Search

A careful study of electrochemical lithiation of a composite graphite electrode at elevated temperatures was performed using a potentiostatic intermittent titration technique. Special emphasis was placed on the stage 4 to stage 3 phase transition, occurring in the range of x (in Li xC 6) between 0.12 and 0.22 (this corresponds to the partial dimensionless intercalation level ? ranging from 0 to 1). An abrupt increase in the Li chemical diffusion coefficient, D chem, when approaching the relative coverage level ?=1/3, and a specific non-Arrhenius shape of the plot of D chem vs. the inverse of the absolute temperature were observed. These two features of the phase transition seem to be in agreement with a recent thermodynamic model for adatoms diffusing on a surface with two considerably different barrier energy sites. [ABSTRACT FROM AUTHOR]

During deposition on a stepped surface the growth mode depends on the conditions such as temperature T, deposition rate F and width of the terraces w. In this work we studied the influence of all the above mentioned characteristics using the kinetic Monte Carlo (kMC) technique. We concentrated on the conditions on the terrace at the moment of the first nucleation. The critical density of monomers for nucleation ηm decreases with the width of the terrace and the nucleation starts at surprisingly low densities of monomers. We tested several definitions of the critical width for nucleation wc used in various articles in the past and we compared our results with results of the analytical steady-state mean-field model (Ranguelov and Altman 2007 Phys. Rev. B 75 245419). To check how the simplified assumption about the steady-state regime during deposition influences the resulting dependence of wc =/~ (D/F)(κ), we set and also solved a time-dependent analytical model. This analytical model as well as kMC predict that wc =/~ (D/F)(1/5). kMC simulation also shows that the Ehrlich-Schwöbel barrier has only limited influence on the nucleation on the stepped surface at conditions close to the nucleation regime. For all widths of terraces there is a critical value of the Ehrlich-Schwöbel barrier ΔE(c)(ES)/k(B)T ~ 7.3 (ΔE(c)(ES) ~0.11 eV at T = 175 K), and only below this critical value does the Ehrlich-Schwöbel barrier affect the final value of the density of nuclei. The results of the kMC are summarized in a semi-empirical analytical formula which describes the dependence of the step-flow growth and nucleation on the terrace width w, diffusion coefficient D and deposition rate F. In our simulations we tested two models of the stepped surface with different thicknesses of the step, both with an Ehrlich-Schwöbel barrier on the edge of the terrace.

We present a theoretical investigation of the influence of domain boundaries on the Ge/Si(111)-5 × 5 phase using both large-scale DFT simulations and an analytical model. It is shown that different boundary types modify the atomic and electronic structure of the adjoining 5 × 5 domains in very different ways. A simple theoretical model, that describes the energy interaction J between the boundaries and the 5 × 5 phase, is presented and the interaction energy decay J(x) ≈ x(-n) for different domain boundaries is estimated. Additionally, the influence of the boundaries on the atomic and electronic structure of adatoms in the parental 5 × 5 phase is analyzed and it is argued that the presence of domain boundaries may strongly affect not only the physical but also the chemical properties of the Ge/Si(111)-5 × 5 phase.

Recent experiments on epitaxial growth of metals on graphene have shown a strong dependence of island densities on coverage. These investigations cannot be explained by the standard mean-field nucleation theories. To understand them, we extend to higher coverage the former theory of rate equations developed for the initial state of nucleation, in a system where adsorbate interaction is included. We account for that, in the case of high coverage, the repulsive interaction influences both the attachment of monomers to clusters and the mobility of atoms. In our work we analyze the modification of the dependence of the island density on coverage, temperature and F/D ratio. In some regimes our theory results in the experimentally observed substantial growth of island density with coverage for a high deposited amount and a weak dependence on deposition rate F. We also find out the local maxima in temperature dependence of island density, as a consequence of long-range repulsive interactions., (© 2012 IOP Publishing Ltd)

We extend a standard theory of second-layer nucleation in the regime of low temperature, where the diffusion is the limiting process. The theory takes into consideration the fluctuations of the adatoms and the distribution of stable clusters on a surface, and yields an expression for the nucleation rate and time evolution of the density of stable clusters. When diffusion is slow, the fluctuations of the monomer distribution play an important role and results differ qualitatively and quantitatively from those obtained using the standard rate-equation approach to nucleation. We argue that in this case the standard theory fails because slow diffusion delays nucleation and the nucleation rate depends on the fluctuations of interatomic distances. It is shown that the final density of stable clusters depends on the fluctuations of the monomer and stable clusters distribution and can be even independent of the deposition rate, as was experimentally observed at low temperatures.

