Search

This paper presents the experimental results on the Terapia Oncologica con Protoni-Intensity Modulated Proton Linear Accelerator (TOP-IMPLART) beam that is currently accelerated up to 35 MeV, with a final target of 150 MeV. The TOP-IMPLART project, funded by the Innovation Department of Regione Lazio (Italy), is led by Italian National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA) in collaboration with the Italian Institute of Health and the Oncological Hospital Regina Elena-IFO. The accelerator, under construction and test at ENEA-Frascati laboratories, employs a commercial 425 MHz, 7 MeV injector followed by a sequence of 3 GHz accelerating modules consisting of side coupled drift tube linac (SCDTL) structures up to 71 MeV and coupled cavity linac structures for higher energies. The section from 7 to 35 MeV, consisting on four SCDTL modules, is powered by a single 10 MW klystron and has been successfully commissioned. This result demonstrates the feasibility of a “fully linear” proton therapy accelerator operating at a high frequency and paves the way to a new class of machines in the field of cancer treatment.

A lithium fluoride crystal slab was irradiated in air with a proton beam of nominal 7 MeV energy at a linear accelerator that is under development at ENEA C.R. Frascati. The irradiation generated a spatial distribution of stable colour centres in the crystal that could be detected as a luminescent image under blue-light excitation in a fluorescence microscope. The reconstruction of the whole Bragg curve from the luminescent image is here demonstrated for the first time by taking into account finite proton-energy bandwidth and saturation of defect concentration due to high absorbed dose. The obtained results confirm lithium fluoride detectors based on visible photoluminescence of radiation-induced aggregate colour centres as reliable candidate devices for advanced proton-beam diagnostics. [ABSTRACT FROM AUTHOR]

An innovative diamond detector layout is presented that is designed to operate at high temperature under intense neutron and gamma fluxes. It is made of a 500 μm “electronic grade” diamond film with 100 nm thick Ag metal contacts deposited onto each surface of the film by means of thermal evaporation. A thick layer of 6LiF has been deposited on top of one of the two Ag contacts to make the detector sensitive to thermal neutrons. The device was tested at the ISIS spallation neutron source (Rutherford Appleton Laboratory, UK) using the INES beam line. The detector was continuously irradiated for 100 hours in vacuum , exposed to a neutron flux of about 106 n cm−2 s−1 at a temperature . The aim of this experiment was to study the time dependence of the diamond detector performance while operating at high temperature under irradiation, providing a first experimental proof of reliable continuous operation for 100 hours at high temperature in a harsh environment. [ABSTRACT FROM AUTHOR]