Search

Passive microwave remote sensing is a vital tool for acquiring valuable information regarding the Earth's surface, with significant applications in agriculture, water management, forestry, and various environmental disciplines. Precision agricultural (PA) practices necessitate the availability of field-scale, high-resolution remote sensing data products. This study focuses on the design and development of a cost-effective, portable L-band microwave radiometer capable of operating from an unmanned aircraft system platform to measure high-resolution surface brightness temperature ($T_{B}$). This radiometer consists of a dual-polarized (Horizontal polarized, H-pol and Vertical polarized, V-pol) antenna and a software-defined radio-based receiver system with a 30 MHz sampling rate. The post-processing methodology encompasses the conversion of raw in-phase and quadratic (I&Q) surface emissions to radiation $T_{B}$ through internal and external calibrations. Radiometric measurements were conducted over an experimental site covering both bare soil within an agricultural field and a large water body. The results yielded a high-resolution $T_{B}$ map that effectively delineated the boundaries between land and water, and identified land surface features. The radiometric temperature measurements of the sky and blackbody demonstrated a standard deviation of 0.95 K for H-pol and 0.57 K for V-pol in the case of the sky and 0.39 K for both H-pol and V-pol in the case of the blackbody observations. The utilization of I&Q samples acquired via the radiometer digital back-end facilitates the generation of different time–frequency (TF) analyses through short-time Fourier transform and power spectral density (PSD). The transformation of radiometer samples into TF representations aids in the identification and mitigation of radio frequency interference originating from the instrument itself and external sources.

Temporal and spatial variation of sea ice type in the Arctic is an indicator of regional and global change. Arctic sea ice can be classified into two major categories: multiyear ice (MYI) and first-year ice. In this paper, classification method based on machine learning is established and applied to produce daily sea ice classification data set during the winter (November–April) from 2002 to 2017 using active microwave data from QuikSCAT and Advanced Scatterometer as well as passive microwave data from Advanced Microwave Scanning Radiometer for EOS, Special Sensor Microwave Imager/Sounder, and Advanced Microwave Scanning Radiometer 2 radiometer. First, the open water area is flagged out using brightness temperature (Tb) from the passive microwave sensor. Then, K-means algorithm is applied to identify the clusters of the two ice types in the Tb/backscatter parameter space and finally assign pixels to each class. Two optimization methods based on the movement of MYI and marginal ice zone are used to correct the misclassification of MYI. The results have shown a decrease of MYI in winter from 2002 to 2017, especially in 2008 and 2013 with a remarkable recovery in 2014. The classifications are consistent with results by visual interpretation from synthetic aperture radar images in the Canadian Arctic Archipelago with overall classification accuracy over 93%. Comparison with classifications from previous studies and products shows that our method could reflect more differences in MYI declining trend interannually and less anomalous fluctuations in certain years. [ABSTRACT FROM AUTHOR]

In this paper, an operational retrieval algorithm is described to infer sea surface temperature (SST) using measurements from the Advanced Microwave Scanning Radiometer-2 (AMSR-2) aboard the Global Change Observation Mission-Water. The algorithm exploits AMSR-2 observations from 12 channels (6–36 GHz, horizontally and vertically polarized), after being corrected for residual calibration biases, to retrieve SST using a statistical based scheme. The Algorithm performance is assessed and results are compared to models and other independent data products. [ABSTRACT FROM PUBLISHER]

This paper considers some of the issues of radiometer brightness image formation and reconstruction for use in the NASA-sponsored Calibrated Passive Microwave Daily Equal-Area Scalable Earth Grid 2.0 Brightness Temperature Earth System Data Record project, which generates a multisensor multidecadal time series of high-resolution radiometer products designed to support climate studies. Two primary reconstruction algorithms are considered: the Backus–Gilbert approach and the radiometer form of the scatterometer image reconstruction (SIR) algorithm. These are compared with the conventional drop-in-the-bucket (DIB) gridded image formation approach. Tradeoff study results for the various algorithm options are presented to select optimum values for the grid resolution, the number of SIR iterations, and the BG gamma parameter. We find that although both approaches are effective in improving the spatial resolution of the surface brightness temperature estimates compared to DIB, SIR requires significantly less computation. The sensitivity of the reconstruction to the accuracy of the measurement spatial response function (MRF) is explored. The partial reconstruction of the methods can tolerate errors in the description of the sensor measurement response function, which simplifies the processing of historic sensor data for which the MRF is not known as well as modern sensors. Simulation tradeoff results are confirmed using actual data. [ABSTRACT FROM AUTHOR]