We have extended a recently proposed correlated cluster mean-field (CCMF) theory to two-dimensional binary alloys with interactions up to the next-nearest neighbors and investigated their critical behavior. A very good agreement with results from the renormalization group theory was obtained for the critical temperatures of a simple model. We finally successfully compared our results obtained using the CCMF with the results of Monte Carlo simulations for the case of ordering in a random Fe(0.5)Co(0.5) overlayer on the Cu(001) substrate. The proposed theory represents a numerically efficient alternative to existing approaches like the cluster variation method and Monte Carlo simulations.

The authors consider the influence of steps and nonequilibrium conditions on surface diffusion in a strongly interacting surface adsorbate system. This problem is addressed through Monte Carlo simulations of a lattice-gas model of OW(110), where steps are described by an additional binding energy EB at the lower step edge positions. Both equilibrium fluctuation and Boltzmann-Matano spreading studies indicate that the role of steps for diffusion across the steps is prominent in the ordered phases at intermediate coverages. The strongest effects are found in the p(2x1) phase, whose periodicity Lp is 2. The collective diffusion then depends on two competing factors: domain growth within the ordered phase, which on a flat surface has two degenerate orientations [p(2x1) and p(1x2)], and the step-induced ordering due to the enhanced binding at the lower step edge position. The latter case favors the p(2x1) phase, in which all adsorption sites right below the step edge are occupied. When these two factors compete, two possible scenarios emerge. First, when the terrace width L does not match the periodicity of the ordered adatom layer (LLp is noninteger), the mismatch gives rise to frustration, which eliminates the effect of steps provided that EB is not exceptionally large. Under these circumstances, the collective diffusion coefficient behaves largely as on a flat surface. Second, however, if the terrace width does match the periodicity of the ordered adatom layer (LLp is an integer), collective diffusion is strongly affected by steps. In this case, the influence of steps is manifested as the disappearance of the major peak associated with the ordered p(2x1) and p(1x2) structures on a flat surface. This effect is particularly strong for narrow terraces, yet it persists up to about L approximately 25Lp for small EB and up to about L approximately 500Lp for EB, which is of the same magnitude as the bare potential of the surface. On real surfaces, similar competition is expected, although the effects are likely to be smaller due to fluctuations in terrace widths. Finally, Boltzmann-Matano spreading simulations indicate that even slight deviations from equilibrium conditions may give rise to transient peaks in the collective diffusion coefficient. These transient structures are due to the interplay between steps and nonequilibrium conditions and emerge at coverages, which do not correspond to the ideal ordered phases.

We study the influence of nonequilibrium conditions on the collective diffusion of interacting particles on vicinal surfaces. To this end, we perform Monte Carlo simulations of a lattice-gas model of an ideal stepped surface, where adatoms have nearest-neighbor attractive or repulsive interactions. Applying the Boltzmann-Matano method to spreading density profiles of the adatoms allows the definition of an effective, time-dependent collective diffusion coefficient D(C) (t)(theta) for all coverages theta. In the case of diffusion across the steps and strong binding at lower step edges we observe three stages in the behavior of the corresponding D(xx,C) (t)(theta). At early times when the adatoms have not yet crossed the steps, D(xx,C) (t)(theta) is influenced by the presence of steps only weakly. At intermediate times, where the adatoms have crossed several steps, there are sharp peaks at coverages theta<1L and theta>1-1L, where L is the terrace width. These peaks are due to different rates of relaxation of the density at successive terraces. At late stages of spreading, these peaks vanish and D(xx,C) (t)(theta) crosses over to its equilibrium value, where for strong step edge binding there is a maximum at theta=1L. In the case of diffusion in direction along the steps the nonequilibrium effects in D(yy,C) (t)(theta) are much weaker, and are apparent only when diffusion along ledges is strongly suppressed or enhanced.

We study the submonolayer diffusion of hard disks and rodlike molecules on smooth surfaces through numerical simulations and theoretical arguments. We concentrate on the behavior of the various diffusion coefficients as a function of the two-dimensional (2D) number density rho in the case where there are no explicit surface-particle interactions. For the hard disk case, we find that while the tracer diffusion coefficient D(T)(rho) decreases monotonically up to the freezing transition, the collective diffusion coefficient D(C)(rho) is wholly determined by the inverse compressibility which increases rapidly on approaching freezing. We also study memory effects associated with tracer diffusion, and present theoretical estimates of D(T)(rho) from the mode-mode coupling approximation. In the case of rigid rods with short-range repulsion and no orientational ordering, we find behavior very similar to the case of disks with the same repulsive interaction. Both D(T)(rho) and the angular diffusion coefficient D(R)(rho) decrease with rho. Also in this case D(C)(rho) is determined by inverse compressibility and increases rapidly close to freezing. This is in contrast to the case of flexible chainlike molecules in the lattice-gas limit, where D(C)(rho) first increases and then decreases as a function of the density due to the interplay between compressibility and mobility.