynamic measurements performed with GENEPI-3C. Their excellent agreement shows the possibility of using such accelerator-based neutron sources for MSM measurements when they are correctly monitored. This is of great interest for deep sub-critical level characterization for which detector count rates per source neutrons might be low. [ABSTRACT FROM AUTHOR]

Three sub-critical (SC) core configurations were investigated in the VENUS-F zero power reactor coupled with the GENEPI-3C accelerator. The SC10 and SC12 were a mock-up of a MYRRHA start-up core and SC11 represented a more complex MYRRHA core loaded with various types of in-pile-sections. The sub-criticality of 11 variants of these VENUS-F cores was changed in several steps from -6$ down to -30$ using the safety and control rods. Their sub-criticalities were determined with the Source Jerk Integral (SJI) method using 11 fission chambers located all over the reactor. For the data analysis, the 8-group delayed neutron parameters from the JEFF-3.1.2 evaluated nuclear data library were used. Reliability and reproducibility of the experimental results were tested by repeating the measurements, swapping the detectors and varying the accelerator beam intensity, thus changing the detector count rates and verifying the validity of the dead time corrections. The obtained results are compared with MCNP calculations. [ABSTRACT FROM AUTHOR]

The study of fission yields has a major impact on the characterization and understanding of the fission process and is mandatory for reactor applications. While the yields are known for the major actinides (235U, 239Pu) in the thermal neutron-induced fission, only few measurements have been performed on 242Am. This paper presents the results of a measurement at the Lohengrin mass spectrometer (ILL, France) on the reaction 241 Am(2nth,f): a total of 41 mass yields in the light and the heavy peaks have been measured and compared with the fission process simulation code GEF. Modus operandi and first results of a second experiment performed in May 2013 on the same reaction but with the goal of extracting the isotopic yields are presented as well: 8 mass yields were re-measured and 18 isotopic yields have been investigated and are being analyzed. Results concerning the kinetic energy and its comparison with the GEF Code are also presented in this paper. [ABSTRACT FROM AUTHOR]

Fission cross section of short-lived minor actinides is of prime importance for the incineration of minor actinides in high and thermal neutron fluxes. But due to the shortness of their half-lives, measurements are difficult to handle on these isotopes and the existing data present some large discrepancies. An original method has been developed, in the framework of the Mini-INCA project at ILL, to measure the fission and capture cross sections of minor actinides with low error bars associated even for short-lived isotopes. This method lies on a quasi on-line alpha- and gamma-spectroscopy of irradiated samples and on the use of fission micro-chambers. Coupled to a very powerful Monte-Carlo simulation, both microscopic information on nuclear reactions (total and partial cross sections for neutron capture and/or fission reactions) and macroscopic information on transmutation and incineration potentials could be gathered. In this paper, the method is explained in its originality and some recent results are given and compared with existing measurements and evaluated data libraries. © 2005 American Institute of Physics [ABSTRACT FROM AUTHOR]

In the framework of nuclear waste transmutation studies, the Mini-INCA project has been initiated at CEA/DSM with objectives to determine optimal conditions for transmutation and incineration of Minor Actinides (MA) in high intensity neutron fluxes. Our experimental tools based on alpha- and gamma-spectroscopy of irradiated samples and the development of fission micro-chambers could gather both microscopic information on nuclear reactions (total and partial cross sections for neutron capture and/or fission reactions) and macroscopic information on transmutation and incineration potentials. Cross sections of selected actinides (241Am, 242Am, 242Pu, 237Np, 238Np) have already been measured at ILL, showing some discrepancies when compared to evaluated data libraries but in overall good agreement with recent experimental data. © 2005 American Institute of Physics [ABSTRACT FROM AUTHOR]

We propose to measure the neutron flux in the liquid Pb-Bi 1 MW MEGAPIE target at PSI. Micro fission-chambers will be placed inside the central rod of the target to measure both thermal and non-thermal components of the neutron flux. In principle, both time- and space-dependent variations of the flux will be on line monitored with a precision better than 5%. © 2005 American Institute of Physics [ABSTRACT FROM AUTHOR]