We present a new high-fidelity method of calibrating a cross-track scanning microwave radiometer using Global Positioning System (GPS) radio occultation (GPSRO) measurements. The radiometer and GPSRO receiver periodically observe the same volume of atmosphere near the Earth's limb, and these overlapping measurements are used to calibrate the radiometer. Performance analyses show that absolute calibration accuracy better than 0.25 K is achievable for temperature sounding channels in the 50-60-GHz band for a total-power radiometer using a weakly coupled noise diode for frequent calibration and proximal GPSRO measurements for infrequent (approximately daily) calibration. The method requires GPSRO penetration depth only down to the stratosphere, thus permitting the use of a relatively small GPS antenna. Furthermore, only coarse spacecraft angular knowledge (approximately one degree rms) is required for the technique, as more precise angular knowledge can be retrieved directly from the combined radiometer and GPSRO data, assuming that the radiometer angular sampling is uniform. These features make the technique particularly well suited for implementation on a low-cost CubeSat hosting both radiometer and GPSRO receiver systems on the same spacecraft. We describe a validation platform for this calibration method, the Microwave Radiometer Technology Acceleration (MiRaTA) CubeSat, currently in development for the National Aeronautics and Space Administration (NASA) Earth Science Technology Office. MiRaTA will fly a multiband radiometer and the Compact TEC/Atmosphere GPS Sensor in 2015. [ABSTRACT FROM PUBLISHER]

Tipping calibration is an important technique for the absolute calibration of ground-based microwave radiometers. The standard tipping calibration is usually used in clear atmosphere. The spatial variations of liquid water in cloudy atmosphere may lead to great calibration errors in the process of standard tipping calibration. A new method of tipping calibration for ground-based microwave radiometers is proposed, which uses an accurate channel to calibrate another inaccurate channel in cloudy atmosphere. The simulation and measurements show that the method proposed here can eliminate the radiation of cloud liquid water and calibrate the radiometer under cloudy-sky conditions effectively. A relative tipping calibration is also introduced to retrieve the parameters in cloudy atmosphere. It has been proven that the relative tipping calibration can reduce the retrieval error significantly in cloudy atmosphere even though neither of the two channels is accurate. [ABSTRACT FROM PUBLISHER]

After 2.5 years of the Soil Moisture and Ocean Salinity (SMOS) mission, the characterization of residual instrumental systematic errors in the measured brightness temperatures (TB) is still rather poor. This, in turn, negatively impacts the sea surface salinity retrievals and, as such, notably limits the mission's success. The error mitigation methodology currently used operationally, the so-called Ocean Target Transformation (OTT), mixes both instrumental and model-induced errors. In this paper, it is proposed to distinguish errors by their type of impact on the TB images: mean brightness level, incidence angle dependence, and azimuth angle dependence. A new approach to characterize the azimuth-dependent errors is proposed. First, a careful data selection strategy is applied. Then, an empirically fitted model, which only accounts for the TB incidence angle dependence, is subtracted from the mean TB images of the selected data sets to estimate the systematic antenna-frame errors. The robustness of this methodology is assessed through the estimated anomaly pattern stability when computed for different geophysical conditions, periods of time, and latitudinal bands. The residual variability ranges from 0.03 K to 0.14 K, whereas the OTT variability is about 0.5 K. The new method is forward model independent and generic. It can therefore be applied to estimate the antenna-frame systematic errors over land and ice. Moreover, it proves to be very effective in separating different sources of error and can therefore be used to further characterize other error components and improve the various SMOS forward model terms. [ABSTRACT FROM AUTHOR]

