Search

Within this work, we investigate the potential to optimize the screen‐printed front side metallization of silicon heterojunction (SHJ) solar cells. Three iterative experiments are conducted to evaluate the impact of the utilized fine mesh screen configurations and grid layout adaption (finger pitch) for the front side metallization on silver laydown and electrical performance of the solar cells. With respect to the screen configuration, we compare the performance of a fine‐mesh knotless screen to a conventionally angled screen demonstrating an additional gain of Δη = +0.1%abs due to reduced shading losses. Additionally, a grid layout is improved by increasing the number of contact fingers from 120 to 156. Furthermore, the current possibility to push the fine‐line printing process for low‐temperature pastes to the limit is investigated by reducing the nominal finger width wn to 20, 18, and 15 μm. It is shown that even the smallest nominal width of wn = 15 μm can be printed with high quality, leading to an additional efficiency gain of Δη = +0.15%abs as well as a reduction of silver paste laydown by −5 mg. Finally, a batch of champion cells is fabricated by applying the findings of the previous experiments, which results in a maximum efficiency of ηmax = 23.2%. Compared to the reference group without optimization, this corresponds to a gain of Δη = +0.17%abs, which comes along with an additional decrease of the silver paste laydown by approximately −2 mg. This emphasizes the significance of consistent optimization of the screen‐printing process in terms of cell performance and resource utilization for SHJ solar cells. [ABSTRACT FROM AUTHOR]

This paper shows two applications for using vacuum circuit breakers (VCBs) in flexible ac transmission systems in the high-voltage (HV) power grid. This is first a mechanically switched reactor, which is series connected to a thyristor-controlled series compensator in order to enhance the inductive working range. Nevertheless, the switching frequency of VCBs is limited by their mechanical properties. In order to achieve a higher switching frequency, more VCBs are switched in parallel to each other. Second, a device is investigated, which consists of mechanically switched capacitors and a mechanically switched reactor. It is connected to a node in the HV system in order to enhance the voltage quality and to avoid a voltage collapse. Since VCBs are mainly available in the medium-voltage range, a transformer is used to connect the mechanically switched device to the HV system. In this paper, it could be shown that the mechanically switched series reactor is able to enhance the damping progress of power oscillations and that the mechanically switched device using VCBs can stabilize the voltage of the node in case of disturbances, such as faults in the power system. Furthermore, the electrical stress on the VCBs has been assessed for different simulation cases with PSCAD. [ABSTRACT FROM PUBLISHER]