Search

Advanced grid stiffened composite cylindrical shell is widely adopted in advanced structures due to its exceptional mechanical properties. Buckling is a main failure mode of advanced grid stiffened structures in engineering, which calls for increasing attention. In this paper, the buckling response of advanced grid stiffened structure is investigated by three different means including equivalent stiffness model, finite element model and a hybrid model (H-model) that combines equivalent stiffness model with finite element model. Buckling experiment is carried out on an advanced grid stiffened structure to validate the efficiency of different modeling methods. Based on the comparison, the characteristics of different methods are independently evaluated. It is arguable that, by considering the defects of material, finite element model is a suitable numerical tool for the buckling analysis of advanced grid stiffened structures. [ABSTRACT FROM PUBLISHER]

In this study, the buckling and compressive failure of adhesively-bonded stepped-lap joints (with/without composite patches) composed of pultruded glass fiber-reinforced polymer composite laminates was investigated experimentally and numerically. Two-component epoxy adhesive was used for bonding purposes. Composite patches were woven glass-epoxy layer. They were added onto the conventional stepped-lap joints so that additional load transfer paths were created and localized stress concentrations near joint edge were reduced. The axial compression tests were performed and the results revealed that the buckling and failure load of new stepped lap composite joints with composite patches were significantly higher than the conventional stepped lap joints. The influence of the overlap length was evaluated. For both types of joints, a small increase was observed in failure loads by increase of the overlap length. Numerical results showed a very good agreement with experimental results. [ABSTRACT FROM AUTHOR]

The buckling of laminated metal-matrix composite (MMC) plates with a central square cutout were analyzed under compressive biaxial loading using the finite element approach. The MMC plates displayed some interesting buckling patterns and initial buckling shapes when subjected to different combination of hole sizes and boundary conditions. In the case of anti-symmetric, free-free boundary conditions, the MMC plates with central square cutout resist higher buckling loads as the hole size increased. Two laminated stacking sequences [90/0/0/90]2 and [45/-45/-45/45]2 were used in this study. For the same hole size, plate aspect ratio, and boundary conditions, the results showed that the critical buckling behavior of the plates were primarily influenced by the edge boundary conditions rather than by the laminated stacking sequences. The overall critical buckling analysis indicated that plates with clamped boundary conditions will take higher compressive loads than that of simply supported boundary conditions by a ratio of 2 to 1. [ABSTRACT FROM AUTHOR]