The local oscillators (LOs) of the Soil Moisture and Ocean Salinity mission payload are used to shift the operating frequency of the 72 receivers to an optimal intermediate frequency needed for the signal processing. The LO temperature variations produce phase errors in the visibility, which result in a blurring of the reconstructed brightness temperature (Tb) image. At the end of the commissioning phase, it was decided to calibrate the LO every 10 min while waiting for a more in-depth analysis. During short periods of time, the LO calibration has been performed every 2 min to assess the impact of a higher calibration rate on the quality of the data. In this paper, by means of a decimation experiment, the relative errors of 6- and 10-min calibration interval data sets are estimated using the 2 min as a reference. A noticeable systematic across- and along-track pattern of amplitude \pm0.3 K is observed for Tb differences between 10 and 2 min, whereas this is reduced between 6 and 2 min. A simulation experiment confirms that the nature of such systematic pattern is due to the visibility phase errors induced by the LO calibration rate. Such pattern is propagated into the sea surface salinity (SSS) retrievals. Overall, the SSS error increase (relative to the 2 min SSS data) is about 0.39 and 0.14 psu for the 10- and 6-min data sets, respectively. This paper shows that a LO calibration rate of at least 6 min would noticeably improve the SSS retrievals. [ABSTRACT FROM AUTHOR]

A prerequisite for the successful retrieval of geophysical parameters from remote sensing measurements is the development of an accurate forward model. The European Space Agency Soil Moisture and Ocean Salinity (SMOS), carrying onboard an L-band interferometric radiometer (Microwave Interferometric Radiometer using Aperture Synthesis), was launched on November 2009. Due to the lack of L-band passive ocean measurements from space, several prelaunch forward models were developed and initially used in the SMOS ocean salinity operational processor. In this paper, an update of the prelaunch semi-empirical forward model is presented, using for the first time, real SMOS data. In particular, the ocean surface emissivity modulation at L-band due to rough sea surface is reviewed and reanalyzed. A new model definition is provided with the help of a simple neural network. The improvement is quantified in terms of retrieved salinity accuracy compared with the climatology and concerns essentially the range of wind speeds higher than 12 m·s-1. [ABSTRACT FROM AUTHOR]

Since its launch in December 1999, Terra MODIS has been making continuous Earth observations for more than seven years. It has produced a broad range of land, ocean, and atmospheric science data products for improvements in studies of global climate and environmental change. Among its 36 spectral bands, there are 20 reflective solar bands and 16 thermal emissive bands (TEBs). MODIS TEBs cover the mid-wave infrared and long-wave infrared spectral regions with wavelengths from 3.7 to 14.4 μm. They are calibrated on-orbit using an onboard black- body (BB) with its temperature measured by a set of thermistors on a scan-by-scan basis. This paper will provide a brief overview of MODIS TEB calibration and characterization methodologies and illustrate onboard BB functions and TEB performance over more than seven years of on-orbit operation and calibration. Discussions will be focused on TEB detector short-term stability and noise characterization and changes in long-term response (or system gain). Results show that Terra MODIS BB operation has been extremely stable since launch. When operated at its nominal controlled temperature of 290 K, the BB temperature variation is typically less than ±0.30 mK on a scan-by-scan basis, and there has been no time-dependent temperature drift. In addition to excellent short-term stability, most TEB detectors continue to meet or exceed their specified noise characterization requirements, thus enabling calibration accuracy and science data product quality to be maintained. Excluding the noisy detectors identified prelaunch and those that occurred postlaunch, the changes in TEB responses have been less than 0.7% on an annual basis. The optical leak corrections applied to bands 32-36 have been effective and stable over the entire mission. [ABSTRACT FROM AUTHOR]

Ten underflights of the Special Sensor Microwave Imager/Sounder (SSMIS) with Conical Scanning Millimeter-wave Imaging Radiometer (CoSMIR) onboard the NASA ER-2 aircraft were conducted over the coastal region of California between March 2004 and March 2005. The measured brightness temperature (Tb) values from both sensors are collocated and compared at frequencies of 50.3, 52.8, 53.6, 91.655, 150, 183.3 ± 1,183.3 ± 3, and 183.3 ± 6.6 GHz. The more transparent channels at 50.3, 91.655, and 150 GHz are strongly affected by the changes in surface emission and low-level liquid clouds. Thus, the average differences in Tb values (δTb), measured by the two sensors, and their changes from flight to flight are difficult to assess. For the remaining opaque channels, using the CoSMIR measurements as reference, the lowest SSMIS Tb values occur when the SSMIS is completely under the Earth's shadow. As the satellite moves out of the Earth's shadow in the ascending passes, the SSMIS Tb values are found to gradually increase with more exposure to the sun. The magnitudes of these Tb changes are about 4-5 K for the three 183.3-GHz channels and about 2 K for the 52.8- and 53.6-GHz channels. [ABSTRACT FROM AUTHOR]